;22/*\"4GEJCTIGCDNG"9KTGNGUU"5VGTGQ"
*GCFRJQPGU
%106'065
Connecting to an Audio Source . 4
#"+/2146#06"#
If an icon appears at the end of a paragraph, go to the box on the side of that page with the corresponding icon for pertinent information.
R????? Warning
. ??? Caution
Thank you for purchasing RadioShack Rechargeable 900MHz Wireless Stereo Headphones. Your headphones use the 900MHz band to deliver
POWER indicator ???
lights red when the AC adapter is correctly plugged in and you press POWER.
CHARGE Indicator ??? lights green when the batteries are charging.
?? 2002 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks used by RadioShack Corporation.
Location a Choosing
."%#76+10".
???You must use a Class 2 power source that supplies 12 volts DC and delivers at least 250mA. Its center tip must be set to positive and its plug must fit the transmitter's DC IN 12V jack. The supplied adapter meets these specifications. Using an adapter that does not meet these specifications could damage the transmitter or the adapter.
???Always connect the AC adapter to the transmitter before you connect it to AC power. When you finish, disconnect the adapter from AC power before you disconnect it from the transmitter.
???Use only fresh batteries of the required size and recommended type.
???Do not mix old and new batteries, different types of batteries (standard, alkaline, or rechargeable), or rechargeable batteries of different capacities.
???If you do not plan to use the headphones for a week or longer, remove the batteries. Batteries can leak chemicals that can destroy electronic parts.
%*115+0)"#".1%#6+10
Many factors affect the range of your system. To achieve the best performance:
???Position the transmitter as far as possible from other electronic devices such as TVs, receivers, or VCRs. Radio interference from these devices could affect your system???s performance.
???Position the transmitter away from large metal objects, as these could block your transmitter???s signals.
???Try several locations for the transmitter. Select the location that provides the best performance.
Your system???s overall performance depends on your home???s construction method, the other devices near the system, and other radio frequency sources in your home (such as cordless telephones).
75+0)"#%"219'4
Use the supplied 12V, 250mA AC adapter to connect the transmitter to AC power.
Plug the supplied AC adapter???s barrel plug into the transmitter???s DC IN 12V jack, then plug the adapter into a standard AC outlet. .
+056#..+0)"$#66'4+'5"
Your headphones require three AAA alkaline batteries or rechargeable batteries (neither supplied) for power. .
1. Remove the battery
2.If you are using
alkaline batteries, set ALK/RCH inside the compartment to ALK.
If you are using rechargeable batteries, set ALK/RCH to
RCH.
3.Place the batteries in the compartment according to the polarity symbols (+ and
4.Slide the cover back on until it clicks into place.
2
If the headphones??? range decreases, you do not hear sound from the audio source, or the headphones??? POWER/BATT LOW indicator is blinking, replace the alkaline batteries or recharge the rechargeable batteries. R??
%*#4)+0)"4'%*#4)'#$.'" $#66'4+'5
Your transmitter has a
1.Turn off the headphones and remove the battery compartment cover on the left earpiece. #"
2.Select ALK/RCH to RCH.
3.Place the rechargeable batteries in the compartment according to the polarity symbols (+ and
4.Replace the cover.
5.Lift the charging compartment cover on the back of transmitter to open and pull out the charging cord. .#
DC IN 4.5V
Charging
Cord
Red
6.Plug the charging barrel plug into the DC IN 4.5V jack on the left earpiece.
R"9#40+0)??R"
Dispose of old batteries promptly and properly. Do not burn or bury them.
#"+/2146#06"#
You can only charge rechargeable batteries. Do not attempt to charge alkaline batteries.
."%#76+10".
The charging compartment cover on the transmitter is hinged. Do not attempt to remove it.
Charging Rechargeable Batteries
3
Source Audio an to Connecting
."%#76+10".
Do not connect the transmitter to your audio source???s speaker output. Doing so could damage the transmitter and audio source.
7.The batteries automatically begin charging and the transmitter???s CHARGE indicator lights green.
Before using your headphones for the first time, you must charge the batteries for at least 24 hours. When the batteries have been completely discharged, it takes about 12 hours to completely recharge the batteries.
When charging is complete, unplug the charge cord. The CHARGE indicator turns off.
4'%;%.+0)"0+/%&"$#66'4+'5
The EPA certified RBRC??Battery Recycling Seal on the
in an industry program to collect and recycle these batteries at the end of their useful life, when taken out of service in the United States or Canada. The RBRC program provides a convenient alternative to placing used
%100'%6+0)"61"#0"#7&+1" 5174%'
You can connect the transmitter to your audio source???s left and right audio output jacks or the headphone jack. .
1.Connect one end of the supplied audio patch cord to the transmitter???s audio jacks (white plug to L AUDIO IN and red plug to R AUDIO IN).
2.If you are using the audio source???s output jacks, connect the white and red plugs at the other end of the patch cord directly to the audio source???s corresponding left (white) and right (red) audio jacks.
If you are using your audio source???s stereo headphone jack, connect the patch cord???s white and red plugs to the white and red phono jacks on the Phono to
3.If your audio source has a
4
If your audio source has a
.+56'0+0)"5#('.;
To protect your hearing, follow these guidelines when you use your headphones.
???Set the volume to the lowest setting before you begin listening. After you begin listening, adjust the volume to a comfortable level.
???Do not listen at extremely high volume levels. Extended
???Once you set the volume, do not increase it. Over time, your ears adapt to the volume level, so a volume level that does not cause discomfort might still damage your hearing.
75+0)";174"*'#&2*10'5
You can use multiple sets of headphones with each transmitter. We do not recommend using multiple transmitters in the same area.
1.Press POWER on the transmitter. The transmitter???s POWER indicator lights red. Turn on the audio source.
2.To turn on the headphones, slide POWER away from the headband. The POWER/BATT LOW indicator lights red.
3.Put on the headphones and adjust VOLUME to the desired listening level.
4.To turn off the headphones, slide POWER toward the headband.
5.To turn off the transmitter, press the power switch. The POWER indicator turns off.
??"016'"??"
???If the POWER/BATT LOW indicator is blinking, the battery level is low and you must replace the alkaline batteries or recharge the rechargeable batteries before use.
???If you connected the transmitter to an audio source???s headphone jack, set the audio source???s volume control to its mid- position, then adjust VOLUME on the headphones to the desired level.
???To preserve battery life, be sure to turn off the headphones when you are not using them.
???If reception is poor even when the batteries are fully charged and you are near the transmitter, try moving the transmitter to a higher location or moving it away from the audio source.
???If you are not using the transmitter, disconnect the adapter.
???Turn off the headphones before turning off the transmitter.
Using Your Headphones
5
Troubleshooting
6417$.'5*116+0)
We do not expect you to have problems with your headphones, but if you do, these suggestions might help.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
???Reorient or relocate the receiving antenna.
???Increase the separation between the equipment and receiver.
???Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
???Consult your local RadioShack store or an experienced radio/TV technician for help.
???If you cannot eliminate the interference, the FCC requires that you stop using your headphones.
6
Changes or modifications not expressly approved by RadioShack may cause interference and void the user???s authority to operate the equipment.
%#4'
Keep the headphones dry; if they get wet, wipe them dry immediately. Use and store the headphones only in normal temperature environments. Handle the headphones carefully; do not drop them. Keep the headphones away from dust and dirt, and wipe them with a damp cloth occasionally to keep them looking new.
5'48+%'"#0&"4'2#+4
If your headphones are not performing as they should, take them to your local RadioShack store for assistance. Modifying or tampering with the headphones??? internal components can cause a malfunction and might invalidate their warranty.
52'%+(+%#6+105
Specifications are typical; individual units might vary. Specifications are subject to change and improvement without notice.
Limited
This product is warranted by RadioShack against manufacturing defects in material and workmanship under normal use for ninety (90) days from the date of purchase from RadioShack
MAKES NO EXPRESS WARRANTIES AND
ANY IMPLIED WARRANTIES, INCLUDING
THOSE OF MERCHANTABILITY AND FIT-
NESS FOR A PARTICULAR PURPOSE, ARE
LIMITED IN DURATION TO THE DURATION
OF THE WRITTEN LIMITED WARRANTIES
CONTAINED HEREIN. EXCEPT AS PRO- VIDED HEREIN, RadioShack SHALL HAVE
NO LIABILITY OR RESPONSIBILITY TO CUS-
TOMER OR ANY OTHER PERSON OR EN-
TITY WITH RESPECT TO ANY LIABILITY,
LOSS OR DAMAGE CAUSED DIRECTLY OR
INDIRECTLY BY USE OR PERFORMANCE
OF THE PRODUCT OR ARISING OUT OF
ANY BREACH OF THIS WARRANTY, IN-
CLUDING, BUT NOT LIMITED TO, ANY DAM-
AGES RESULTING FROM INCONVENIENCE,
LOSS OF TIME, DATA, PROPERTY, REVE-
NUE, OR PROFIT OR ANY INDIRECT, SPE-
CIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, EVEN IF RadioShack HAS BEEN
ADVISED OF THE POSSIBILITY OF SUCH
DAMAGES.
Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential dam- ages, so the above limitations or exclusions may not apply to you.
In the event of a product defect during the war- ranty period, take the product and the RadioShack sales receipt as proof of purchase date to any RadioShack store. RadioShack will, at its option, unless otherwise provided by law:
(a)correct the defect by product repair without charge for parts and labor; (b) replace the prod- uct with one of the same or similar design; or
(c)refund the purchase price. All replaced parts and products, and products on which a refund is made, become the property of RadioShack. New or reconditioned parts and products may be used in the performance of warranty service. Repaired or replaced parts and products are warranted for the remainder of the original war- ranty period. You will be charged for repair or replacement of the product made after the expi- ration of the warranty period.
This warranty does not cover: (a) damage or failure caused by or attributable to acts of God, abuse, accident, misuse, improper or abnormal usage, failure to follow instructions, improper installation or maintenance, alteration, lightning or other incidence of excess voltage or current;
(b)any repairs other than those provided by a RadioShack Authorized Service Facility; (c) consumables such as fuses or batteries; (d) cosmetic damage; (e) transportation, shipping or insurance costs; or (f) costs of product re- moval, installation,
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
RadioShack Customer Relations, 200 Taylor Street, 6th Floor, Fort Worth, TX 76102
12/99
7
2#465"#0&"#%%'5514+'5
Parts and accessories are available at your local RadioShack store. Accessories are also available online at www.radioshack.com. Parts and accessories are available but not limited to the following. Visit your local RadioShack store or obtain a RadioShack catalog for a more complete listing of available accessories.
#%%'5514+'5
Tired of the
batteries dying right in the middle of your favorite song? RadioShack???s wide variety of
rechargeable batteries let
you control the power to your headphones so your favorite music is never interrupted again.
So you and your
roommate can both enjoy the same music in different locations, RadioShack
offers a complete line of additional
wireless headphones for
your wireless headphone system.