I n s t a l l a t i o n G u i d e

for the

SB-H-CRV/10W3V3

SKU#94429

2007+

If you choose to perform the installation yourself, it is absolutely vital that the Stealthbox?? be properly mounted to the vehicle according to these instructions. Failure to mount the enclosure properly presents two problems:

1)The sub-bass performance will suffer due to the movement of the enclosure caused by the force exerted by the woofer(s).

2)A loose enclosure presents a serious safety hazard in the event of a collision or sudden deceleration.

INSTALLATION

D I F F I C U LT Y :

3OUT

OF

5

Estimated TIME:

2-3 HOURS

Thank you for choosing a JL Audio Stealthbox?? for your automotive sound system. With proper installation, your new vehicle-specific enclosed subwoofer system will deliver years of listening pleasure.

We strongly recommend that you have your new Stealthbox?? installed by your authorized JL Audio dealer. The installation professionals employed by your dealer have the necessary tools and experience to disassemble and reassemble your vehicle properly. If you prefer to perform your own installation, please read this installation guide completely

before beginning the process.

S T E P 1

Remove any contents in the trunk of the car so that you will have a clean area to work in. Place the Wax Square as shown

S T E P 2

Thread the included Hex Head Bolt into the enclosure so that approximately 1/2??? remains exposed (as shown).

S T E P 3

Set the Stealthbox in place. Push in and, down as indicated by the arrows to get the bolt to make an impression in the wax square.

S T E P 4

Remove the enclosure, ensure that an adequate depression has been made in the Wax Square to use it as a guide to drill a hole. If the impression is not present, back the bolt out of the enclosure and, repeat STEP 3 untill there is a well defined impression in the Wax Square.

SB-H-CRV/10W3V3 INSTR_SKU# 011281

S T E P 8

Insert the Spacer over the Hex Head Bolt, through the 1??? hole in the interior plastic trim panel so that it will rest against the metal interior fender panel.

S T E P 5

Using a 1 inch hole saw, drill and cut a hole through the inner plastic panel. At the same time, drill the pilot hole only

through the metal inner fender panel.

*CAUTION*

Before drilling, always make sure that you are not going to be drilling into any gas lines, brake lines, transmission lines, electrical wiring, exhaust systems or anything else that might cause a reduction in your weekly pay. Always wear eye protection when drilling.

S T E P 6

From inside the fender well, insert the Hex Head Bolt, Split Lock Washer and Fender Washer through the hole drilled in

STEP 5

S T E P 9

This illustration details how the hardware should be arranged to mount the Stealthbox?? securely.

S T E P 1 0

Hook up the wire from the amplifier to the Stealthbox??, and test the Stealthbox?? to ensure the correct operation. Have a friend slide the Stealthbox??into postion while you turn the Hex Head Bolt in order to get the threads started into the Stealthbox??, tighten the fastners.

S T E P 7

From inside the vehicle, the Hex Head Bolt should protrude well past the interior plastic trim panel.

S T E P 1 1

C O N G R A T U L A T I O N S !

You have completed the installation for this model!

Enjoy your new Stealthbox??!

Please refer to the Power Recommendation section for an amplifier recommendation and basic set-up help.