Dimensions and Specifications (in inches) Installation Space

34-1/4"-

34-3/4"

The cutout depth must be 24"

The cutout dimensions shown allow for a full door swing and access to the pull-out racks when installed as a built-in.

??? The wine reserve can be free-standing.

Note: If installing between frameless cabinets, a 1/2" wide filler strip or side panel may be required. The filler strip will act as a spacer between the door case and adjacent cabinet and will prevent interference with cabinet door swing. The width of the opening

must include filler panels.

???Wine reserve is vented at the front toekick to allow built-in undercounter installation.

???Door swing is reversible.

Additional Specifications:

???A 120 volt 60Hz., 15 or 20 amp power supply is required. An individual property grounded branch circuit or circuit breaker is recommended. Install a properly grounded 3-prong electrical receptacle recessed into the back wall as shown. Electrical must be located on rear wall as shown. Note: GFI (ground fault interrupter) is not recommended.

Specification Created 10/07

Product Clearances

14" Minimum

All models are factory set for a 110?? door swing.

For a minimum 90?? door swing:

??? Allow 4" min. clearance to wall on the hinge side.

For a full 110?? door swing:

??? Allow 14" min. clearance to wall on the hinge side.

Listed by

Underwriters

Laboratories

For answers to your Monogram,?? GE Profile??? or GE?? appliance questions, visit our website at GEAppliances.com or call GE Answer Center?? service, 800.626.2000.

Dimensions and Specifications (in inches)

For a complete food storage center, install two Monogram refrigeration modules side-by-side.

Note: Reversible door swing on wine chillers/reserves and beverage centers only. See below for combination cutout dimensions.

Important Note: Products must operate from separate, properly grounded receptacles.

1-1/2"1-1/2"

47-1/2" Min.

Note: Additional cutout width may be required for models with custom panels.

Grounding the Wine Reserve

important ??? (Please read carefully)

for personal safety, this appliance must be properly grounded.

The power cord of this appliance is equipped with a 3-prong (grounding) plug which mates with a standard 3-prong (grounding) wall receptacle to minimize the possibility of electric shock hazard from this appliance.

Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.

When a standard 2-prong wall outlet is encountered, it is your personal responsibility and obligation to have it replaced with a properly grounded 3-prong wall out.

do not, under any circumstances, cut or remove the third (ground)

prong from the power cord.

do not use an adapter plug to connect the refrigerator to a 2-prong outlet.

do not use an extension cord with this appliance.