I
CHEST FREEZER
Models EH12OC
and EH15OC
ers. Freezers,
I
CHEST FREEZER
Models EH12OC
and EH15OC
ers. Freezers,
Please read this Use and Care Guide
before you do anything else...
This booklet tells you how to start your freezer, defrost it, clean it and adjust controls.
Treat your new freezer with care. Use it only to do what home freezers are designed to do.
Parts and features
Key Eject
lock
Basket
Temperature
control
Model and Serial
Number Plate
Defrost Water Dral
and Drain Cover
Copy your Model and Serial Numbers here...
When you need service, or call with a question, have this information ready:
1.Complete Model and Serial Numbers [from the plate located as shown).
2.Purchase date from sales slip.
Copy this information in these spaces. Keep this book, your warranty and sales slip together in a handy place. There is no warranty registration to re- turn.
Model Number
Serial Number
Purchase Date
Service Company and Telephone Number
2
Plug ltln ........................
USING YOUR FREEZER.............
Setting the Temperature Control ...
Adjusting the Temperature Control
Cooling Freezer First .............
The Sliding Basket ...............
The Key Eject Lock ...............
Energy Saving Tips ...............
01985 Whirlpool Corporation
Before you plug it in
IMPORTANT
l is installed and levelled on a floorthat will hold the l weight, and in an area suitable for its size and use.
l is not near an oven, radiator or other heat source.
is properly maintained. is out of the weather.
is used in an area where the room temperature will not exceed 110??F (43.3%).
is not run where there are explosive fumes.
is not used by those who may not understand how it should be used.
is not loaded with food before it has time to get properly cold.
Install properly..
Allow room to open lid
/;inches 3inchesfr
I, Check the strength of the floor. It should hold the weight of a fully loaded freezer.
2.Pick a safe place, indoors, away from in- ftammabies such as gasoline.
3.Allow at least 3 inches (7.5 cm) air space on all sides of freezer and 2 inches (5 cm] at back. Leave roam at top for lid to open all the way.
4.It should not be necessary to remove the lid during installation. If, for any reason, the hinges need ad- justment, see your authorized WHIRLPOOL dealer.
5.Do not cover the freezer with items such as blank&s, sheets, tablecloths, etc.
Remove sales labels...
Remove the Consumer Buy Guide label and any inside labels before using the freezer
To remove any remaining glue:
1.Rub briskly with thumb to make a ball, then remove.
OR
2.Soak area with dishwashing detergent solution (1 teaspoon detergent in 1 quart warm water) be- fore removing glue as described in step 1.
DO NOT USErubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car- bon tetrachioride, etc. These can damage the material.
NOTE: DO NOT REMOVEthe Care b Service label on inslde ild or Tech Sheet on back of cabinet.
Clean it ...
Clean your freezer befo using it. See cleaning instructions on page 6.
Level chest freezel;..
from end to end and front to back so that the lid will seal properly
Check with level
Install defrost drain covel;..
I. Remove cover from literature package.
2.Check drawing on front cover for placement.
3.Install cover
Plug- it in...
Recommended Grounding Method
A 115 Volt, 60 Hz.. AC only 15 or 20 ampere fused and properly grounded electrical supply is required. It is recommended that a separate circuit serving only this appliance be provided. Use a receptacle which cannot be turned off wtth a swlfch or pull chain. Do not use an exfenslon cord.
Attach retaining clip over power cord plug from literature package inside the freezer.
4
Using your freezer ,:
Setting the temperature control...
I.Insert a coin in the slot of the Temperature Control to turn it.
2.Turn COntrOl to Number 3. This setting is designed to maintain the temperature at or near 0??F ( - 17.8???C) under normal operating conditions.
Adjusting the temperature control...
1, Turn control to higher number for colder temper- atures.
2, Turn to lower number for less cold temperatures.
Cooling freezer first...
I, Allow freezer to cool 6 to 8 hours before filling with
frozen food.
2.Let it cool overnight before adding large amount of unfrozen food.
NOTE: When freezer is first started the compressor will run constantly until the cabinet is cooled. It may take up to 6 to 8 hours or longer, depending on room tem- perature and the number of times the freezer lid is opened.
After the cabinet is cooled the compressor will turn on and off as needed to keep freezer at proper temperature.
The sliding basket...
Can be moved from side to side or removed when loading or unloading food below it.
To remove:
Lift basket out.
To replace:
Lower basket into place.
The key eject lock...
can help reduce the hazard of child entrapment.
To lock or unlock the freezer you must hold the key in the lock while turning. The lock is spring loaded so the key cannot be left in the lock.
If the key is lost, contact your WHIRLPOOL dealer for a replacement. Always give the com- plete model and serial number of your freezer when requesting a replacement key.
l Check lid gasket and level cabinet to ensure a good lid seal. Keeping freezer locked ensures lid closure.
l Keep lid openings to a minimum. Remove several items at one time. Keep contents organized to elimi- nate searching.
l
l
l
Fill to capacity Follow recommended procedures for freezing foods.
Set Temperature Control to provide temperatures around 0??F ( - 17.8???Cj. There is no need to store foods below 0??F.
Do not let frost build up to more than Y4 inch (6 mm) thick.
Cleaning your freezer
This freezer should be cleaned when frost has built up to about Y4 inch (6 mm] thickness. Complete defrosting and cleaning should be done at least once a year
In high humidity areas, a freezer may need more frequent defrosting.
To defrost and clean:
1.Turn Temperature Control to OFF.
2.Unplug Freezer
3.Take out all frozen food and sliding basket.
Note: Wrap frozen foods and packages in several layers of newspaper and cover with a blanket. Food will stay frozen several hours.
4.Remove drain cover by pul(ing out.
5.Insert hose adapter provided into drain outlet.
6.Remove rubber stopper from inside bottom of freezer.
Waxlng is recommended In hlgh humldlty areas. Use a good auto paste wax or an appliance wax on palnted metal surfaces. Do not use on plasflc because lt may damage these parts.
0 Use plastic scraper to remove frost.
lPlace pans of hot water in freezer with lid open to speed melting. Directing air from an electric fan into freezer will also help.
l Remove defrost water with towel or sponge. l Wash with solution of 2 tablespoons (26 g) baking soda to 1quart (.95 L) warm water
l Rinse and dry
DO NOT USEan Ice pick, knife of other
l Wash with mild detergent and warm water * Rinse and dry.
DO NOT USEcleaning waxes, concentrated detergents, bleaches or cleansers contalnlng petroleum on plastic parts.
6
Freezing food in your freezer
To wrap foods...
/,
When freezer has cooled to a safe storage temperature, it may be loaded with frozen food.
When you plan to freeze unfrozen food, see the following chart for the amount to freeze at
one time.
POUNDS OF FOOD
I TO FREEZEAT ONE TIME???
???These amounts are based on USDA recommen- dations If too many packages of unfrozen food are packed at one time Into the freezer, the rate of freezing 1stoo slow Poor quality products result
Packaging and sealing food ...
Airtight packaging IS important in freezing foods. Containers and wrappings should be moisture and
Freezer burn can result If food is not properly wrapped. When this happens, food dehydrates and is of poor quality.
1.Cut sheet of wrapping material about one- third longer than distance around food to be wrapped. Place wrapping sheet on flat sur- face with food in center of sheet.
2.Bring front and back of wrapping together and fold in toward food, making at least two
3. Crease ends close to food to eliminate air
4.Press all air from package Fold each end over twice Make sure fold is tight and fasten against end of package with freezer tape.
NOTE: When packaglng meats that have not been boned, pad sharp edges with extra wrap or use stockinette to protect against tearing or puncturing.
Use
See booklet, ???How to Preserve Foods the Modern Way with Your WHIRLPOOL Freezer,??? for complete information and tips on home freezing.
71
1.Before freezing large quantities of food, turn Tem- perature Control to highest setting and let freezer operate for several hours. After loading all food items, return Temperature Control to the usual setting.
Packages already frozen
2.To speed freezing, place unfrozen packages near a side wall. Leave space between packages.
3.Add more unfrozen food after first load is frozen (approximately 18 to 24 hours). Stack frozen packages in center of freezer
8
Vacation and moving care
Vacations...
Arrange for someone to make regular checks of your freezer to make sure it isoperating and electricity has not been interrupted.
Shutting off and moving...
If freezer is shut off for more than 24 hours:
1.Remove and store all food.
2.Unplug freezer.
3.Clean thoroughly. See ???Cleaning your freezer,??? page 6.
4.Block lid open for air circulation. Turn lock to locked position with lid open. Place blocks between lid and cabinet and tape in place with
If you move the freezer:
1.Remove the sliding basket.
2.Do not place objects lnrlde or on top of cabinet.
3.Level properly to ensure good lid seal.
CAUTION: To help prevent accidents, do not al- low children near the freezer when the Ild Is blocked open.
To restart freezer, see ???Usingyour freezer,??? page 5.
If you need setice or assistance, we suggest you follow these four steps:
1. Before calling for assistance...
Performance problems often result from little things you can find and fix yourself without tools of any kind.
If electrlclty goes off:
Learn how long power will be off by calling the power company.
lIf service is to be interrupted 24 hours or less, keep freezer closed. Most food will stav frozen.
l If service is to be interrupted longer than 24 hours, do this:
1.Remove all unfrozen food and store in a frozen food locker OR...
2.Place 2 Ibs. (0.9 kg] of dry ice in freezer for every cu. ft. of freezer space. This will keep frozen foods for 2 to 4 days. Wear gloves to protect your hands from dry ice burns.
3.If neither food locker storage or dry ice is avail- able, use or can perishable food at once.
l The length of time food will stay frozen depends on several factors. For instance: a full freezer will remain cold longer than a freezer partially filled. And a freezer full of meat will stay cold longer than a freezer filled with baked goods. Also, if the food still contains ice crystals, it may be safely refrozen, al- though the quality and flavor may be affected. Use this food as soon as convenient. If the condition of the food is poor or is in any way questionable, it is wise to dispose of it.
If freezer stops running:
l Check to see if power cord is plugged into the outlet.
l Check fuse box or circuit breaker
l Check electric company for a power failure. l Be sure Temperature Control is turned ON.
2. lf you need assistance*...
Call Whlrlpool
Continental U.S. . . . . . . . . . . . (800)
and talk with one of our trained Consultants. The Consultant can instruct you in how to obtain satisfac- tory operation from your appliance or, if service is necessary, recommend a qualified service company in your area.
If motor seems to run too long
1.If large amounts of unfrozen food have been put into the freezer, motor will run longer:
2.On hot summer days of if raom is hot. motor will run longer to provide correct amount of cooling.
If freezer feels warm
During normal operating conditions the freezer transfers heat removed from food packages and air space to the outside room air. The freezer cabinet may feel warm.
If ttost builds up on the trim strip around top of cabinet
1.Check the fit of the lid to make sure it is sealing. With the lid closed, press down firmly on the edges or at the center of the lid. This pressure will cause the flexible lid to fit flat against the cabinet and seal.
2.Do not open or close the lid by grasping a corner. Use the handle.
10
3. If you need senic&...
Whirlpool has a na- tionwide network of
-franchised
to fulfill the product
States. To locate
4. If you have a problem*...
Call our
Mr. Stephen E. Upton, SKVice President Whirlpool Corporation
Administrative Center 2000
Benton Harbor, Ml 49022
*If you must call or write, please provide: model number, serial number, date of purchase, and a complete description of the problem. This informa- tion is needed in order to better respond to your request for assistance.
Making your world a little easier.
Part No. 730049
01985 Whirlpool Corpomtion
=
ce Makers, Dishwashers.