ARCTIC SILVER QUIET DRIVE CROSS TRAINER 90X-0XXX-03

( MADE IN HUNGARY)

Customer Support Services

PARTS MANUAL30 Jul 2008

Page 2 of 17

Note: The 93X has Telemetry only.

Page 3 of 17

Console Support

MAK62-00123-0000

Console Support Cap

M0K62-01030-0000

Console Support

Shroud

M0K62-01023-0000

Right Inside Deadshaft Cover M0K62-01010-0000 Left Inside Deadshaft Cover M0K62-01011-0000 2-Front Inside Deadshaft Cover 0K62-01009-0000

Right Bullhorn Cover

M0K62-01007-0001

Left Bullhorn Cover

M0K62-01008-0001

Outside Front

Deadshaft Cover (2)

M0K62-01013-0000

Outside Rear

Deadshaft Cover (2)

M0K62-01012-0000

Page 4 of 17

Medallion Bug AK58-00245-0000 Bug Adaptor 0K62-01034-0001

Left Handlebar

MAK62-00091-0000

NOTE: The Right Bullhorn Assembly consists of: AK62-00057-0001 Bullhorn, M0K62-01136-0000 Grip, and M0K62-01199-0000 Gasket.

NOTE: The Left Bullhorn Assembly consists of: AK62-00058-0001 Bullhorn, M0K62-01136-0000 Grip and M0K62-01199-0000 Gasket

Page 5 of 17

Console Case Screws 0017-00101-1242

PCB Mounting Screws 0017-00101-1650

Programmed PCB

A084-92220-A008

Battery Door Polar W/Latch Ca ble0K62-01026-0000 AK39-00063-0000

Console Case with decal AK62-00142-0000

Polar PCB with Receiver

AK39-00064-0000

Overlay/Bezel/Switch (see chart below)

Page 6 of 17

Console Support Mounting Screws (6) M0017-00101-1791 Console Support Shroud Mounting Screws 0017-00101-1796

Inside Deadshaft Cover Screws 0017-00101-1796 (2 per side)

Bullhorn Screw Kit (kit includes 4 screws) GK62-00002-0042

Bullhorn Cover Screws 0017-00101-1854

Outside Deadshaft Cover Screws 0017-00101-1796 ( 2 per side )

Page 7 of 17

Right Pedal

Lever Assembly

MAK62-00236-0000

LF Bug

Medallion Assembly

AK58-00245-0000

Left Pedal Lever

Assembly

MAK62-00235-0000

Page 8 of 17

Crank Cover 0K61-03100-0002 2 - Mounting screws 0017-00101-1837

Stabilizer Caps

4 - 0K62-01003-0000

Front frame Cap M0K62-01004-0000 Mounting Screws

(Located on front sides of Ladder Frame Cover) 2- 0017-00101-1795

Page 9 of 17

Rocker Cover Kit (includes clip & screw) GK62-00002-0066 Mounting screw 0017-00101-1796

Right Inside Rocker Cover 0K62-01037-0000

Right Inside Lever Joint Cover 0K62-01039-0000

Outside Pedal Joint Cover 0K62-01035-0000 Mounting screw 0017-00101-1836

Rear Shroud Assy. AK62-00223-0000 Mounting screws (2 per side) 0017-00101-1796

Right Link Cover w/decal AK62-00115-0000

Left Link Cover w/decal AK62-00116-0000 Mounting screws

( 6 per cover) 0017-00101-1796

Left Inside Rocker Cover 0K62-01038-0000

Left Inside Lever Joint Cover 0K62-01040-0000

Outside Pedal Joint Cover 0K62-01035-0000 Mounting Screw 0017-00101-1836

Page 10 of 17

Control Link Kit GK62-00002-0071 (contains 2 control links, part nos. AK62-00384-0000)

Control Links (2)

E-RingAK62-00384-0000

0017-00100-0107 Thrust Washer 0K47-01105-0000 Brass Washer 0K47-01104-0000

Pedal/Rocker Shaft & Bearings Order Kit GK62-00002-0001

Hex nut 0017-00103-0333

Right Inside Pedal Cover 0K62-01015-0000

Left Inside Pedal Cover 0K62-01016-0000 Mounting screws (5) 0017-00101-1796

Washer 0017-00104-0479 Nut 0017-00103-0333

Crank Extension Mounting Bolt 0017-00101-1907

Left Pedal

M0K62-01005-0000

Right Pedal

M0K62-01006-0000

Note: Units with old control link assemblies will require kit MGK62-00002-0015

when replacing either the tie rod assembly or the crank extension for the first time.

Page 11 of 17

PCB, Reed Switch Battery Bracket 0K62-01233-0000

Power Control Board B084-92218-D002 PCB Mounting screws 0017-00101-1838

Battery Mounting screws 0017-00101-1797

6V Battery

0017-00003-0685

Grommet (4)

M0017-00042-0821

Reed Switch 118E-00001-0140

Reed Switch Mounting screws (2) 0017-00101-1794

Page 12 of 17

This assembly is used 4 times on the drive module assembly.

Bearing Flanges (2)

Service Kit-0K62-01220-0000

MGK62-00002-0044

Includes:

1- crankshaft

2- bearings

2- sets of bearing flanges

4- nuts and washers

Service Kit- GK62-00002-0045

Includes:

1 - intermediate shaft

2 - bearings

2- sets of bearing flanges

4- nuts and washers

1??? Bearing 0K62-01221-0000

Page 13 of 17

Page 14 of 17

Crank Arm-Pulley Assembly

See Page 14 for breakdown

Crankshaft

M0K62-01222-0001

Alternator-Flywheel Assembly AK61-00250-0001 Mando Alternator Brushes 0017-00009-0895

J10 Flexonic Belt

0K62-01135-0000

Intermediate Shaft 0K62-01223-0000

Resistor Assembly Includes Power Control Cable MAK62-00260-0000

Bearing-Insert

Assembly (4) See Page 13 for breakdown

Right Crank Arm

Weld Assembly

MAK62-00204-0000

J8 Flexonic Belt

0K62-01134-0000

Poly-V Metric Pulley 0K35-01186-0007 Pulley Set Screws 0017-00101-1833

Page 15 of 17

Crankshaft

M0K62-01222-0001

Square

Machine Key (2)

M0K53-01122-0000

Alternator-Flywheel Assembly Mounting bolt 0017-00101-0986

Crank Arm Mounting bolt 0017-00101-1849 nut 0017-00103-0334

Alernator-flywheel mounting bolt and nut

bolt-0017-00101-1867 nut-0017-00103-0332

Machine Key 0K53-01183-0000

Bearing-Insert mounting screw and nut 0017-00101-1866 0017-00103-0341

Retaining ring 0017-00100-0107

Poly-V pulley mounting screw and washer 0017-00101-1836 0017-00104-0465

Page 16 of 17

Power Control Cable

AK62-00092-0000

Main Cable

AK62-00093-0000

Page 17 of 17