RTA ROUND TAPERED ALUMINUM

Catalog #

Comments

[ W I T H R O U N D T W I N E L L I P T I C A L A R M ]

Prepared by

SPECIFICATION FEATURES

Type

Date

1 ...Cast aluminum alloy shoe base with aluminum alloy bolt covers or base cover dependent upon base type.

2 ...Flush handhole assembly with internal reinforcing frame. 3" x 5" for 6" shafts. 4" x 6" for 7", 8", & 10" shafts. Ground lug located opposite handhole opening drilled & tapped for 3/8" 16NC-2 grounding screw.

3 ...Tapered aluminum lighting shaft with polished finish.

4 ...Aluminum alloy arm mounting plate fastened by

(4) 1/2" stainless steel hex head bolts, nuts and washers. Shaft drilled 1 1/4" diameter wire hole with 1" I.D. rubber grommet installed.

AL (arm length)

5 ...Tapered elliptical bracket aluminum alloy satin etch finish.

6 ...Removable aluminum alloy pole cap secured with

(3) 1/4" stainless steel allen head cup point set screws.

7 ...Anchor bolt per ASTM A576 with (1) nut, (1) flat washer, and (2) shims. Nuts, washers and threaded portion of bolt are hot dip galvanized.

6

5

4

3

FINISH COLORS [See ordering information. Other finish colors available]

WARNING: THE USE OF UNAUTHORIZED ACCESSORIES SUCH AS BANNERS, SIGNS OR PENNANTS FOR WHICH THE POLE WAS NOT DESIGNED FOR VOIDS THE

COOPER LIGHTING WARRANTY AND MAY RESULT IN POLE FAILURE CAUSING SERIOUS INJURY OR PROPERTY DAMAGE. COOPER LIGHTING'S POLE

WARRANTY IS ALSO VOIDED IF LUMINAIRE IS NOT INSTALLED AT TIME OF POLE INSTALLATION.

COOPER LIGHTING

MH (mounting height)

2

18" handhole

1

Base View

"#

$

"0

5

!"

(

F O U R B O LT A N C H O R A G E

BC=Bolt Circle

BP=Bolt Projection

AB=Anchor Bolt

D=Bolt Diameter

H=Bolt Dimensions