to the base of the speakers.
Connect each speaker to the receiver using the
To connect, insert the colored wire into the matching positive (colored) terminal and the other wire into the negative (black) terminal as shown
below. Connect the speakers the same way (matching the wire to the
Note that the
Note
When??? disposing of used batteries, please comply with governmental and/or environmental regulations that apply in your country or area.
Do??? not use or store batteries in direct sunlight or other excessively hot places, such as inside a car or near a heater. This can cause batteries to leak, overheat, explode or catch fire. It can also reduce the life or performance of batteries.
Stick the
Twist and pull off the protective shields on
each wire.color-coded wire
Receiver
Listening position
Subwoofer
Front left
Front right
Center
Connect the FM wire antenna and fully extend along a window 1 frame or another suitable place that receives good reception.
jack.
shut as shown below.
AM loop antenna
jack on the receiverAUDIOtoTVtheINaudio output on your
TV.* This will allow you to listen to your TV through this speaker system.
* Note that you must also connect the DVD player/recorder???s video output to your TV???s video input to watch a DVD video (video cable is not supplied).
STANDBY/ON
PHONES
AUDIO
MULTI JOG
ENTER
MASTER
VOLUME
FRONT
AUDIO INPUT
DVD player/recorder, then you ready to start enjoying your home theater system.
s??? operating instructionsReferfortoa thedetailedreceiver
s??? surround sound features.explanation of this system
Receiver
FM wire antenna
Receiver
OPT
CD
S R
FRONT
??? STANDBY/ON
DVD player/ recorder (Not supplied)
For detailed instructions, see the Operating Instructions supplied and/or contact one of our knowledgeable Pioneer Customer Service Representatives at
Setting Up Your
Wall mounting the speakers
Refer to the following diagram when making system connections for a full surround sound setup. Note that the TV, DVD player/recorder and some accessories are not included. Refer to the reverse side of this sheet to check what???s supplied with the
Using the front panel audio input
Use the supplied
The front, center and surrond speakers has a mounting hole which can be used to mount the speaker on the wall.
Mounting screw (not supplied)
5 mm (3/16 in.)
10 mm (3/8 in.)
5 mm to 7 mm (3/16 in. to 1/4 in.)
(Not supplied)
AUDIO
STANDBY/ON
Mini plug audio cable
(see above), keepBeforein mindmountingthe following points:
??? Remember that the speaker system is heavy and that its weight could cause the screws to work loose, or the wall material to fail to support it, resulting in the speaker falling. Make sure that the wall you intend to mount the speakers on is strong enough to support them. Do not mount on plywood or soft surface walls.
??? Mounting screws are not supplied. Use screws that are suitable for the wall material and can support the weight of the speaker.
menu
Caution
???If you are unsure of the qualities and strength of the walls, consult a professional for advice.
???Pioneer is not responsible for any accidents or damage that result from improper installation.
???Do not hang the subwoofer on the wall or from the ceiling as they might fall and cause injury.
???When placing this unit, ensure that it is firmly secured and avoid areas where it may be likely to fall and cause injuly in the event of a natural disaster (such as an earthquake).
For more information about speaker installation, please see the instructions that come with the speakers.
Not supplied
TV
The illustration above shows the connection for a DVD player (the DVD/LD jack). Connect to the DVR jack when connecting a DVD recorder.
???+
(Purple)
(Blue)
Surround L.
??? +
(Grey)
Surround R.
??? +
For detailed instructions, see the Operating Instructions supplied and/or contact one of our knowledgeable Pioneer Customer Service Representatives at