Cat. No.
Your Radio Shack
FEATURES
Frequency Response ??? optimized for
and pop noise.
tor ??? for easy connection to your CB or outdoor PA system.
1.Push the tab on the battery com- partment cover in the direction of the arrow, then lift off the cover.
2.Install the batteries as indicated by the polarity symbols (+ and
3.Replace the cover.
When the BATT. LOW indicator lights, re- place the batteries.
Note: The BATT. LOW indicator lights briefly when you release the switch on the microphone???s side.
INSTALLING THE
BATTERIES
You need two AAA batteries (not sup- plied) to power your microphone. We rec- ommend alkaline batteries, such as Cat. No.
??1995 Tandy Corporation. All Rights Reserved.
Radio Shack is a registered trademark used by Tandy Corporation.
MOUNTING THE CLIP
HANGER
You can hang the microphone on your CB???s existing mounting bracket, or use the supplied clip hanger and screws.
To mount the clip hanger, use it as a tem- plate and drill two holes at the desired lo- cations on the vehicle???s dashboard. Then use the supplied screws to mount the clip hanger on the dashboard.
Caution: Be sure not to drill into objects behind the dashboard.
CONNECTING THE
MICROPHONE
Plug your microphone???s
USING THE
MICROPHONE
Push the switch on the microphone???s side to send a transmission. Release the switch to receive.
USING THE AMP
To use the microphone???s internal pream- plifier, set AMP. ON/OFF to ON. Adjust VOL. to vary the output level of the ampli- fier. To turn off the amplifier, set the switch to OFF.
Note: The VOL. setting only affects your transmitting volume and only works with
AMP. ON/OFF set to ON.
2
REWIRING THE MICROPHONE???S DIN PLUG
The following chart shows the function of the pins in the microphone cord???s DIN plug. This information is provided in case you need to rewire the plug to be compatible with CB brands other than Radio Shack, or with various business band, ham, and broadcast trans- ceivers and PA equipment.
Important: Do not cut the microphone???s wires. If you cut any wire, you cannot obtain a refund or exchange on this product. Radio Shack will provide warranty service if you cut a wire and find the product is defective.
.
Caution: If you are unsure about how to rewire the plug, do not risk damaging your equip- ment and possibly violating FCC regulations. Take your microphone, this owner???s manual, and the transmitting device to your local Radio Shack store for service. Only an accurate circuit analysis can ensure proper compatibility between the microphone and the device to which you connect it.
3
SPECIFICATIONS
Specifications are typical; individual units might vary. Specifications are subject to change and improvement without notice.
RADIO SHACK LIMITED WARRANTY
This product is warranted against defects for 90 days from date of purchase from Radio Shack
EXCEPT AS PROVIDED HEREIN, RADIO SHACK MAKES NO EXPRESS WARRAN-
TIES AND ANY IMPLIED WARRANTIES ARE LIMITED IN DURATION TO THE DURA- TION OF THE WRITTEN LIMITED WARRANTIES CONTAINED HEREIN. Some states do not permit limitation or exclusion of implied warranties; therefore, the aforesaid limi- tation(s) or exclusion(s) may not apply to the purchaser.
This warranty gives you specific legal rights and you may also have other rights which vary from state to state.
RADIO SHACK
A Division of Tandy Corporation
Fort Worth, Texas 76102