Operating Instructions

VACUUM CLEANER

???Before operating this unit, please read the instructions carefully.

???Indoor use only.

Register your product at www. samsung. com/ global/ register

IMPORTANT SAFEGUARDS

1.Read all instructions carefully. Before switching on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate on the bottom of the cleaner.

2.WARNING: Do not use the vacuum cleaner when rug or floor is wet.

Do not use to suck up water.

3.Close supervision is necessary when any appliance is used by or near children. Do not allow the vacuum cleaner to be used as a toy. Do not allow the vacuum cleaner to run unattended at any time. Use the vacuum cleaner only for its intended use as described in these instructions.

4.Do not use the vacuum cleaner without a dust bin. Empty the dust bin before it is full in order to maintain the best efficiency.

5.Do not use the vacuum cleaner to pick up matches, live ashes or cigarette butts. Keep the vacuum cleaner away from stoves and other heat sources. Heat can deform and dis- colour the plastic parts of the unit.

6.Avoid picking up hard, sharp objects with the vacuum cleaner as they may damage the cleaner parts. Do not stand on the hose assembly. Do not put weight on the hose. Do not block the suction or the exhaust port.

7.Switch the vacuum cleaner off on the body of the machine before unplugging from the electrical outlet. Disconnect the plug from the electrical outlet before changing the dust bag or dust container. To avoid damage, please remove the plug by grasping the plug itself, not by pulling on the cord.

8.This appliance is not intended for use by young children or infirm persons without supervision unless they are adequately supervised by a responsible person to ensure that they can use the appliance safely.

Young children should be supervised to ensure that they do not play with the appliance.

9.The plug must be removed from the socket outlet before cleaning or maintaining the appli- ance.

10.The use of an extension cord is not recommended.

11.If your vacuum cleaner is not operating correctly, switch off the power supply and consult an authorized service agent.

12.If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.

13.Don???t carry the vacuum cleaner by holding the hose. Use the handle on the vacuum cleaner set.

14.Unplug the cleaner when not in use. Turn off the power switch before unplugging.

1

1ASSEMBLING THE CLEANER

OPTION

For storage, park the floor nozzle.

2

2OPERATING THE CLEANER

2-1. POWER CORD

NOTE

When removing the plug from the electrical outlet, grasp the plug, not the cord.

2-2. POWER CONTROL (INFRARED CONTROL)

1)REMOTE CONTROL TYPE

-HOSE

SENDER

HANDLE CONTROL

[The cleaner is controlled by using infrared signals.]

- BODY

OPTIONAL - DIGITAL SIGNAL

POWER ON/OFF

1.Vacuum cleaner ON/OFF ( )

Press the ON/OFF button to operate the vacu- um cleaner. Press again to stop the vacuum cleaner.

2.Vacuum cleaner (+ , -)

Press the (+) button to operate the vacuum to highsuction power. Press the (-) button to oper- ate the vacuum to low suction power.

NOTE : Don???t cover the handle sender when you use a handle control button.

Press the power ON/OFF button repeatedly to start and to stop the vacuum cleaner

(OFF ??? ON ??? OFF)

NOTE : If the remote handle control is not working, the cleaner can be operated using the ON/OFF button on the body of the machine.

RECEIVER

The IR light indicates the part that receives the infra-red signal from the handle control.

The ON/OFF button operates the vacuum cleanner or stops it.

The filter light is illuminated when the dust pack requires checking or emptying. An audio signal will also sound.

3

2) BODY-CONTROL TYPE

To reduce suction for cleaning draperies, small rugs, and other light fabrics, pull the tap air until the hole is open.

To control power level, just slide the power control botton right and left.

off = For stopping the vacuum cleaner.

MAX = For hard floors and heavily soiled carpets.

2-3. HOW TO USE AND MAINTAIN THE ACCESSORIES

???

Features may vary according to model.

PIPE

Adjust the length of the telescopic pipe by sliding the length control but- ton located in the center of the tele- scopic pipe back and forth.

To check for blockages, separate the telescop- ic pipe and adjust to shorten. This allows for easier removal of waste clogging the tube.

ACCESSORY

All in one Accessory

Push the accessory on to the end of the hose han- dle.

Pull out and turn the dust- ing brush for cleaning deli- cate areas.

To use the upholstery tool, push the accessory on to the end of the hose handle in the opposite direction.

ELBOW EXTENDING TUBE (OPTION)

1.Connect the elbow extending tube to connecting part for hose knob and telescopic pipe.

2.Fit the telescopic pipe to the lower part of the elbow extending tube.

3.Press the PUSH button.

4.With the PUSH button pressed, the elbow extending tube is folded.

5.Using the elbow extending tube allows hard to reach areas (e.g. under furniture)to be cleaned without having to kneel down.

4

OPTION - Carpet

Cleaning

OPTION

Vacuum dust in wide area at once

Remove waste matter completely if the inlet is blocked.

OPTION

For improved pick- up of pet hair and fibre on carpets

Frequent vacuuming of hair or pet fur may cause a falling-off of the rotation due to matters tangled around the drum. In this case, clean the drum with care.

Brush for blanket

For picking up pet hair and fibre on upholstery

Remove waste matter com- pletely when inlet is blocked.

and bed linen.

Warning : Use for bedclothes only. Be cautious not to damage brush during unclogging.

5

3EMPTYING THE DUST BIN

Once dust reaches the DUST FULL mark, empty the dust bin.

Throw the dust away in the bin.

After empting the DUST BIN, remove the obstacles like hair, fur on the cap of the DUST BIN.

Before use, push the dust bin into the main body of the vac- uum cleaner until you hear the "click" sound.

- Empty into a plastic bag

(recommended for asthma/allergy sufferers)

OPTION

NOTE

You may rinse the dust bin with cold water

6

4CLEANING THE DUST PACK

4-1. WHEN TO CLEAN THE DUST PACK

-Please, check the dust bin and dust pack if suction is noticeably reduced or the filter check indicator lamp turns on after empting the dust bin.

The lamp will illuminate to signal when suction is reduced.

If the light comes on, please clean the DUST BIN as shown.

4-2. CLEANING THE DUST BIN

NOTE :

Please, check the filter check indicator lamp (4-3) as shown in the following illustrations if the lamp is still illumi- nated even after clean- ing the dust bin.

4-3. CHECKING THE FILTER CHECK INDICATOR LAMP

Turn the vacuum power to 'MAX'

If the filter check indicator turns red with the inlet floating 10cm above flat floor, clean the DUST PACK.

7

4-4. CLEANING THE DUST PACK

Wash the sponge and the filter of the dust pack with water.

Let the sponge and filter dry in the shade for more than 12 hours.

Put the sponge and filter into the dust pack.

Before reassembly, align the dust pack cover and dust pack correctly.

Put the assembled dust pack into the main body.

NOTE : Make sure the filter is completely dry before putting it back into the vacuum cleaner. Allow 12 hours for it to dry.

8

5CLEANING THE MOTOR PROTECTION FILTER

Take out both the dust bin and the dust pack.

Remove the motor protection filter from the vacuum cleaner. Shake and tap the dust from it and put back in machine.

6CLEANING THE OUTLET FILTER

OPTION - MICRO CARBON FILTER

NOTE :

Replacement filters are avail- able at your local Samsung distributor.

Remove and replace the blocked outlet filter.

9

7CHANGE THE BATTERY(OPTIONAL)

BATTERY TYPE : AAA Size

NOTE

1. When the vacuum cleaner does not work, replace the batteries. If the problem persists, please contact our authorized dealer.

2. Use 2 batteries of size AAA.

3.Do not reverse (+),(-) poles.

4.Dispose of the batteries properly.

- IF YOU HAVE A PROBLEM

10

M E M O

M E M O

M E M O

M E M O

DJ68-00369L REV(0.3)