Overview

Overview

At A Glance

Processor:

Dual-Core AMD Opteron 1000 Series processors

Single-Core Athlon 64 3500+ processors

Memory:

512 MB Standard / 8 GB Maximum of PC2-5300 DDR2 667 MHz ECC unbuffered Memory

Storage Controller:

4 Port SATA controller with Embedded RAID on Motherboard (RAID 0,1,5)

Internal Drive Support:

4 HDD Support:

2TB SATA max storage (utilizing 500GB CTO HDD) 1.2TB SAS max storage (4 x 300GB)

Network Controller:

Embedded NC320i PCI Express Gigabit Server Adapter

Expansion Slots:

Two 32-bit/33MHz PCI at 3.3V slot

Two PCI-Express slots (x8 and x16).

USB Ports:

Eight total USB ports (2 internal, 2 front, 4 rear)

Form Factor:

Micro ATX tower

Management:

Standard IPMI reporting

Lights Out 100c Remote Management Card (Optional)

Warranty: This product is covered by a global limited warranty and supported by HP Services and a worldwide network of HP Authorized Channel Partners. Hardware diagnostic support and repair is available for one year from date of purchase. Support for software and initial setup is available for 90 days from date of purchase. Additional support may be covered under the warranty or available for an additional fee. Enhancements to warranty services are available through HP Care Pack services or customized service agreements.. Certain restrictions and exclusions apply. SATA hard drives have a one year warranty. (3-1-1 warranty offered in AP only).

Server Warranty includes 1 year Parts, 1 year Labor, 1-year on-site support with next business day response. Additional information regarding worldwide limited warranty and technical support is available at: http://h18004.www1.hp.com/products/servers/platforms/warranty/index.html

Standard Features

NOTE: For a brief, printer friendly data sheet that describes this product and informs you of the essential capabilities and

specifications, please visit: http://h71028.www7.hp.com/ERC/downloads/4AA1-0483ENW.pdf

Standard Features

Standard Features

Standard Features

Standard Features

Models

NOTE: For the Standard Features shipped in the "Factory Integrated Models", please see the "Configuration Information - Factory Integrated Models" section.

SATA Models

SAS Models

Configuration Information-Factory Integrated Models

NOTE: This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations are ordered, HP recommends the use of an HP approved configurator. Contact your local sales representative for information on CTO product offerings and requirements.

NOTE: HP does not allow factory integration of options into standard models listed above. Configure-to-order servers must start with a CTO Chassis.

NOTE: This product offering does not support HP Factory Express Server Configuration Level 1.

NOTE: FIO indicates that this option is a Factory Installable Option.

Step 1: Base Configuration

ModelsHP ProLiant ML115 NHP CTO Chassis (North America)439138-B21

Factory Integrated Models ship with:

Embedded NC320i PCI Express Gigabit Server Adapter

Keyboard and Mouse

370 Watts, PFC (Power Factor Correcting) Tower Form Factor (4U)

NOTE: HP SATA Drive Models are limited to <2TB support.

NOTE: On SATA models with embedded RAID, setup instructions are located in User Guide, CTO RAID is set-up not available. HP ProLiant 100 Series Server User Guide: http://h20000.www2.hp.com/bc/docs/support/SupportManual/ c00368941/c00368941.pdf?jumpid=reg_R1002_USEN

Step 2: Choose Required Options (only one of the following from each list unless otherwise noted)

Configuration Information-Factory Integrated Models

Step 3: Choose Additional Options for Factory Integration

NOTE: For additional options, please refer to the "Options" section below.

NOTE: Some options may not be factory integratable. Please contact your local sales representative for additional information.

Configuration Information-Factory Integrated Models

Options

Options

Options

Options

NOTE: Required for supporting USB peripherals.

NOTE: For additional information regarding KVM Switches, Serial Console servers, rack mount monitors, keyboards and all related options please see the following URL: http://www.hp.com/go/kvm.

Service and Support, HP Care Pack, and Warranty Information

Memory

HP ProLiant ML115 Models

NOTE: Memory configurations listed do not apply to "Factory Integrated Models".

Standard Memory

512 MB of PC2-5300 DDR2 SDRAM running at 512 MB with ECC capabilities Memory installed (1 x 512 MB SDRAM DIMM).

Standard Memory Plus Optional Memory

Up to 5120 MB memory is available with the optional installation of PC2-5300 un-buffered ECC DDR2 SDRAM DIMM Memory kits.

Standard Memory Replaced with Optional Memory

Up to 8192 MB of memory is available with the removal of the standard 512 MB of memory and the optional installation of PC2-

5300 un-buffered ECC DDR2 SDRAM DIMM Memory kits.

NOTE: The below chart does not represent all possible memory configurations.

NOTE: In memory configurations requiring 2 DIMM and 4 DIMM configurations, the memory must be paired for optimal performance. This means that DIMMs in slot 1 and 3 have to be identical, in slot 2 and 4 have to be identical. (For example, the Optional memory configuration shown below)

Storage

1 48x IDE (ATAPI) CD-ROM

2 Removable Media Bays (1.6" each) 3, 4, 5, 6 Four (4) Non-Hot Plug Drive Bays

Drive Support

Storage

Hard Drives (SAS Models only)

Tape Drives and D2D Backup System

NOTE: A SCSI controller needs to be purchased to operate internal SCSI devices in the SATA Models.

NOTE: For an up-to-date listing of the latest O/S Support details for each of the Tape Drives listed below, please see the following: http://h18000.www1.hp.com/products/quickspecs/division/10233.html (Worldwide)

Storage

HP StorageWorks D2DEmbedded Network ControllerN/A

Backup Systems

D2D110

D2D120

D2D130

Power Specifications

System Specifications

Technical Specifications

Technical Specifications

Technical Specifications

The EU WEEE directive (2002/95/EC) requires manufacturers to provide treatment information for each product type for use by treatment facilities. This information (product disassembly instructions) is posted on the Hewlett Packard web site at: http://www.hp.com/go/green. These instructions may be used by recyclers and other WEEE treatment facilities as well as HP OEM customers who integrate and re-sell HP equipment.

?? Copyright 2008 Hewlett-Packard Development Company, L.P.

The information contained herein is subject to change without notice.

Microsoft and Windows NT are US registered trademarks of Microsoft Corporation.

AMD, the AMD Arrow logo, AMD Opteron???, and combinations thereof, are trademarks of Advanced Micro Devices, Inc.

The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein.

For hard drives, 1 GB = 1 billion bytes. Actual formatted capacity is less.