INSTALLATION MANUAL

GEX-P900XM

This product conforms to CEMA cord colors.

Printed in Japan

MANUAL INSTALLATION

Connecting the Units

Note:

???This unit is for vehicles with a 12-volt battery and negative grounding. Before installing it in a recre- ational vehicle, truck, or bus, check the battery voltage.

???To avoid shorts in the electrical system, be sure to disconnect the - battery cable before beginning installation.

???Refer to the owner???s manual for details on connecting the power amp and other units, then make connections correctly.

???Secure the wiring with cable clamps or adhesive tape. To protect the wiring, wrap adhesive tape around them where they lie against metal parts.

???Route and secure all wiring so it cannot touch any moving parts, such as the gear shift, handbrake and seat rails. Do not route wiring in places that get hot, such as near the heater outlet. If the insulation of the wiring melts or gets torn, there is a danger of the wiring short-circuiting to the vehicle body.

???Don???t pass the yellow lead through a hole into the engine compartment to connect to the battery. This will damage the lead insulation and cause a very dangerous short.

???Do not shorten any leads. If you do, the protection circuit may fail to work when it should.

???Never feed power to other equipment by cutting the insulation of the power supply lead of the unit and tapping into the lead. The current capacity of the lead will be exceeded, causing overheating.

???When replacing fuse, be sure to use only fuse of the rating prescribed on the fuse holder.

???To prevent incorrect connection, the input side of the IP-BUS connector is blue, and the output side is black. Connect the connectors of the same colors correctly.

???Cords for this product and those for other products may be different colors even if they have the same function. When connecting this product to another product, refer to the supplied Installation manuals of both products and connect cords that have the same function.

Green (Terrestrial)

Fuse holder

Yellow

To terminal always supplied with power regardless of ignition switch position.

Black (ground)

To vehicle (metal) body.

Screw (3 ??? 6 mm)

Fig. 2

Installation

Note:

???Before finally installing the unit, connect the wiring temporarily, making sure it is all connected up properly, and the unit and the system work properly.

???Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions.

???Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle.

???Install the unit where it does not get in the driver???s way and cannot injure the passenger if there is a sudden stop, like an emergency stop.

???When mounting this unit, make sure none of the leads are trapped between this unit and the sur- rounding metalwork or fittings.

???Do not mount this unit near the heater outlet, where it would be affected by heat, or near the doors, where rainwater might splash onto it.

???Before drilling any mounting holes always check behind where you want to drill the holes. Do not drill into the gas line, brake line, electrical wiring or other important parts.

???If this unit is installed in the passenger compart- ment, anchor it securely so it does not break free while the car is moving, and cause injury or an accident.

???If this unit is installed under a front seat, make sure it does not obstruct seat movement. Route all leads and cords carefully around the sliding mechanism so they do not get caught or pinched in the mecha- nism and cause a short circuit.

Installing the Unit

Mounting with Brackets (Fig. 3)

Tapping screw (4 ??? 12 mm)

Screw (4 ??? 6 mm)

Bracket

Car mat or chassis

Drill 2 to 2.5 mm diameter holes.

Fig. 3