???Before beginning, please read these instructions completely and carefully.

???Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty. ???The installer should leave these instructions with the consumer for future reference.

GENERAL INFORMATION

1.ALWAYS connect CO2 gas cylinder to reducing valve or regulator

2.NEVER connect gas cylinder directly to keg.

3.ALWAYS secure gas cylinder in upright position.

4.ALWAYS keep gas cylinder away from heat.

5.NEVER drop or throw gas cylinder.

6.ALWAYS ventilate after CO2 leakage.

7.Gas cylinders should be stored in the coolest part of the room, preferably at 70oF., and securely fastened in the upright position before the primary regulator is attached to the cylinder

41006170 Rev. F

Proper Disposal of Your Old Refrigeration Product

Suffocation Hazard

Remove doors from your old refrigerator.

Failure to do so can result in child entrapment, which can cause death or brain damage

IMPORTANT: Child entrapment and suffocation are not problems of the past. Junked or abandoned refrigerators are still dangerous, even if they will sit for ???just a few days.??? If you are getting rid of your refrigeration product, please follow the instructions below to help prevent accidents.

BEFORE YOU THROW AWAY YOUR OLD REFRIGERATION

PRODUCT:

???Take off the doors.

???Leave the shelves in place so that children may not easily climb inside.

BUILT-IN INSTALLATION

Select Location

The proper location will ensure peak performance of your appliance. Choose a location where the unit will be out of direct sunlight and away from heat sources. Units with fan cooled condensers can be built-in.

Unit should be operated in a properly ventilated area with ambient temperatures above 40oF (4.4oC) and below 110oF (43oC). Installation should be such that the cabinet can be moved for servicing if necessary.

Cabinet Clearance

Ventilation is required from the bottom front section of the unit. Keep this area open and clear of any obstructions. The adjacent cabinets and countertop can be built around the unit as long as no top trim or counter top is installed lower than the top of the hinge.

ELECTRICAL CONNECTION

2

CASTERS

Your beverage dispenser is equipped with four casters. the front two casters can be locked.

For built-in applications, the four casters can be removed by removing the nut located inside the dispenser cabinet and then pulling the threaded caster spindle through the base of the unit.

If removing the casters is necessary for installation, the unit should be raised off the ground. This should be done with an approved material.

(Consult local building codes for approved material.)

LEVEL UNIT

1.After placing unit in position, check to make certain the unit is level side to side and front to back.

2.Accurate leveling is essential for proper operation.

3

DIMENSIONS - FREESTANDING MODELS

24 5/8??? (62.5 cm)

2 1/2???

(6.4 cm)

4 3/16???

(10.6 cm)

13 3/4???

(34.9 cm) 24 5/8???

(62.5 cm)

23 1/8???

(58.7 cm)

12 5/16???

(31.3 cm)

4

CABINET CUTOUT -

UNDERCOUNTER MODELS

*24??? width for cabinet only. 24 1/4??? (61.6 cm) needed for cabinet and door width clearance if door is recessed between cabinets.

5

DIMENSIONS - UNDERCOUNTER MODELS

*Actual dimension of drain pan is 12??? x 5??? (30.5 cm x 12.7 cm)

6

7

CO2 REGULATOR

1.Low pressure gauge.

(reads the amount of internal keg pressure)

2.Adjustment lock nut.

3.Regulator adjustment screw

(after keg is tapped, screw clockwise until low pressure gauge indicates between 12 & 14 lbs.)

4.Shut-off valve.

5.CO2 Nut (use fiber CO2 washer)

How to Replace an Empty CO2 Cylinder

1.Close cylinder valve by turning clockwise ???A???.

2.Unscrew adjustment screw (counter-clockwise) ???B??? as far as it will go.

3.Remove the regulator from empty cylinder ???E???.

4.Remove dust cap from new cylinder ???E???. Open and close valve ???A??? quickly to blow dust from outlet.

5.With cylinder valve ???A??? in closed position, reattach regulator to cylinder at ???E???. Be sure to include the CO2 washer.

6.Open valve ???A??? all the way. (This is important because this cylinder valve seals in two places.)

7.Readjust regulator pressure ???B??? and open valve ???C???.

8

SANKEY TYPE KEG

COUPLER

(Taps all CoorsTM, MillerTM and BudweiserTM kegs)

TWIN PROBE KEG TAPS

CO2 Cylinders (It is recommended to have an extra cylinder on hand)

9

DRAIN HOSE AND CONTAINER

Before using the beverage dispenser, make sure the drain hose and container are properly installed.

1.Attach the hose to the drain.

2.Attach the container to the hose.

3.Empty the container when it becomes full.

4.Rinse both the hose and container before reattaching to the beverage dispenser.

Drain

Drain hose

Drain container

FINAL PREPARATION

???All stainless steel parts should be wiped with hot soapy water. If buildup occurs, do not use steel wool, abrasive cloths, cleaners, or powders. If it is necessary to scrape stainless steel to remove encrusted materials, soak with hot, wet cloths to loosen the material, then use a wood or nylon scraper. Do not use a metal knife, spatula, or any other metal tool to scrape stainless steel; scratches are almost impossible to remove.

GENERAL TIPS AND SUGGESTIONS

???After making a temperature change, allow 24 hours for your unit to reach a new temperature setting. ???The motor will start and stop often. It must do this to maintain the temperature you select.

???Unplug the appliance before working on anything with the electrical system.

???Exercise caution when sweeping, vacuuming, or mopping near the front of the unit. Damage to the grill can occur. ???For all cleaning, mix 2 tablespoons baking soda with 1 quart warm water or use mild soapy and water solution. Do not use strong cleaners or scouring powder or pads.

???Keep your appliance out of direct sunlight.

???Do not splash or spray water on or under the unit.

???Clean you appliance???s condenser periodically to maintain proper cooling performance.

10

WIRING DIAGRAM

24??? W. REFRIGERATED BEVERAGE DISPENSER

WARNING: ELECTRICAL GROUNDING INSTRUCTIONS

This appliance is equipped with a three prong grounding plug for your protection against shock hazard and should be plugged directly into a properly grounded three prong receptacle. Do not cut or remove the grounding prong from this plug.

OPERATING INSTRUCTIONS

SETTING THE CONTROL

NOTE: The control is factory set for the ideal draft beer temperature - 38oF (3.3oC). (Temperature setting may need adjustments depending on ambient temperature.)

Initially set the cold control knob midway between the numbers. Allow at least 48 hours for the unit to stabilize before making any adjustments to the initial temperture setting The higher the number, the cooler the temperature.

The temperature control knob is located at the bottom front of the cabinet, just behind the square opening near the middle of the grill.

Draft beer is not pasteurized, so it must be kept cold - preferably around 38oF (3.3oC). Temperatures above 45oF

(7.2oC) may cause the beer to become wild, turn sour and cloudy. Draft beer should be consumed within 30 days, as it is not pasteurized and loses its original brewery fresh taste and aroma the older it gets.

11

12

COMMON DRAFT PROBLEMS

ENERGY SAVING TIPS

Ways to save power, save money, and still enjoy your beverage dispenser.

???Reduce door openings.

???Close the door as soon as you can.

???Keep the coils on bottom of the refrigerator clean.

???Adjust the temperature control to a warmer setting when practical. ???Keep unit away from the stove or other heat sources.

13

CLEANING AND MAINTENANCE

Condenser

The condenser tubing under the cabinet for forced air units does not require frequent cleaning. However, satisfactory cooling depends on adequate ventilation over the condenser. Be sure that nothing obstructs the air flow openings in the lower front of the cabinet. At least once or twice a year brush or vacuum lint and dirt from the condenser for efficient performance by unscrewing the grill on the bottom front of the cabinet.

Cabinet

The painted cabinet can be washed with mild soap and water and thoroughly rinsed with clear water. Never use abrasive scouring powders.

Interior and Door Gasket

Wash interior compartment with mild soap and water. Mix 2 tablespoons of baking soda with one quart of warm water. Do not use an abrasive powder, solvent, polish cleaner or undiluted detergent.

SERVICE INFORMATION

It is assumed that your beverage dispenser has been properly installed in accordance with all specifications and local codes. If your beverage dispenser should fail to operate, review the common draft problems before calling for service.

If service is required:

1.Call your dealer or authorized service agency. The name of the authorized service agency can be obtained from the dealer or distributor in your area.

2.Have the following information readily available:

???Model Number

???Serial Number ???Date of purchase

???Name of dealer from whom purchased.

3. Clearly describe the problem that you are having.

If you are unable to obtain the name of an authorized service agency, or if you continue to have service problems, contact Viking at (888) 845-4641 or write to:

VIKING PREFERRED SERVICE

111 Front Street

Greenwood, Mississippi 38930 USA

Record the information indicated below. You will need it if service is ever required. The model and serial number for your beverage dispenser is located on the front of the unit at the base of the door frame.

If service is requires installation of parts, use only authorized parts to ensure protection under the warranty. This manual should remain with the beverage dispenser for future reference.

14

PROFESSIONAL SERIES

24??? W. BEVERAGE DISPENSER WARRANTY

ONE YEAR FULL WARRANTY

Built-in/freestanding beverage dispensers and all of their components and accessories, except as detailed below*, are warranted to be free from defects in material or workmanship under normal household use for a period of one (1) year from the date of original retail purchase. Viking Range Corporation, warrantor, agrees to repair or replace, at its option, any part which fails or is found to be defective during the warranty period.

*Painted and decorative items are warranted to be free from defective materials or workmanship for a period of ninety (90) days from the date of original retail purchase. ANY DEFECTS MUST BE REPORTED TO THE SELLING DEALER

WITHIN NINETY (90) DAYS FROM DATE OF ORIGINAL RETAIL PURCHASE.

FIVE YEAR LIMITED WARRANTY

Any sealed refrigeration system component, as listed below, is warranted to be free from defective materials or workmanship in normal household use during the second through the fifth year from the date of original retail purchase. Viking Range Corporation, warrantor, agrees to repair or replace, at its option, any part which fails or is found to be defective during the warranty period.

Sealed Refrigeration System Components: Compressor, Evaporator, Condenser, Connecting Tubing, Dryer/Strainer

It is recommended that in temperatures above 100oF (37.8oC) and below 40oF (4.4oC) the unit be shut off. The normal operating range for the unit is between 60oF (15.6oF) and 100oF (37.8oC).

This warranty extends to the original purchaser of the product warranted hereunder and to each transferee owner of the product during the term of the warranty.

This warranty shall apply to products purchased and located in the United States and Canada. Products must be purchased in the country where service is requested. Warranty labor shall be performed by an authorized Viking Range Corporation service agency or representative. Warranty shall not apply to damage resulting from abuse, accident, natural disaster, loss of electrical power to the product for any reason, alteration, improper installation, improper operation or repair or service to the product by anyone other than an authorized Viking Range Corporation service agency or representative. Warranty shall not apply to damage resulting from indoor units being used in outdoor situations. This warranty does not apply to commercial usage. Warrantor is not responsible for consequential or incidental damage whether arising out of breach of warranty, breach of contract, or otherwise. Some jurisdictions do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.

Owner shall be responsible for proper installation, providing normal care and maintenance, providing proof of purchase upon request, and making the appliance reasonably accessible for service. If the product or one of its component parts contains a defect or malfunction during the warranty period, after a reasonable number of attempts by the warrantor to remedy the defects or malfunctions, the owner is entitled to either a refund or replacement of the product or its component part or parts. Replacement of a component part includes its free installation. Warrantor???s liability on any claim of any kind, with respect to the goods or services covered hereunder, shall in no case exceed the price of the goods or service or part there of which gives rise to the claim.

WARRANTY SERVICE: Under the terms of this warranty, service must be performed by a factory authorized Viking Range Corporation service agent or representative. Service will be provided during normal business hours, and labor performed at overtime or premium rates shall not be covered by this warranty. To obtain warranty service, contact the dealer from whom the product was purchased, an authorized Viking Range Corporation service agent, or Viking Range Corporation. Provide model and serial number and date of original purchase. For the name of your nearest authorized Viking Range Corporation service agency, call the dealer from whom the product was purchased or Viking Range Corporation. IMPORTANT: Retain proof of original purchase to establish warranty period.

The return of the Owner Registration Card is not a condition of warranty coverage. You, however, should return the Owner Registration Card so that Viking Range Corporation can contact you should any question of safety arise which could affect you.

Any implied warranties of merchantability and fitness applicable to the above described undercounter refrigerator are limited in duration to the period of coverage of the applicable express written limited warranties set forth above. Some jurisdictions do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. This warranty gives you specific rights, and you may also have other rights which may vary from jurisdiction to jurisdiction.

Viking Range Corporation

111 Front Street ???Greenwood, Mississippi 38930 USA ???(662) 455-1200

15