AT4053b HYPERCARDIOID CONDENSER MICROPHONE

???Specially engineered to meet the most critical acoustic requirements of professional recording, broadcast and sound reinforcement

???Direct-coupled, balanced output results in a clean signal even under high-output conditions

???Transformerless circuitry virtually eliminates low-frequency distortion and provides superior correlation of high-speed transients

???Switchable 80 Hz hi-pass filter and 10 dB pad

???Rugged turned-brass microphone housing for enduring dependability

???State-of-the-art design and manufacturing techniques ensure compliance with A-T???s stringent consistency and reliability standards

The AT4053b is intended for use in professional applications where remote power is available. It requires 48V DC phantom power, which may be provided by a mixer or console, or by a separate, in-line sourc e such as the Audio-Technica AT8801 single-c hanne l or CP8506 four-channel phantom power supplies.

Out put fro m the mic ropho ne' s XL RM- typ e conn ector is low impedance (Lo-Z) balanced. The signal appears across Pins 2 and 3; Pin 1 is ground (shield). Output phase is ???Pin 2 hot??? ??? positive acoustic pressure produces positive voltage at Pin 2.

To avoid phase cancellation and poor sound, all mic cables must be wired consistently: Pin 1-to-Pin 1, etc.

An integral 80 Hz hi-pass filter provides easy switching from a flat frequency response to a low-end roll-off. The high-pass positio n reduces the microphone's sensitivity to popping in close vocal use. It also reduces the pickup of low-frequency ambient noise (such as tra ffic, air- handling systems, etc.), room reverberatio n and mechanically coupled vibrations.

The AT4053b consists of two modular subassemblies: an AT4900b-48 body and an AT4053b-EL head capsule (both available separately). Additional interchangeable capsules are available in omnidirectional (AT4049b-EL) and cardioid (AT4051b-EL).

Avoid leaving the microphone in the open sun or in areas where temperatures exceed 110?? F (43?? C) for extended periods. Extremely high humidity should also be avoided.

AT4053b SPECIFICATIONS???

???In the interest of standards development, A.T.U.S. offers full details on its test methods to other industry professionals on request.

*1 Pascal = 10 dynes/cm2 = 10 microbars = 94 dB SPL

1 Typical, A-weighted, using Audio Precision System One. Specifications are subject to change without notice.

Rsnopsee in dB

FrequencyinHertz

200 Hz 1 kHz 5 kHz 8 kHz

Audio-TechnicaU.S., Inc., 1221 Commerce Drive, Stow, Ohio 44224

Audio-TechnicaLimited, Old Lane, Leeds LS118AG England

www.audio-technica.com

P52080 ??2008 Audio-Technica U.S., Inc. Printed in U.S.A.