Model Nos,

233.51345590

233.53245590

233.53345590

Cau_om

Read and follow

all Safety Rulesand Operating InslTuctions

before first use of this

Product.

RANGE

HOOD

???Safety Instructions

???Operation

???Care and Maintenance

???Wiring Diagram

???Warranty

???Parts List

SAFETY INSTRUCTIONS

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR IN-

JURY TO PERSONS, OBSERVE THE FOLLOWING:

1. Use this unit only in the manner intended by the manufac- turer. If you have questions, contact tile manufacturer at the address or telephone number listed in the warranty.

2.Before servicing or cleaning unit, switch power off at ser- vice panel and lock service panel to prevent power from being switched on accidentally.

3.Installation work and electrical wiring must be done by a qualified person(s) in accordance with all applicable codes and standards.

4.Sufficient air is needed for proper combustion and exhaust-

5.When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.

6.Ducted fans must always be vented to tile outdoors.

7.Do not use this unit with any solid state speed control de- vice.

8.To reduce the risk of fire, use only metal duetwork.

9.This unit must be grounded.

TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:

1.Keep fan, filters and grease laden surfaces clean.

2.Always turn hood ON whet) cooking at high heat.

3.Use high range settings on range only when necessary. Heat oil slowly on low to medium setting.

4.Don't leave range unattended when cooking.

5.Always use cookware and utensils appropriate for the type and amount of food being prepared.

TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT

OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:*

1.SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off tile burner. BE CAREFUL TO PRE- VENT BURNS. If the flames do not go out immediately,

EVACUATE AND CALL THE FIRE DEPARTMENT

2.NEVER PICK LIPA FLAMING PAN - You may be burned.

3.DO NOT USE WATER, including wet dishcloths or towels - a violent steam explosion will result.

4.Use an extinguisher ONLY if:

A.You know you have a Class ABC extinguisher and you already know how to operate it.

B.The fire is small and contained in the area where it started.

C.The fire department is being called.

D.You can fight the fire with your back to an exit.

* Based on "Kitchen Firesafety Tips" published by NFPA.

CAUTION

1.For general ventilating use only. Do not use to exhaust haz- ardous or explosive materials and vapors.

2.To avoid motor bearing damage and noisy and/or unbalanced

impellers, keep drywall spray, construction dust, etc. off power unit.

3.For best capture of cooking impurities, your range hood should be mounted 18-24" above the cooking surface.

4.Please read specification label on product for further infor- mation and requirements.

OPERATION

CONTROLS

The fat) and light are each controlled by a rocker switch. Th light switch has two positions, "ON" and _OFF'. The fan switch has three positions - "HIGH", "LOW", and "OFF". ("OFF" is the

middle position.)

CARE AND MAINTENANCE

CLEANING

Always disconnect the electricity from the range hood before servicing. Keep your range hood clean by using a mild deter- gent suitable for painted surfaces. DO NOT USE ABRASIVE CLOTH, STEEL WOOL PADS OR SCOURING POWDERS. The

fan assembly is designed to be easily removed for cleaning. See "Fan Assembly RemovaF below.

Aluminum filters used in vented hoods are dishwasher safe.

Avoid extremely caustic cleaning agents, however. They may discolor the aluminum. Clean filters once a month.

Ventless hoods are equipped with a special ventless filter. Do not wash the filter - its effectiveness will be destroyed. The ventless filter will last up to twelve months with normal use. Replace the filter whenever the blue side becomes noticeably dirty or discolored.

FILTER REPLACEMENT

In ventless hoods, MAKE

SURE THAT THE BLUE Filter

SIDE OF THE FILTER IS

NEXT TO THE FAN WHEN THE FILTER IS INSTALLED.

NOTE: Make sure that the arrows on the filter retaining clip point toward the front and back of the hood.

LIGHT BULB

REPLACEMENT

The light bulb (not supplied with hood) should be 75 Watt maximum. Remove the light lens covering the bulb by pressing the two extending tabs together until they re-

lease from the retaining slots

in the hood.Screws

TO REMOVE FAN ASSEMBLY

Make sure that power is disconnected. Remove filter.

Remove two screws holding motor bracket to range hood. Unplug fan assembly.

Be careful not to allow fan

assembly to drop when screws are removed. Be careful not to bend or

damage the fins on the blade

temperaturerating(105??CThannc_astlcAWM,U,L,Listed)

WARRANTY

FULLTHREEYEARWABRANTY ON PARTS

If within 3 years from the date of installation, any part of this range hood fails to function properly due to a defect in matadal or workmanship, Sears will repair the pad or furnish and install a new pad, free of charge.

FULL 30-DAYWARRANTY ON FINISH ON PAINTED OR BRIGHT

METAL PARTS

If within 30 days from the date of installation, the finish on any painted or bright metal parts of this range hood is defective in matadal or workman- ship, Sears will furnish and install a new part, free of charge,

WARRANTY SERVICE IS AVAILABLE BY CONTACTING THE

NEAREST SEARS SERVICE CENTERIDEPARTMENT IN THE

UNITED STATES,

This warranty applies only while this product is in use in the United States. This warranty gives you specific legal rights and you may have other rights which vary from state to state,

Sears, Roebuck and Ca, Dept 817_/A, Hoffman Estates, I L 60179

PARTS LIST

MODEL 233.51345590

17_4'

16

19 20

21

*Standard Hardware. May be pumhaeed locally.

**Not Illustrated.

12 13

MODELS 233.53245590

23319 20

21

11 13

3

SEARS

OWNER'S

MANUAL

Model Nos. 233.51345590 233.53245590 233.53345590

The model number of

your range hood is found on a label inside the hood.

When requesting

service or ordering

parts, always provide the

following information:

Product Type

Model Number

Part Number

Part Description

_

RANGE

HOOD

For the repair or replacement parts you need

Call 7 am - 7 pro, 7 days a week

1-800-366-PART

(1-800-366-7278)

For in-home major brand repair service

Call 24 hours a day, 7 days a week

1-800-4-REPAIR

(1-800-473-7247)

For the location of a

Sears Repair Service Center in your area

Call 24 hours a day, 7 days a week

1-800-488-1222

For information on purchasing a Sears Maintenance Agreement or to inquire about an existing Agreement

call 9 am - 5 pro, Monday-Saturday

1-800-827-6655

SEARS

Arr_w_'s Re_ir Specialists