COOKING
Designer
Standard Features & Accessories
All models include
Model Options
FINISH DETAILS FOR DERT MODELS ONLY
???Stainless Steel/Black (SB)
o Black glass ceramic tops and knob grips.
???Stainless Steel/White (SW)
o White glass cramic tops with gray knob grips.
???Brass trim option
*Shown throughout with 6???H. backguard. See Installation Notes & Accessories for details.
ORDERING INSTRUCTIONS
First specify model number, and then color code
??? Please see
Installation Notes &
Accessories
for important
installation
information,
including
backguard, high-
shelf, and island
trim.
COOKING
Designer
Dimensions & Specifications
PRODUCT DIMENSIONS
30???W. MODEL
36???W. MODEL
COOKING
Designer
Dimensions & Specifications
CLEARANCE DIMENSIONS
A
30??? 30??? (76.2 cm)
36??? 36??? (91.4 cm)
Minimum clearances from adjacent combustible construction*
???Cooking surface and below, i.e., 36??? (91.4 cm) and below
o
o
o Top grate
???Above cooking surface, i.e., above 36??? (91.4 cm)
o
o Within 6??? (15.2 cm) side clearance, wall cabinets no deeper than 13??? (33.0 cm) must be minimum 18??? (45.7 cm) above cooking surface.
o Wall cabinets directly above product must be minimum 36??? (91.4 cm) for open top burners above cooking surface.
Do not install two or more units
1.This rangetop may be installed directly adjacent to existing 36??? (91.4 cm) high base cabinets. Important: The top grate support must be 3/8??? (0.95 cm) above the adjacent base cabinet countertop.
2.The rangetop cannot be installed directly adjacent to sidewalls, tall cabinets, tall appliances, or other side vertical surfaces above 36??? (91.4 cm) high. There must be a minimum of 6??? (15.2 cm) side clearance from the rangetop to such combustible surfaces above the 36??? (91.4 cm) counter height.
3.Within the 6??? (15.2 cm) side clearance to combustible vertical surfaces above 36??? (91.4 cm), the maximum wall cabinet depth must be 13??? (33.0 cm) and wall cabinets within this 6??? 15.2
cm) side clearance must be 18??? 45.7 cm) above the 36??? (91.4 cm) high countertop.
4.Wall cabinets above the rangetop must be a minimum of 36??? (91.4 cm) above the rangetop cooking surface for the full width of the rangetop. This minimum height requirement does not apply if a rangehood is installed over the cooking surface.
UTILITY
REQUIREMENTS
GAS
??? Not applicable
ELECTRICAL
???Electrical
???Check your national and local codes regarding this unit.
???
???Maximum amp usage???
o DERT 30" o
PLUMBING
Not applicable
COOKING
Designer
Installation Requirements
ACCESS REQUIREMENTS
COOKING
Designer
??? Installation Notes & Accessories
A backguard,
6???H. Backguard
???Stainless Steel (SS)
???Coordinates with all finishes
10???H. Backguard
???Stainless Steel (SS)
???Coordinates with all finishes
???Stainless Steel (SS)
???Coordinates with all finishes
???Shelf comes attached to a 24???H. backguard
Island Trim
???Stainless Steel (SS)
???Coordinates with all finishes
???For island/peninsula installation
???Can replace backguard if wall is
Countertop Side Trim
???Stainless Steel (SS)
???Coordinates with all finishes
???Installs on side of unit; overlaps countertop
???One pair of trim
Compliance Information
WARRANTY INFORMATION*
???
???
???
* For complete warranty see Use & Care Guide. Warranty valid on Viking products shipped within the United States and Canada.