PRODUCT MODEL NUMBERS

KIDS36EP KIDS42EP

Electrical: 120-volt, 60-Hz, AC-only, 15- or 20-amp. electrical supply. Use copper wire only. A time-delay fuse or circuit breaker and separate circuit is recommended.

If using a Hot Water Accessory Tank and/or a garbage disposer, a separate 120-volt, 60 Hz, AC-only, 15- or 20-amp fused electrical supply is required for each devise.

Water: For dishwasher, a hot water line with 20-120 psi (138-827kPa) water pressure. Water temperature must be minimum 120??F (48.9??C) at dishwasher. Use 3/8" O.D. copper tubing with compression fitting is recommended. Use a 90?? elbow with 3/8" N.P.T. external pipe threads on one end to connect to water inlet valve. Do not solder within 6" (15.2 cm) from water inlet valve. For sink faucet, hot and cold water line. Copper tubing with compression fitting for specific faucet to be installed.

Drain: Separate drain P-traps for sink and dishwasher.

OVERALL DIMENSIONS

DISHWASHER DRAIN

22-1/32"

(56.0 cm) to bottom of dishwasher drain

1/2" (1.3 cm) minimum

back wall

If the dishwasher drain exits through the back wall, the centerline of the drain must be a minimum of 1/2" (1.3 cm) below the dishwasher drain. This is required to completely drain the dishwasher tub so that no standing water remains in tub.

backsplash

7/16" (1.1 cm) min. flat surface required

*NOTE: The cutout must be accurately cut to the dimensions shown within 1/16" (1.6 mm). Dishwasher top flange overlaps the countertop cutout by 7/16" (1.1 cm) on front and back edges and 1/4" (6.4 mm) on sides.

???Cabinetry and countertop must be sturdy enough to support loaded dishwasher and sink (400 lbs. [181.4 kg]).

21-1/8"

(53.7 cm) (see *NOTE)

A

It is recommended that sink water and drain line connections be located on this side of cabinet.

for base cabinet installations, min. 36" (91.4 cm) width required

A

42" model ??? 40" (101.6 cm)

36" model ??? 34" (86.4 cm) B C (see *NOTE)

A

25" (63.5 cm) deep countertop

Countertop must be level.

It is recommended that dishwasher water and drain line connections be located on this side of cabinet.

IMPORTANT: Corner radius dimensions specified must be used. If they are not, the dishwasher will not fit the opening.

A radius: 2-1/4" (5.7 cm)

C Back right corner: If countertop is more than 3/4" (1.9 cm) thick,

measure down 3/4" (1.9 cm) and cut 45?? bevel all the way around radius.

3/4" 45?? (1.9 cm)

Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.