Installation and Assembly:

Desktop Swivel Mount for Philips 32HFL2082 and 40HFL2082 Displays

Model: HLG440-PH, HLG440-PH-Q10

Mounting to Desktop Surface

Mounting using Bolt Down Method

NOTE: Read entire instruction sheet before you start installation and assembly.

Before you start make sure all parts listed are included with your product.

D E F

G H I

A

B C

Mounting using Bolt Down Method

1 Choose swivel range below and identify swivel range holes of swivel plate assembly (A).

A

SWIVEL RANGE HOLE

Place two 1/4-20 x 1-3/4" thin head carriage bolts (C) into slots of swivel plate assembly (A).

C

A

TABLE TOP

B

A

ARROW INDICATES FRONT OF SWIVEL

PLATE ASSEMBLY

DISPLAY

BASE SCREWS

32" Display Base Attachment Location (note orientation of plate to base)

FRONT

.88"

wrench between both slope nuts (D) and tighten. NOTE: Avoid jamming both slope nuts (D) together, doing so may make it difficult to remove slope nut used for tightening first slope nut (D) as shown in fig 4.1. After slope nut is secure remove bottom slope nut and add plastic cap (E) as shown in figure 4.2. Repeat with remaining

1/4-20 x 1-3/4" thin head carriage bolt (C).

C

D C

Detail 1

BOTTOM OF DESKTOP

C

TIGHTENING

SLOPE NUT

E

NOTE: Do not overtighten slope nut (D) plate may distort

Installation of Security Screws for Base to Display Attachment

42" Display Base Attachment Location

(note orientation of screws)

H

G

DISPLAY

I

DISPLAY BASE

NOTE: Display and base may appear different than illustrated

?? 2010, Peerless Industries, Inc. All rights reserved. All other brand and product names are trademarks or registered trademarks of their respective owners.