30" combination microwave/wall ovens
JMW3430W, JMW2430W, JMW2330W ??? 293???4" x 431???8" x 263???4"
PRODUCT DIMENSIONS
A
B C
D
E
F
J
G
H
I
FRONT VIEW
A
K
LL 
M
N
O
P
Top VIEW
30" combination microwave/wall ovens
JMW3430W, JMW2430W, JMW2330W ??? 293???4" x 431???8" x 263???4"
PRODUCT DIMENSIONS
A
B C
D
E
F
J
G
H
I
FRONT VIEW
A
K
LL
M
N
O
P
Top VIEW
30" combination microwave/wall ovens
JMW3430W, JMW2430W, JMW2330W ??? 293???4" x 431???8" x 263???4"
DIMENSIONS AS INSTALLED
F
G
H
I
Back of Cabinet
D
E
Conduit Channel
A
B
Side VIEW
C
Bottom of Cabinet
30" combination microwave/wall ovens
JMW3430W, JMW2430W, JMW2330W ??? 293???4" x 431???8" x 263???4"
OPENING/CLEARANCE DIMENSIONS
FRONT VIEW
Side VIEW
ELECTRICAL REQUIREMENTS
240 volt,
The length of conduit provided is for serviceability. Do not cut the conduit. The junction box should be located 3" (7.6 cm) maximum below the support surface. Drill a 11???4" (3.4 cm) minimum diameter hole in the left rear corner of the support surface for access to the junction box.
Power Supply Location
Back VIEW
Product dimension, cutout and installation specifications are provided for planning purposes only. Before installing any product, be sure to verify cutout dimensions and electrical/gas connections as actual product dimensions may vary.
JRC120003A 07/2012
30" combination microwave/wall ovens ??? Flush Installation
JMW3430W, JMW2430W, JMW2330W ??? 293???4" x 431???8" x 243???4" (depth without handles)
OPENING/CLEARANCE DIMENSIONS
FRONT VIEW
Side VIEW
ELECTRICAL REQUIREMENTS
240 volt,
The length of conduit provided is for serviceability. Do not cut the conduit. The junction box should be located 3" (7.6 cm) maximum below the support surface. Drill a 11???4" (3.4 cm) minimum diameter hole in the left rear corner of the support surface for access to the junction box.
Flush Installation Requirements
A 25" (63.5 cm) minimum cutout depth is required.
These dimensions will result in a 3???8" (1.0 cm) reveal on the top,
a 1???8" (0.3 cm) reveal on the sides and a 13???8" (3.5 cm) reveal on the bottom of the wall oven.
The front face of the cleats and platform will be visible and should be treated as a finished surface.
Power Supply Location
*Cleats and platform must be recessed 1" (2.5 cm) from the front of the cabinet.
Product dimension, cutout and installation specifications are provided for planning purposes only. Before installing any product, be sure to verify cutout dimensions and electrical/gas connections as actual product dimensions may vary.
JRC120003A 07/2012