B

12W??v2 SUBWOOFER PHYSICAL

SPECIFICATIONS

Nominal Diameter: 12.0 in. 305 mm

Overall Diameter (A): 12.52 in. 318 mm

Mounting Hole Diameter (B): 11.0625 in. 281 mm

Bolt Hole Circle (C): 11.7 in. 297 mm

Magnet Diameter (D): 5.05 in

128 mm

Mounting Depth (E): 5.4 in. 137 mm

Net Weight: 8.11 lbs. 3.68 kg

Driver Displacement: 0.048 ft3

1.36 liters

A

CE

D

Free Air Resonance (Fs): 28.43 Hz

Electrical ???Q??? (Qes): 0.715

Mechanical ???Q??? (Qms): 10.709

Total Speaker ???Q??? (Qts): 0.670

Equivalent Compliance (Vas): 2.530 ft3

71.64 liters

One-way, Linear Excursion (Xmax)*: 0.45 in. 11.4 mm

Efficiency (1W/1m)**: 85.64 dB SPL

Effective Piston Area (Sd): 74.509 in2

0.0481 m2

DC Resistance (Re): 4.280 ohm

Nominal Impedance: 4 ohm

Power Handling (continuous): 300 W

*Xmax specifications are derived via one-way voice coil overhang method with no correction factors applied.

**Efficiency (1W/1m) is not an accurate indicator of a subwoofer???s output capability and should not be used as a comparison to other subwoofers to determine which one is ???louder??? !

???The enclosure recommendations listed are external dimensions which assume the use of 3/4" (19mm) thick material. If you are using 5/8" (16mm) thick material, subtract 1/4" (6.5mm) from each dimension. Do not use any material with a thickness of less than 5/8" (16mm) as this may compromise the rigidity of the enclosure.

???All enclosure volumes listed are net internal volumes! Box volume displacement, port displacement and brace displacement must be added to obtain the final gross internal volume. All enclosure dimensions listed have already taken this into account.

???When using two subwoofers in a common enclosure simply double the required volume and, in the case of a ported enclosure, use two times the recommended port(s).

???We recommend the use of this speaker in a bi-amplified system using high-quality satellite speakers and amplifiers. We do not recommend the use of this subwoofer with a passive crossover (coil), as this type of device will adversely affect performance.

! ! CAUTION ! !

Prolonged exposure to sound pressure levels in excess of 100dB can cause permanent hearing loss. This high-performance speaker can exceed this level. Please exercise restraint in its operation in order to preserve your ability to enjoy its fidelity.

When installing a subwoofer in your vehicle, it is extremely important to secure the enclosure firmly. We recommend bolting the enclosure through the metal of the floorpan or the frame of the vehicle with large diameter washers for reinforcement. If an enclosure is not firmly attached, it can become a projectile in a collision. This is particularly important in a hatchback, station wagon, sports utility vehicle, or van.

MEDIUM???GRAY (MINIMUM):

From a reliability standpoint, this zone represents a very comfortable operating power range for each driver. This level of power will not stress the woofer but will not extract all of its performance potential, either.

Use of less than the minimum power level will not damage the woofer, but may result in unsatisfactory performance.

LIGHT???GRAY (OPTIMUM):

This zone represents the best compromise between long-term reliability, high-output and low-distortion performance. This power level is lower than the woofer???s continuous power rating (as published in its specifications), but you will still be taking advantage of the woofer???s, low-distortion performance range without undue risk of failure.

DARK???GRAY (MAXIMUM):

Slightly more SPL will be gained by pushing the power into this zone, but typically not more than 2dB, compared to the light gray zone. The subwoofer driver is designed to operate safely up to this power range, but not beyond. Operate with caution.

BLACK (WARRANTY???VOID):

We do not recommend operating woofers at this level of power. In this zone, there is a very high probability that the driver will fail due to excessive heat and/or mechanical stress.

Subwoofer drivers operated at these levels of power are NOT covered under warranty.

JL AUDIO warrants this speaker to be free of defects in materials and workmanship for a period of one (1) year from the original date of purchase.

Damage caused by the following is not covered under warranty: accident, misuse, abuse, product modification or neglect, failure to follow installation instructions, unauthorized repair attempts, misrepresentations by the seller. This warranty does not cover incidental or consequential damages and does not cover the cost of removing or reinstalling the unit(s). Cosmetic damage due to accident or normal wear and tear is not covered under warranty.

Thiswarrantyisnottransferableandappliesonlytotheoriginalpurchaser of the product from an authorized JL AUDIO dealer. Warranty is voided if the factory-applied product serial number is removed or defaced.

Should service be necessary under this warranty for any reason due to manufacturing defect or malfunction, JL AUDIO will, at its discretion, repair or replace the defective product with new or remanufactured product at no charge.

Any applicable implied warranties are limited in duration to the period of the express warranty as provided herein beginning with the date of the original purchase at retail, and no warranties, whether express or implied, shall apply to this product thereafter. Some states do not allow limitations on implied warranties, therefore these exclusions may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

If you need service on your JL AUDIO product:

All warranty returns should be sent to JL AUDIO freight prepaid through an authorized JL AUDIO dealer and must be accompanied by proof of purchase (a copy of the original sales receipt.) Direct returns from consumers or non- authorized dealers will be refused unless specifically authorized by JL AUDIO with a valid return authorization number. Warranty expiration on products returned without proof of purchase will be determined from the manufacturing date code. Coverage may be invalidated as this date is previous to purchase date. Return only defective components. Non-defective items received will be returned freight-collect. Customer is responsible for shipping charges and insurance in sending the product to JL AUDIO. Freight damage on returns is not covered under warranty. Always include proof of purchase (sales receipt).