INSTALLATION INSTRUCTIONS

CARE AND MAINTENANCE

Cadet?? 3 Concealed Trapway

Studio?? Concealed Trapway

Right Height??, Elongated Model 2985, 2989, 2794

Right Height??, Round Front Model 2984, 2988, 2795

Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes.

Certi???ed by

IAPMO R&T

!CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!

NOTE: Pictures may not exactly define contour of china and components.

RECOMMENDED TOOLS AND MATERIALS

1REMOVE OLD TOILET

a.Close toilet supply valve and flush tank completely. Towel or sponge remaining water from tank and bowl.

b.Disconnect and remove supply line. NOTE: If replacing valve, first shut off main water supply!

c.Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping sewer gases.

d.Remove closet bolts from flange and clean away old wax, putty, etc. from base area. NOTE: Mounting surface must be clean and level before new toilet is installed!

E U S E

IMPORTANT: Water supply on the wall is required at 2-1/4" or 8" from centerline of the toilet (see rough-in). First suggested position is hidden behind the toilet. The geometry of the toilet gives space for this installation. The second suggested position is next to the toilet. Between these two positions, the space for the supply between wall and toilet is limited to 4-1/2". In this case, check your supply and hose dimensions.

S A V E F O R F U T U R

IMPORTANT: Water supply on the wall is required at 2-1/4" or 8" from centerline of the toilet (see rough-in).

between wall and toilet is limited to 4-1/2". In this case, check your supply and hose dimensions.

6

water supply.

7

!Hand Tighten Only. Do Not Overtighten.

Tighten handles alternately 10 until tank contacts bowl.

HAND TIGHTEN ONLY!

TIP: Place 2 pieces of masking tape on ???oor (as shown) to help with alignment in step 6.

8

* For seat installation, see instructions

included with seat.

! WARNING:

Overtightening of water supply line nuts could result in breakage and potential flooding. If the connection leaks after hand tightening, replace the supply line. Do not use any type of sealant on the water supply connection.

!Use of plumber???s putty, pipe dope, or any other type of sealant will void the warranty.

11

A

Turn on water supply.

B

Adjust water level to level indicated on tank by turning water level adjustment knob to move ???oat cup up or down.

C

Trip Lever Rod

Approximate

Water Level

Float Cup

Flush Valve

Chain

Fill Valve

Or Water

Control

Flapper Seal

Flapper

Tank to Bowl Gasket

Water Supply Line

CARE AND CLEANING:

When cleaning your toilet, wash it with mild, soapy water, rinse thoroughly with clear water and dry with a soft cloth.

WARNING: Do not use in-tank cleaners. These products can seriously corrode fittings in the tank. This damage can cause leakage and property damage.

American Standard shall not be responsible or liable for any damage caused by the use of in-tank cleaners.

www.americanstandard.com