Microphone Mixer

Connections

AUX2 L and R AUX1 L and R

BATTERY LOW

Indicator

Thank you for purchasing your Stereo 4-Channel Microphone Mixer from RadioShack. It enables you

to mix and add sound from up to four microphones or two audio input sources, such as a CD player, tuner, or cassette player. Please read this user???s guide before installing, setting up and using your new product.

What???s Included

MixerUser???s Guide

Speci???cations

POWER Switch

MONO/STEREO

OUTPUT L and R

Use shielded audio cables (not supplied) for all input connections. The connected input source???s signals are routed to the corresponding channel on the mixer.

Two stereo inputs

Connect the line level outputs from one device to the mixer???s AUX 1 INPUT R and L jacks. Connect the line level outputs from the second device to the mixer???s AUX 2 INPUT R and L jacks.

Four stereo sources as monaural inputs

Use shielded Y-adapters (not supplied) at each source???s left and right outputs, and connect a separate stereo source to each input jack (AUX 1 R, AUX 1 L, AUX 2 R, or AUX 2 L) on the mixer.

Speci???cations are subject to change and improvement without notice. Actual product may vary from the images found in this document.

Recycle Rechargeable Batteries

Placing rechargeable batteries in the trash can be harmful to the

environment. Instead, recycle old rechargeable batteries at your

local RadioShack store free of charge. RadioShack participates in the RBRC?? battery recycling program, and is committed to

preserving the environment and conserving natural resources. Call 1-800-THE-SHACK (1-800-843-7422) for more information.

CHANNEL 1-4

Four monaural inputs

Limited Warranty

This product is warranted by RadioShack against manufacturing defects in

Setting Up Your Mixer

Installing Batteries

1.Remove the battery cover.

2.Insert one 9V battery (not supplied) in the battery compartment matching the polarity symbols (+ and

???) marked on the back of the battery cover.

3.Replace the battery cover.

Replace the battery when BATTERY LOW indicator lights.

Battery Notes

???Dispose of old batteries promptly and properly.

???Do not burn or bury batteries.

???Use only a fresh battery of the required size and recommended type.

???If you do not plan to use the mixer for more than a week, remove the battery. It can leak chemicals that can damage electronic parts.

Using AC Power

Notes:

???Always connect the AC adapter to the mixer before you connect it to AC power. When you finish, disconnect the adapter from AC power before you disconnect it from the mixer.

???Using an adapter that does not meet the specifications could damage the mixer or adapter.

Presetting the Mixer

To prevent accidental audio mixing or channel overdrive, set MONO/STEREO to MONO, set POWER ON/OFF to

OFF, and slide Channel 1???4 to 0 (minimum) before you connect to your power supply.

A sudden high output from the mixer could damage audio devices connected to the mixer and could damage your hearing, especially if you use headphones.

Presetting Audio Devices

Make sure you power off the devices before you connect them to the mixer.

To avoid sudden sound outputs from connected audio devices, adjust the volume of the connected audio device to its lowest level.

Connect each monaural device to each input jack (AUX 1 R, AUX 1 L, AUX 2 R, or AUX 2 L) on the mixer.

Two monaural sources as stereo inputs

Use shielded Y-adapters (not supplied) at each source???s monaural outputs, and connect one source to AUX 1 R and L. Connect the other source to AUX 2 R and L.

MIC jacks

Four microphones

Connect up to four microphones to the mixer???s MIC jacks (1???4). Each microphone signal is routed to the mixer???s corresponding channel.

If you connect an audio device and a microphone so they are output to the same channel, the signals from both devices are mixed and controlled by the mixer.

Output

To play the mixer???s output through your speaker system (at parties, dances, conferences, etc.), use an audio patch cord (not supplied) to connect the mixer???s OUTPUT L and R jacks to your receiver or ampli???er???s line input jacks.

To record the mixer???s output, use an audio patch cord (not supplied) to connect the mixer???s OUTPUT L and R jacks to your recording device???s line input jacks.

material and workmanship under normal use for one (1) year from the date of purchase from RadioShack company-owned stores and authorized RadioShack franchisees and dealers. EXCEPT AS PROVIDED HEREIN, RadioShack MAKES

NO EXPRESS WARRANTIES AND ANY IMPLIED WARRANTIES, INCLUDING

THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE,

ARE LIMITED IN DURATION TO THE DURATION OF THE WRITTEN LIMITED

WARRANTIES CONTAINED HEREIN. EXCEPT AS PROVIDED HEREIN, RadioShack SHALL HAVE NO LIABILITY OR RESPONSIBILITY TO CUSTOMER

OR ANY OTHER PERSON OR ENTITY WITH RESPECT TO ANY LIABILITY, LOSS

OR DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE OR PERFORMANCE

OF THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WARRANTY,

INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM

INCONVENIENCE, LOSS OF TIME, DATA, PROPERTY, REVENUE, OR PROFIT OR

ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, EVEN IF RadioShack HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.

Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you.

In the event of a product defect during the warranty period, take the product and the RadioShack sales receipt as proof of purchase date to any RadioShack store. RadioShack will, at its option, unless otherwise provided by law: (a) correct

the defect by product repair without charge for parts and labor; (b) replace the product with one of the same or similar design; or (c) refund the purchase price.

All replaced parts and products, and products on which a refund is made, become the property of RadioShack. New or reconditioned parts and products may be

used in the performance of warranty service. Repaired or replaced parts and products are warranted for the remainder of the original warranty period. You will be charged for repair or replacement of the product made after the expiration of the warranty period.

This warranty does not cover: (a) damage or failure caused by or attributable to acts of God, abuse, accident, misuse, improper or abnormal usage, failure to follow instructions, improper installation or maintenance, alteration, lightning

or other incidence of excess voltage or current; (b) any repairs other than those provided by a RadioShack Authorized Service Facility; (c) consumables such as

fuses or batteries; (d) cosmetic damage; (e) transportation, shipping or insurance costs; or (f) costs of product removal, installation, set-up service adjustment or reinstallation.

This warranty gives you speci???c legal rights, and you may also have other rights which vary from state to state.

RadioShack Customer Relations

www.radioshack.com

Protect the environment by recycling used electronics. Go to www.ecyclingcentral.com to ???nd a recycle location near you.

Using Your Mixer

1Set the POWER switch to ON. To avoid popping sounds, always turn on the mixer before you turn on your ampli???er.

2.Turn on the output ampli???er and set its volume to minimum.

3.Set the audio input source???s volume to minimum. Turn on the source, and set it to play (or continuously talk into the microphone).

4.Adjust the mixer???s corresponding CHANNEL 1, 2, 3, or 4 to level 6-10. When mixing more than one audio input, adjust each input???s volume to about the same listening level.

5.Adjust the output ampli???er???s volume as desired.

6.When you are ???nished mixing, turn off the mixer, the output ampli???er, and all audio input sources.

Mixing Mono or Stereo

To mix mono signals with stereo signals, set STEREO/ MONO to STEREO.

When STEREO/MONO is set to MONO:

???The mixer routes monaural input signals of devices connected (separately) to the mixer???s AUX 1 L, AUX 1 R, AUX 2 L, AUX 2 R jacks to both outputs.

???The mixer changes stereo input signals of devices connected to the mixer???s AUX 1 L/R and AUX 2 L/R jacks to monaural signals.

For mono ampli???ers (found in some PA systems), it is best to set MODE STEREO/MONO to MONO.

Voiceovers

Talk into a microphone to mix pre-recorded music or sound from an audio input source with your voice.

1.Before talking, adjust CHANNEL (corresponding to the connected audio source) to the desired volume level.

2.As the music plays, talk or sing into the microphone. Adjust the microphone and audio levels so you can hear yourself over the music.

3.If you pause and stop talking or singing, adjust CHANNEL to its original position (step 1).

4.When ???nished, adjust the microphone???s volume to 0 and the audio source???s CHANNEL to its original position (step 1).

Important Safety Instructions

Read Instructions ??? All safety and operating instructions should be read before the appliance is operated.

Retain Instructions ??? The safety and operating instructions should be retained for future reference.

Heed Warnings ??? Follow all warnings on the appliance and in the operating instructions.

Cleaning ??? Unplug this appliance from the wall outlet before cleaning. Use only a damp cloth for cleaning. Do not use liquid or aerosol cleaners.

Water and Moisture ??? Do not use this appliance near water (for example, near a bathtub, washbowl, kitchen sink, or laundry tub; in a wet basement; or near a swimming pool).

Mounting Accessories ??? Do not place this appliance on an unstable cart, stand, tripod, bracket, or table. The appliance may fall, causing serious injury to a child or adult, and serious damage to the appliance.

Ventilation ???Do not place the appliance on a bed, sofa, rug, or other similar surface. Do not place the appliance in a built-in installation such as a bookcase or rack unless it provides proper ventilation as speci???ed by the manufacturer.

Heat ??? The appliance should be situated away from heat sources such as radiators, heat registers, stoves, or other appliances (including ampli???ers) that produce heat.

Power Sources ??? Operate this appliance using only the power source indicated on its marking label. If you are not sure of your home???s power type, consult your appliance dealer or local power company.

Power-Cord Protection ??? Route power-supply cords so they are not likely to be walked on or pinched by items placed on or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance.

Power Lines ??? An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside

antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

Nonuse Periods ??? The power cord of the appliance should be unplugged from the outlet when the appliance is to be left unused for a long period of time.

Overloading ??? Do not overload wall outlets, extension cords, or integral convenience receptacles, as this can result in a risk of ???re or electric shock.

Objects and Liquids ??? Never push objects of any kind into this appliance through openings, as they may touch dangerous voltage points or short out parts that could result in a ???re or electric shock. Never spill liquid of any kind on the appliance.

Carts and Stands ??? If the appliance is used with a cart or stand, the cart or stand should be a type recommended by the manufacturer. An appliance and cart combination should be moved with care. Quick stops, excessive

force, and uneven surfaces cause the appliance and cart combination to overturn.

Damage Requiring Service ??? Unplug this appliance from the wall outlet and refer servicing to quali???ed service personnel under the following conditions:

???When the power-supply cord or plug is damaged.

???If liquid has been spilled or objects have fallen into the appliance.

???If the appliance has been exposed to rain or water.

???If the appliance does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions, as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the appliance to normal operation.

???If the appliance has been dropped or damaged in any way.

???When the appliance exhibits a distinct change in performance.

Servicing ??? Do not attempt to service this appliance yourself, as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to quali???ed service personnel.

Replacement Parts ??? When replacement parts are required, be sure the service technician has used replacement parts speci???ed by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in ???re, electric shock or other hazards.

Safety Check ??? Upon completion of any service or repairs to this appliance, ask the service technician to perform safety checks to determine that the appliance is in proper operating condition.

Lightning ??? For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet. This will prevent damage to the product due to lightning and power line surges.

Attachments ??? Do not use attachments not recommended by the product manufacturer as they may cause hazards.

Wall or Ceiling Mounting ??? The product should be mounted to a wall or ceiling only as recommended by the manufacturer.

CAUTION

RISK OF ELECTRIC SHOCK !

DO NOT OPEN

WARNING: 7RUHGXFHWKHULVNRI??UHRUVKRFNKD]DUGGRQRWH[SRVHWKLVSURGXFW WRUDLQRUPRLVWXUH

CAUTION725('8&(7+(5,6.2)(/(&75,&6+2&.'21275(029(7+( &29(525%$&.1286(56(59,&($%/(3$576,16,'(5()(56(59,&,1* 7248$/,),('3(56211(/

The lightning symbol is intended to alert you to the presence of uninsulated, dangerous voltage within this product???s

HQFORVXUHWKDWPLJKWEHRIVXI??FLHQWPDJQLWXGHWRFRQVWLWXWHD

risk of electric shock. Do not open the product???s case.

The exclamation symbol is intended to inform you that

!important operating and maintenace instructions are included in the literature accompanying this product.