Bracket Installation

1.Remove the screws from each side of the receiver. See Figure 1

RECEIVER (TOP VIEW)

FRONT

FIGURE 1

2.Secure the brackets (not supplied with the WA503 kit) to the sides of the receiver with the screws re- moved in Step 1. See Figure 2.

RECEIVER (TOP VIEW)

FIGURE 2

NOTE: There are four holes in each bracket. Use the rear holes if the re- ceiver is to be recessed; use the front holes to mount it flush to the rack.

WA503 Adapter & Cable Installation

1.Insert the WA503 adapters through the holes in each bracket, and se- cure them from each side, using the attaching hardware. See Figure 3.

2.Connect the supplied antenna cables to the receiver antenna inputs and WA503 adapters. See Figure 4.

RECEIVER (TOP VIEW)

FRONT

FIGURE 4

3.Screw the antennas into the bulk- head adaptors protruding through the front panel. See Figure 5.

RECEIVER (TOP VIEW)

FRONT

FIGURE 5

4.Insert the receiver into the equip- ment rack and secure the brackets to the rack with the supplied screws. See Figure 6.