Huffy_Fitness_Equipment

9/16"

A DIVISION OF RUSSELL CORPORATION

Pool System

Owners Manual

Customer Service Center

??? N53 W24700 South Corporate Circle ??? Sussex, WI 53089 ??? U.S.A.

REQUIRED TOOLS AND MATERIALS:

???2 People

???Optional: Large & Small Adjustable Wrenches

???(2 each) Wrenches and/or Socket Wrenches and

Sockets. Deep sockets recommended.

1/2"

AND/OR

???Garden Hose or Sand

1/2" 9/16"

Toll-Free Customer Service Number for U.S: 1-800-558-5234,

For Canada: 1-800-284-8339,

For Europe: 00 800 555 85234 (Sweden: 009 555 85234),

For Australia: 1-800-333 061

Internet Address: http://www.huffysports.com

SAFETY INSTRUCTIONS

FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY RESULT IN SERIOUS INJURY OR

PROPERTY DAMAGE AND WILL VOID WARRANTY.

Owner must ensure that all players know and follow these rules for safe operation of the system.

To ensure safety, do not attempt to assemble this system without following the instructions carefully. Check entire box and inside all packing material for parts and/or additional instruction material. Before beginning assembly, read the instructions and identify parts using the hardware identifier and parts list in this document. Proper and complete assembly, use and supervision are essential for proper operation and to reduce the risk of accident or injury. A high probability of serious injury exists if this system is not installed, maintained, and operated properly.

???DO NOT position system near trampolines, diving boards, slides, or any play area.

???If using a ladder during assembly, use extreme caution.

???This equipment is intended for home recreational use only and NOT excessive competitive play.

???DO NOT position system near trampolines, diving boards, slides, or any play area equipment. System misuse could cause serious bodily injury.

???Two pole assembly is for in-ground pool side use only.

???Read and understand the warning label affixed to pole.

???The life of your basketball pole depends on many conditions. The climate, placement of the pole, the location of the pole, exposure to corrosives such as chlorine, pesticides, herbicides or salts are all important factors.

???During assembly, if using a ladder use extreme caution. Two people are recommended for this operation.

???Seat the pole sections properly (if applicable). Failure to do so could allow the pole sections to seperate during play and/or during transport of the system.

???Climate, corrosion and excessive use or misuse could result in system failure.

???Check tank regularly for leakage. Slow leaks could cause system to tip over unexpectedly.

???If technical assistance is required, contact Huffy Customer Service Center.

???Adult supervision is recommended when adjusting system.

Most injuries are caused by misuse and/or not following instructions.

Use caution when using this system.

MOVING SYSTEM

1. While holding pole, rotate basketball system forward until wheels engage with ground.

2. Move basketball system to desired location.

4. Reattach ground restraint and check system for stability.

201261 3/99

NOTICE TO ASSEMBLERS

ALL Huffy Sports Basketball Systems, including those used for DISPLAYS, MUST be assembled and ballasted with sand or water according to instructions. Failure to follow instructions could result in SERIOUS INJURY. It is NOT acceptable to devise a makeshift weight system.

IMPORTANT!

Remove all contents from boxes. Be sure to check inside pole sections,

hardware and additional parts are packed inside.

WARRANTY CARD:

Please remember to complete your product registration form either on-line at: www.huffysports.com/customer_support/product_registration

or mail-in the enclosed postcard.

For more information on assembly, placement, proper use and maintenance, visit The American Basketball Council website at http://www.smarthoops.com.

WARNING

FAILURE TO FOLLOW THESE

WARNINGS MAY RESULT IN

SERIOUS INJURY AND/OR

PROPERTY DAMAGE.

Owner must ensure that all players know and follow these rules for safe operation of the system.

See instruction manual for proper installation and maintenance.

DO NOT position system near trampolines, diving boards, slides or any play area equipment. System misuse could result in serious bodily injury.

DO NOT perform dunk type activities on this system.

DO NOT hang from any part of system, including backboard, support braces, rim or net.

DO NOT jump, slide, climb, shake or play on tank and/or pole. Surface beneath the tank must be smooth and free of gravel or other sharp objects. Punctures cause leakage and could cause system to tip over.

After assembly is complete, fill tank completely with water or sand and stake to ground and/or permanent solid object. Never leave system in an upright position without filling tank with weight, as system may tip over causing injury.

DO NOT allow water in tank to freeze. During sub-freezing weather fill with 2 gallons of non-toxic antifreeze, sand or empty tank completely and store. (Do Not Use Salt.)

Keep pole top covered with cap at all times.

Keep organic material away from pole tank. Grass, litter, etc. could cause corrosion and/or deterioration.

Check pole system for signs of corrosion (rust, pitting, chipping) and repaint with exterior enamel paint. If rust has penetrated through steel anywhere, replace pole immediately. Check system before each use for loose hardware, excessive wear and signs of corrosion and repair before using.

Check system before each use for stability.

DO NOT use system during windy and/or severe weather conditions, system may tip over. Place system in the storage position and/or in an area protected from the wind and free from personal property and/or overhead power lines.

During play, use extreme caution to keep player's face away from the backboard, rim or net. Serious injury could occur if teeth/face come in contact with backboard, rim or net.

When adjusting height or moving unit, keep hands and fingers away from moving parts. Do not allow children to adjust system.

During play, do not wear jewelry (rings, watches, necklaces, etc.) Objects may entangle in net.

A Division of Russell Corporation

In the U.S.: 1-800-558-5234 and Canada Only: 1-800-284-8339

211239 2/05

SECTION A: ASSEMBLE THE BASE

This is what your system will look like when you???ve finished this section:

NOTE:

* Units with 42??? steel frame acrylic backboard do not require the use of included board struts (.75??? x 22???)

9/16??? and 1/2???

Item #5

Item #10

Item #6

AND/OR

Item #14

9/16??? and 1/2???

Item #26

7.Install backboard assembly to the pole assembly as shown. Attach backboard and rim (16) to the extension arm (18) using bolts (20), spacers (21), washers (10, 19) and nuts (15) as shown. Tighten completely. Attach bolt covers (29).

WARNING!

TWO PEOPLE REQUIRED

FOR THIS PROCEDURE.

FAILURE TO FOLLOW THIS

WARNING COULD RESULT IN

SERIOUS INJURY AND/OR

PROPERTY DAMAGE.

15 10

29 21

NOTE:

Peel protective film from surface of acrylic backboard prior to use.

NOTE:

BOARD STYLE

MAY VARY

Do not use washers here on spring return style rims.

Insert one ???arm??? of clip into ram as shown. Twist ???body??? of clip slightly so that second ???arm??? slides over the top of the first ???arm??? as shown.

Push in the direction indicated by arrow.

Push second ???arm??? back and into ram as shown.

Twist ???body??? of clip slightly again to spread ???arms??? of clip.

Clip ???arms??? must be flat and touching edge to edge as shown, not overlapping.