DASH DISASSEMBLY:

1.With the gear selector in low, firmly pull away the trim panel from the dash.

2.Disconnect all dash switch wiring from panel and remove panel.

RADIO PREPARATION: (Fig. 1)

1.Attach left bracket (Item #1) to the left side of the radio using (1) plastic push pin (Item #3) at the rear mounting hole and (2) screws (Item #4) at the front mounting holes.

2.Attach right bracket (Item #2) to the right side of the radio using (1) plastic push pins (Item #3) at the top mounting holes and (2) screws (Item #4) at the front mounting holes.

RADIO INSTALLATION: (Fig. 2)

1.Complete all radio wiring connections including attachment of the antenna adaptor.

2.Place radio assembly into dash opening by sliding onto rails and pushing back until plastic retainer clips lock.

3.Perform a functional test on the radio to assure proper op- eration.

4.Re-assemble the dash.