A Huffy Company

Customer Service

N53 W24700 South Corporate Circle

Sussex, WI 53089

U.S.A.

SAFETY INSTRUCTIONS

FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY

RESULT IN SERIOUS INJURY,

PROPERTY DAMAGE AND WILL VOID WARRANTY.

This unit is intended for display purposes only and should not be used for play.

To ensure safety, do not attempt to assemble this system without following the instructions carefully. Check entire box and inside all packing material for parts. Before beginning assembly, read the instructions and identify parts in this document. Proper and complete assembly, use and supervision is essential for proper operation and to reduce the risk of accident or injury. A high probability of serious injury exists if this system is not installed, maintained, and operated properly.

???During assembly, if using a ladder use extreme caution. Two people are recommended for this operation.

???If technical assistance is required, contact Huffy Sports??? Sample and Display Technician.

???Serious injury could occur if teeth/face come in contact with backboard, net or rim.

???Display recommended for 3??? (7.6 cm) or 3-1/2??? (9 cm) Round or 4??? (10 cm) Square poles only.

???All instructions and warnings MUST accompany any display item that is sold.

Most injuries are caused by misuse and/or not following instructions.

Use caution when installing this unit.

REQUIRED TOOLS AND

MATERIALS:

???Wrenches: (Two each) 7/16???, 1/2???, 9/16???, and 3/4??? or Pliers

???3/16??? Allen Wrench

???Step Ladder, 8 ft. (2.4 m)

1Move display to location on sales floor and remove 2 X 4 runners under feet.

9

11

P.O.P.

2Install pegboard panels onto corresponding side support

railings. Secure with zip tie to temporarily hold panel in place. Remove zip ties after assembly is complete. Attach P.O.P. sign (11) with plastic push clips (9) so that it faces aisle as shown.

4Install enclosed pole mounting hardware and pole for each assembly.

908811 C

3-1/2??? Rnd. Pole X 30??? Pole

WARNING

TWO PEOPLE ARE

NECESSARY TO MOUNT THE

ELEVATOR ASSEMBLY TO

THE POLE. ONE PERSON

SHOULD NOT ATTEMPT TO

DO THIS ALONE.

Upper Support

Railing

B

3-1/2??? Rnd. Pole

TOP

VIEW

3-1/2??? Rnd. Pole

A

NOTE:FRONT

Enclosed One Set

Of Hardware For

(Each) Pole Installation

D

3-1/2??? Rnd. Pole

5Assemble display products per diagram below and procedures on following pages for each model. Then

mount to corresponding backboard hardware.

81410

48??? Fan Backboard

w/Slam Jam Rim

CHUFFY TUFF

WARNING

TWO PERSON MINIMUM

REQUIRED FOR THIS

PROCEDURE. NOT

FOLLOWING

RECOMMENDATION MAY

RESULT IN BODILY INJURY.

WARNING

MOUNTING THE ELEVATOR

ASSEMBLY TO THE POLE IS

PERFORMED AT AN

ELEVATED HEIGHT. USE

PROPER PRECAUTION.

A

FREE

STYLE

80550 44??? Fan w/Standard Rim

FRONT

5

2

6

6

1. Mount extension arm and rim to backboard and finger tighten.

NOTE: For spring loaded rim assembly, refer to instructions included with rim hardware.

2. Secure hardware to extension arm as shown and tighten completely.

3

BASKETBALL CENTER

BASKETBALL CENTER