2.4GHz Expandable Cordless Handset
Model No. KX-TGA271W/KX-TGA271V
Installation Manual
PLEASE READ BEFORE USE AND SAVE.
KX-TGA271W/KX-TGA271V is the optional cordless handset for the KX-TG2700/KX-TG2720/KX-TG2730/KX-TG2740.
This installation manual only describes the steps necessary to start up the handset. Please read the KX-TG2700/KX-TG2720/KX-TG2730/KX-TG2740 operating instructions for further details.
Installation!
Connecting the Charger unit
Power Outlet
(AC 120 V, 60 Hz)
AC Adaptor
???USE ONLY WITH Panasonic AC ADAPTOR KX-TCA1 (Order No. KX-TCA1-G).
???The AC adaptor must remain connected at all times. (It is normal for the adaptor to feel warm during use.)
Installing the battery
Insert the battery into the handset as shown, matching the correct polarity (#). Press the battery down until it places into the compartment ($). Close the cover.
2
1
For assistance, please call: 1-800-211-PANA(7262)
Charging the battery
Place the handset on the charger and charge for about 15 hours before initial use.
???The CHARGE indicator lights, a beep sounds and ???Charging??? will be displayed.
??????Recharge battery??? is displayed,
?????? 
??? flashes on the display, or
???the handset beeps intermittently while it is in use.
??? If the battery has been discharged, the handset will display ???Charge for 15HRS??? and ???
??? when you place the handset on the charger. The handset will not work. Keep charging.
Handset battery information
After your Panasonic battery is fully charged:
When using the 2-Way Radio mode with the battery fully charged:
???Clean the charge contacts of the handset and the charger with a soft, dry cloth once a month. Clean more often if the unit is subject to grease, dust or high humidity. Otherwise the battery may not charge properly.
Belt Clip!
You can hang the handset on your belt or pocket using the belt clip.
While pressing the top of the clip (A), pull the right edge in the direction of the arrow (B).
A 
B
Registration!
This cordless handset must be registered at the KX-TG2700/KX-TG2720/ KX-TG2730/KX-TG2740 base unit. The handset will be assigned the extension number at registration. Only one handset can be registered at a time.
Make sure the base unit and the other handsets are not being used. Registration must be completed within 1 minute.
[-] Press MUTE on base unit, then OK on handset to register handset
O K
Soft key (
(MUTE) Button and
Indicator
???The illustration of the base unit is the KX-TG2730.
The handset display shows the instructions as shown on the right.
OK )
SP PRIVACY 
[-]
Press MUTE on base unit, then OK on handset to register handset
O K
2 Handset:
#Press the right soft key ( OK ).
$Wait until a long beep sounds and the display shows the registered number. The registration will be then complete.
SP PRIVACY 
[-]
Handset
Registering
Ex. Extension number 2
SP PRIVACY 
[2]
Handset [2]
Registered
???The registered number ???[1]??? to ???[8]??? is shown on the top right of the display.
???You can stop registration by pressing (OFF) on the handset and pressing (MUTE) on the base unit.
To cancel the handset registration, please see the KX-TG2700/KX-TG2720/ KX-TG2730/KX-TG2740 Operating Instructions.
For assistance, please call: 1-800-211-PANA(7262)
??? 3 ???
Optional Headset!
Plugging an optional headset into the handset allows a hands-free phone conversation. Please use only the Panasonic KX-TCA88 headset.
To order, call the accessories telephone number on page 1.
Connecting the headset
Open the headset jack cover, and connect the headset to the headset jack as shown.
Headset Jack
H
Wall Mounting!
The charger can be wall mounted. Connect the AC adaptor. Install screws using the wall template below. Mount the charger (#). Slide it down ($) then slide down to the right (%) until it is secured.
6.15 cm (2 13???32") 
Wall Template
FCC and Other Information!
When programming emergency numbers and/or making test calls to emergency numbers:
1.Remain on the line and briefly explain to the dispatcher the reason for the call before hanging up.
2.Perform such activities in the off-peak hours, such as early morning hours or late evenings.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Privacy of communications may not be ensured when using this phone.
CAUTION:
Any changes or modifications not expressly approved by the party responsible for compliance could void the user???s authority to operate this device.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
???Reorient or relocate the receiving antenna.
???Increase the separation between the equipment and receiver.
???Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
???Consult the dealer or an experienced radio/TV technician for help.
Operating near 2.4GHz electrical appliances may cause interference. Move away from the electrical appliances.
CAUTION:
To comply with FCC RF exposure requirements, the handset should be carried with the specific belt-clip provided for the handset to ensure compliance. Other non-tested belt- clips or similar body-worn accessories may not comply, therefore, should be avoided.
This equipment is hearing aid compatible as defined by the FCC in 47 CFR Section 68.316.
When you hold the phone to your ear, noise might be heard in your Hearing Aid. Some Hearing Aids are not adequately shielded from external RF (radio frequency) energy. If noise occurs, use an optional headset accessory or the speakerphone option (if applicable) when using this phone. Consult with your audiologist or Hearing Aid manufacturer about the availability of Hearing Aids which provide adequate shielding to RF energy commonly emitted by digital devices.
For assistance, please call: 1-800-211-PANA(7262)
??? 5 ???
CAUTION:
To reduce the risk of fire or injury to persons, read and follow these instructions.
1.Use only the battery(ies) specified.
2.Do not dispose of the battery(ies) in a fire. They may explode. Check with local waste management codes for special disposal instructions.
3.Do not open or mutilate the battery(ies). Released electrolyte is corrosive and may cause burns or injury to the eyes or skin. The electrolyte may be toxic if swallowed.
4.Exercise care in handling batteries in order not to short the battery to conductive materials such as rings, bracelets, and keys. The battery and/or conductor may overheat and cause burns.
5.Charge the battery(ies) provided with or identified for use with this product only in accordance with the instructions and limitations specified in this manual.
A nickel metal hydride battery that is recyclable powers the product you have purchased. Please call 1-800-8-BATTERY for information on how to recycle this battery.
WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS PRODUCT
TO RAIN OR ANY TYPE OF MOISTURE.
If you need assistance with the set-up or operation, please call 1-800-211-PANA(7262)
Panasonic World Wide Web address: http://www.panasonic.com for customers in the USA or Puerto Rico
Panasonic???s e-mail address for customer inquiries: consumerproducts@panasonic.com
Panasonic Consumer Electronics Company,
Division of Matsushita Electric Corporation of America
One Panasonic Way, Secaucus, New Jersey 07094
Panasonic Sales Company,
Division of Matsushita Electric of Puerto Rico, Inc.
Ave. 65 de Infanter??a, Km. 9.5, San Gabriel Industrial Park
Carolina, Puerto Rico 00985
Unidad port??til inal??mbrica de 2.4 GHz ampliable
Modelo KX-TGA271W/KX-TGA271V
Manual de instalaci??n
LEA ESTAS INSTRUCCIONES ANTES DE LA UTILIZACI??N Y
GU??RDELAS.
La KX-TGA271W/KX-TGA271V es una unidad port??til opcional para el KX-TG2700/KX-TG2720/KX-TG2730/KX-TG2740.
Este manual de instalaci??n describe ??nicamente los pasos necesarios para iniciar el funcionamiento de la unidad port??til. Lea las instrucciones de funcionamiento del KX-TG2700/KX-TG2720/KX-TG2730/KX-TG2740 para obtener m??s detalles.
Accesorios (incluidos)
Para solicitar accesorios extra, llame al 1-800-332-5368.
Instalaci??n!
Conexi??n de la unidad de carga
Tomacorriente (CA 120 V, 60 Hz)
Adaptador de CA
???UTIL??CELA SOLAMENTE CON EL ADAPTADOR DE CA KX-TCA1 de Panasonic (N.?? de pedido KX-TCA1-G).
???El adaptador de CA deber?? permanecer conectado en todo momento. (Durante la utilizaci??n es normal que se caliente el adaptador.)
Instalaci??n de la bater??a
Inserte la bater??a en la unidad port??til como se muestra ajustando en la polaridad correcta (#). Presione la bater??a hacia abajo hasta encajarla en el compartimiento ($). Cierre la cubierta.
2
1
??? (1) ???
Carga de la bater??a
Ponga la unidad port??til en el cargador y c??rguela durante 15 horas aproximadamente antes de utilizarla por primera vez.
??? El indicador CHARGE se encender??, sonar?? un pitido y se visualizar?? ???Charging???.
??????
??? parpadee en la pantalla, o
???la unidad port??til emita pitidos intermitentemente mientras se utiliza.
??? Si la bater??a se ha descargado, la unidad port??til visualizar?? ???Charge for 15HRS??? y ???
??? cuando la ponga en el cargador. La unidad port??til no funcionar??. Deje que se cargue.
Informaci??n acerca de la bater??a de la unidad port??til
Despu??s de que su bater??a Panasonic est?? completamente cargada:
Cuando se utiliza el modo de radio en 2 sentidos con la bater??a completamente cargada:
???Limpie los contactos de carga de la unidad port??til y del cargador con un pa??o suave y seco una vez al mes. Limpie m??s a menudo si la unidad est?? expuesta a la grasa, polvo o humedad alta. De lo contrario, la bater??a tal vez no se cargue correctamente.
Utilizaci??n de la presilla para cintur??n
Podr?? colgar la unidad port??til en su cintur??n o bolsillo utilizando la presilla para
Mientras presiona la parte superior de la presilla (A), tire del borde derecho en el sentido de la flecha (B).
A 
B
Registro!
Esta unidad port??til deber?? ser registrada en la unidad base KX-TG2700/ KX-TG2720/KX-TG2730/KX-TG2740. El n??mero de extensi??n de la unidad port??til ser?? asignado al hacer el registro.
Solamente podr?? registrarse una unidad port??til cada vez.
Aseg??rese de que la unidad base y las otras unidades port??tiles no est??n siendo utilizadas. El registro deber?? completarse antes de 1 minuto.
[-] Press MUTE on base unit, then OK on handset to register handset
O K
Tecla blanda ( OK )
(MUTE) bot??n e indicador
???La ilustraci??n de la unidad base es del KX-TG2730.
El visualizador de la unidad port??til muestra las instrucciones como se muestra a la derecha.
$Espere hasta que suene un pitido largo y el visualizador muestre el n??mero registrado. Entonces se habr?? completado el registro.
SP PRIVACY 
[-]
Press MUTE on base unit, then OK on handset to register handset
O K
SP PRIVACY 
[-]
Handset
Registering
Ej., N??mero de extensi??n 2
SP PRIVACY 
[2]
Handset [2]
Registered
???El n??mero de registro ???[1]??? a ???[8]??? se mostrar?? en la parte superior derecha del
visualizador.
???Podr?? parar el registro presionando (OFF) en la unidad port??til y presionando (MUTE) en la unidad base.
Para cancelar el registro de la unidad port??til, consulte las instrucciones de funcionamiento del KX-TG2700/KX-TG2720/KX-TG2730/KX-TG2740.
Auricular opcional!
Enchufando un auricular opcional a la unidad port??til le podr?? conversar por tel??fono con las manos libres. Utilice solamente el auricular Panasonic KX-TCA88. Para hacer el pedido, llame al n??mero de tel??fono para accesorios de la p??gina 1.
Conexi??n del auricular
Abra la tapa de la toma para auricular y conecte el auricular a la toma para auricular como se muestra.
Toma para auricular
H
Montaje en pared!
El cargador puede montarse en una pared. Conecte el adaptador de CA. Instale los tornillos utilizando la plantilla para pared de abajo. Monte el cargador (#). Desl??celo hacia abajo ($) y despu??s hacia abajo y hacia la derecha (%) hasta fijarlo en su sitio.
PLANTILLA PARA PARED
