95Si Stairclimber

Assembly Instructions

Congratulations...

and welcome to the world of

The following Parts Identification Listing and the step by step assembly procedures have been assembled to make the set-up of the Stairclimber as quick and easy as possible.

Please take special note of the following important points prior to choosing a location and beginning assembly of the Stairclimber.

IMPORTANT SAFETY INSTRUCTIONS!

???DO NOT locate the Stairclimber outdoors, near swimming pools, or in areas of high humidity.

???DO NOT operate your Stairclimber if it has been dropped, damaged, or even partially immersed in

water. If this occurs, contact Life Fitness Customer Support Services at the number in the Operation Manual.

???DO NOT locate the Stairclimber any closer than 30 inches ( 76 cm ) to a television set.

???DO NOT locate additional Stairclimbers any closer than a minimum of 42 inches (107 cm) from

center to center to avoid interference (cross talk) between Heart Rate monitors.

???DO keep the area around your Stairclimber clear of any obstructions, including walls and furniture.

???DO verify the contents of the delivery carton against the accompanying Parts Listing prior to setting

the cartons and shipping material aside. If any parts are missing, contact Life Fitness Customer Support Services at the number listed in the Operation Manual. Save the shipping cartons in case of return.

??? DO read the entire Operation Manual prior to attempting to operate this machine as this is essential for proper use.

CONSIGNES DE SECURITE IMPORTANTES!

???NE placez PAS l'appareil ?? l'ext??rieur, pr??s d'une piscine ou dans un endroit tr??s humide.

???NE faites PAS fonctionner l'appareil s'il est tomb??, s'il a ??t?? endommag?? ou s'il a ??t?? partiellement

plong?? dans l'eau. Si cela s'est produit, contactez le service apr??s-vente de Life Fitness au num??ro fourni dans le manuel d'utilisation.

???NE placez PAS l'appareil ?? moins de 76 cm d'un poste de t??l??vision

???NE placez PAS d'autres appareils du m??me type ?? proximit??. Un espace d'au moins 107 cm doit

??tre observ?? entre les parties centrales de deux appareils afin d'??viter les interf??rences entre les contr??leurs de rythme cardiaque.

??? MAINTENEZ la zone autour de l'appareil libre de toute obstruction, y compris murs et meubles. Veillez ?? laisser un d??gagement d'au moins 30 cm devant l'appareil.

??? V??RIFIEZ si l'emballage contient toutes les pi??ces de la liste jointe avant de le mettre de c??t??. Si des pi??ces sont absentes, contactez le service apr??s-vente de Life Fitness au num??ro indiqu??

dans le manuel d'utilisation. Conservez l'emballage au cas o?? vous devriez renvoyer l'appareil.

??? LISEZ le manuel de l'utilisateur tout entier avant d'essayer de faire fonctionner cet appareil. Ceci est indispensable ?? son utilisation correcte.

TOOLS REQUIRED FOR ASSEMBLY... Phillips Screwdriver, T27 Torx Wrench, Socket Set

PARTS DESCRIPTION

1.Before proceeding, familiarize yourself with the parts of the Stairclimber and make sure that you have received all the items described in the Parts List.

2.Locate the MONOCOLUMN (#10). Position the MONOCOLUMN SHROUD (#21) onto the MONOCOLUMN as shown. Position the MONOCOLUMN near the MONOCOLUMN MOUNTING BRACKET (B) as shown. Detach and feed the CONSOLE WIRE HARNESS (C) through the MONOCOLUMN and out through the

DISPLAY CONSOLE MOUNTING BRACKET (D) ACCESS HOLE. Pivot the MONOCOLUMN upright and position the locating slot at the bottom of the MONOCOLUMN onto the pre- installed LOCATING BOLT (E) on the MONOCOLUMN MOUNTING BRACKET. Align the mounting holes of the MONOCOLUMN and MONOCOLUMN MOUNTING BRACKET and secure them together using two MOUNTING BOLTS (#1) and LOCKNUTS (#2). Leave the BOLTS and NUTS loose at this time. Lower the MONOCOLUMN SHROUD until it rests on the

MAIN SHROUDS.

CAUTION: BE CAREFUL NOT TO PINCH THE WIRE HARNESS (C).

MISE EN GARDE : VEILLEZ ?? NE PAS PINCER LE FAISCEAU (C).

1

E

B

D 15

B

C

21

10

D

10

21

2

3.Align and insert the HANDLEBAR ASSEMBLY (#15) into THE HANDLEBAR BRACKET TUBE (F) as shown until the mounting holes in the HANDLEBAR ASSEMBLY align with those of the

HANDLEBAR BRACKET TUBE.

H

10

F

D 3P

15

10

F 17

14 2P

2PR 15

2PL 2P

F 6 10 13

8

J F 8

19

16

15

7.Locate one of the VERTICAL HANDRAILS (#12). Carefully insert the top of the VERTICAL HANDRAIL into the user right end of the HANDLEBAR ASSEMBLY (#15). Align the mounting holes. Secure the VERTICAL HANDRAIL to the HANDLEBAR ASSEMBLY using two MOUNTING SCREWS (#4). Position the bottom of the VERTICAL HANDRAIL over the mounting hole in the top of the right FRAME LEG (K). Using one HEX HEAD BOLT (#3), mount the VERTICAL HANDRAIL to the right FRAME LEG as shown. Tighten the BOLT securely. Repeat the procedure for the remaining VERTICAL HANDRAIL (#12) on the left side of the HANDLEBAR ASSEMBLY and FRAME.

8.Lift the MONOCOLUMN SHROUD (A) and tighten the MONOCOLUMN BOLTS (#1) securely.

CAUTION: DO NOT OVER-TIGHTEN THE BOLTS (#1).

MISE EN GARDE : NE SERREZ PAS TROP LES BOULONS (N?? 1.)

9.Using four MOUNTING SCREWS (#5), attach the ACCESSORY TRAY (#11) to the DISPLAY CONSOLE (#9) as shown.

CAUTION: DO NOT OVER-TIGHTEN THE SCREWS (#5).

MISE EN GARDE : NE SERREZ PAS TROP LES VIS (N?? 5).

10.Attach all CABLES (L) leading from the DISPLAY CONSOLE MOUNTING BRACKET (D) ACCESS HOLE to the back of the DISPLAY CONSOLE (#9).

11.Feed any excess cable into the MONOCOLUMN (#10). Using four MOUNTING SCREWS (#5), secure the DISPLAY CONSOLE (#9) to the DISPLAY CONSOLE MOUNTING BRACKET (D).

CAUTION: DO NOT OVER-TIGHTEN THE PHILLIPS HEAD PAN SCREWS (#5).

15

4

12

K

3

9

11

MISE EN GARDE : NE SERREZ PAS TROP LES VIS CRUCIFORMES ?? T??TE CYLINDRIQUE (N?? 5).

MISE EN GARDE : VEILLEZ ?? NE PAS PINCER LE FAISCEAU

DE C??BLES (E) LORS DU MONTAGE DE LA CONSOLE (N?? 9)10

SUR SON SUPPORT (D).

12.Secure the MONOCOLUMN SHROUD (#21) to the MAIN SHROUD using four MOUNTING SCREWS (#7).

CAUTION: DO NOT OVER-TIGHTEN THE PHILLIPS HEAD

PAN SCREWS (#7).

MISE EN GARDE : NE SERREZ PAS TROP LES VIS

CRUCIFORMES ?? T??TE CYLINDRIQUE (N?? 7).

13. Insert the FRAME CAPS (#20) into the ends of the FRAME LEGS (K).

20

K

PRE-OPERATION CHECKLIST

!Ensure that all fasteners are tight.

!Make sure the Stairclimber is properly leveled and stable. (Refer to the Operation Manual)

!Ensure that the Leveler Jam Nuts are tight.

(Refer to the Operation Manual)

! Read the entire Operation manual before using the Stairclimber.

LISTE DES V??RIFICATIONS ?? EFFECTUER AVANT LA MISE EN MARCHE

!V??rifiez si tous les dispositifs de fixation sont serr??s

!V??rifiez si l'APPAREIL D'EXERCICE POLYVALENT est de niveau et stable. (R??f??rez-vous au manuel d'utilisation.)

!V??rifiez si les contre-??crous des v??rins de mise ?? niveau sont serr??s. (R??f??rez-vous au manuel d'utilisation.)

!Lisez le manuel d'utilisation dans son int??gralit?? avant d'utiliser l'appareil d'exercice polyvalent.

Before attempting to operate your Stairclimber, it is imperative that you familiarize yourself with the contents of the Operation Manual. If your Stairclimber does not respond as described in the OPERATION MANUAL, contact the nearest Life Fitness service center as listed in the Operation Manual.

??2003 Life Fitness, a division of Brunswick Corporation. All rights reserved. Life Fitness is trademark of Brunswick Corporation. Polar is a registered trademark of Polar Electro, Inc.MO51-00K47-A02106.03