7" WIDE SCREEN 16:9 TFT-LCD MONITOR

PLVSHR77

1

3. INSTALLATION

1.Rotate the locking knob on the neck of the mounting stand clockwise.

2.Slide the engagement head on the mounting stand into the slide bracket slot on the rear of the monitor housing.

3.Rotate the locking knob counterclockwise until it is hand-tight and the monitor is securely fastened to the neck of the mounting stand.

4.Locate a desirable spot in your vehicle for the monitor. Hold it place there, with the mounting plate resting in approximately the right location and have a friend sit in the seat from which you intend viewing of this monitor to take place to confirm the location of the monitor. If necessary, loosen the angle adjustment knob and rotate the monitor to a more ideal angle and retighten.,

5.Once you have confirmed the location of the monitor, remove the adhesive backing from the underside of the mounting plate and firmly press all the "petals" of the mounting plate down to the car surface. Temporarily remove the monitor by loosening the locking knob, and use three screws in the locations indicated in the drawing below to further secure the monitor mounting plate. If necessary, drill pilot holes to assist in inserting the screws.

6.Reinstall the monitor onto the neck of the mounting stand and tighten the locking knob. Adjust the monitor angle again as required, being sure to tighten the angle adjustment knob when you are done.

2

4.Function:

4.1Features

7.AV-IN Jack

4.2Remote Control Bar

TV/CATV TV/AV MUTE POWER

To adjust functions of Monitor, use only 5keys:

1 2 3 4

POWER

MUTE

Power: Press the Power button for ON/OFF

Mute: To shutdownAudio output

DOWN

Function: Press the Function button to access On Screen Display Menu of: CONTRAST / BRIGHTNESS /

COLOR / SHARPNESS / SOURCE IN /

VOLUME / MODE / LEFT RIGHT

/ RECALL / EXIT

UP+: To Adjust Volume Up

DN-: To Adjust Volume Down

MODE: Selection button forAV1 / AV2

3

4.3 FUNCTION KEYS AT FRONT PANEL

1. MENU FUNCTIONS

1.POWER

Press the POWER button once it will be power ON. Press it again. The will be power OFF.

2.UP / DOWN

Press "UP+" or "DN--"directly is to adjust volume. Using MENU button together can adjust the other functions.

4

5. Installation for Monitor

Note

It is recommended that the fitting is carried out at a specialist workshop.

5

6.ACCESSORIES

(1)Monitor Stand x 1

(2)System Cable x 1

(3)Operation Manual x1

(4)Release Key x1

(5)Remote Controller x 1

(6)Warranty Card x 1

7.Specifications

The specifications are subject to change without prior notice.

7