Attachment
Illustrated
Parts List
M A N U F A C T U R I N G , I N C .
500 N Spring Street / PO Box 997
Port Washington, WI
?? Copyright 2000 Simplicity Manufacturing, Inc.All Rights Reserved.
Rev. 10/2000
TP
Attachment
Illustrated
Parts List
M A N U F A C T U R I N G , I N C .
500 N Spring Street / PO Box 997
Port Washington, WI
?? Copyright 2000 Simplicity Manufacturing, Inc.All Rights Reserved.
Rev. 10/2000
TP
Turbo Clean Sweep Twin Catcher - Cover & Bag Group
NOTE: Unless noted otherwise, use the standard hardware torque specification chart.
983952
8
17
16
28
29
The above parts group applies to the following Mfg. Nos.:
1691792 Turbo Clean Sweep Twin Catcher
Turbo Clean Sweep Twin Catcher - Cover & Bag Group
Footnotes:
The above parts group applies to the following Mfg. Nos.:
1691792 Turbo Clean Sweep Twin Catcher
Turbo Clean Sweep Twin Catcher - Hitch Group
use the standard hardware torque specification chart.
The above parts group applies to the following Mfg. Nos.:
1691792 Turbo Clean Sweep Twin Catcher
Turbo Clean Sweep Twin Catcher - Hitch Group
Footnotes:
The above parts group applies to the following Mfg. Nos.:
1691792 Turbo Clean Sweep Twin Catcher
Turbo Clean Sweep Twin Catcher - Adapter, Blade & Tube Group
use the standard hardware torque specification chart.
The above parts group applies to the following Mfg. Nos.:
1691792 Turbo Clean Sweep Twin Catcher
Turbo Clean Sweep Twin Catcher - Adapter, Blade & Tube Group
Footnotes:
The above parts group applies to the following Mfg. Nos.:
1691792 Turbo Clean Sweep Twin Catcher
Hardware Identification & Torque Specifications
Common Hardware Types
Standard Hardware Sizing
When a washer or nut is identified as 1/2??? , this is the
Nominal size, meaning the inside diameter is 1/2 inch; if a second number is present it represent the threads per inch
When bolt or capscrew is identified as 1/2 - 16 x 2??? , this means the Nominal size, or body diameter is 1/2 inch; the second number represents the threads per inch (16 in this example, and the final number is the body length of the bolt or screw (in this example 2 inches long).
The guides and ruler furnished below are designed to help you select the appropriate hardware and tools.
Torque Specification Chart
FOR STANDARD MACHINE HARDWARE (Tolerance ?? 20%)
NOTES
1.These torque values are to be used for all hardware excluding: locknuts,
2.Recommended seating torque values for locknuts:
a.for prevailing torque locknuts - use 65% of grade 5 torques.
b.for flange whizlock nuts and screws - use 135% of grade 5 torques.
3.Unless otherwise noted on assembly drawings, all torque values must meet this specification.
Wrench & Fastener Size Guide