Motorola_Microphone

DESCRIPTION

The Mobile Keypad Microphone (Mic), Motorola?? Kit Number HMN4079_ is a full keypad handheld microphone. The keypad on this microphone is intended to assist in navigating through the menus on its parent device, as well as entering information such as phone numbers and menu picks.

INSTALLATION

1.Refer to illustration below and attach hangup clip (1) to vehicle using the two sheet metal screws and back-up plate provided. Place back-up plate (4) behind dashboard. Use flat- head screw (2) in top mounting hole and hex-washer screw

(3) in bottom mounting hole. Be certain mounting screws fasten into holes in back-up plate.

2.Insert button on rear housing of Mic into hang-up clip.

3.Insert the GCAI plug on the radio end of the Mic cord into the GCAI jack on the front of the radio.

4.Turn the locking collar on the radio end of the Mic cord 1/4 turn clockwise to secure it in place.

MOBILE MICROPHONE MOTOROLA KIT NO. HMN4079_

DISCONNECTING MIC FROM RADIO

1.Turn the locking collar on the radio end of the Mic cord 1/4 turn counter clockwise.

2.Pull cable from GCAI connector to release.

OPERATION

Press PTT switch before speaking into Mic. Position Mic about 1- inch away from mouth and speak into Mic in a normal voice.

TROUBLESHOOTING

Troubleshooting of Mic is limited to determining whether the inoperable condition of a Mic is caused by a faulty Mic Cord or a faulty Mic Head. To make this determination and correct the fault, replace the Mic Cord with the spare first. If replacing the Mic Cord does not restore operation, replace the Mic Head. The Mic Cord and Mic Head are not repairable items, therefore they must be replaced when they are determined to be faulty.

REPLACING MIC CORD

Removing Cord from Mic Body

1.Refer to illustration on next page. Grasp locking collar and, while pushing it firmly towards Mic body, turn it counterclock- wise 1/4 turn to disengage it from Mic body.

2.Disconnect cord from Mic body by pulling TELCO connector (which has no tab on it) out of TELCO jack on circuit board inside Mic body.

Installing Cord Into Mic Body

1.Slide locking collar on Mic end of cord away from TELCO plug and past strain relief on cord.

2.Orient TELCO plug on Mic end of cord so that it aligns with TELCO jack inside Mic body and its contacts face rear of Mic housing.

3.Pass TELCO plug through hole at bottom of Mic body and plug it into TELCO jack on circuit board inside Mic body.

4.Slide locking collar back up on cord with tabs on its sides facing sides of Mic body.

5.Push locking collar firmly into hole at bottom of Mic body then turn it 1/4 turn clockwise to secure it in place.

European Union (EU) Waste of Electrical and Electronic Equipment (WEEE) directive The European Union???s WEEE directive requires that products sold into EU countries must have the crossed out trash bin label on the product (or the package in some cases). As defined by the WEEE directive, this cross-out trash bin label means that customers and end-users in EU countries should not dispose of electronic and electrical equipment or accessories in household waste. Customers or end-users in EU countries should contact their local equipment supplier representative or service centre for information about the waste collection system in their country.

?? 2005, 2006 by Motorola, Inc.

8000 W. Sunrise Boulevard, Ft. Lauderdale, FL 33322. band MOTOROLA are trademarks of Motorola, Inc.

TELCO is a trademark of TELCO Intercontinental Corporation.

(Continued on Back)

*6881097C72*

6881097C72-P