FCC STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful inter- ference, and (2) this device must accept any,@terferencereceived, includ- ing interferencethat may cause undesiredo-tion.

Whing: Changes or modificationsto this u& not expressly approved by the party responsible for compliance could void the user'sauthority to operate the equipment.

This equipment has beentested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonableprotection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and, if not installedand used in accordance with the instructions, may cause harmful interferenceto radio communications. However, there is no guarantee that interference will not occur in a particu- lar installation. If this equipment does cause harmful interferenceto radio or television reception, which can be determined by turning the equipment off and on, the user is encouragedto try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increasethe separation between the equipment and the receiver.

-Consult the dealer or an experienced radio/N technicianfor help.

Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.

If you have any questions, please contact:

mUCK START WIDE

To start using your Digital Video Camera, follow these simple steps.

See the main user guide on CD for the full documentation for the VCAMNOW 2.0. It is installed on your computer as part of the installation process. To read the complete user guide, please go to Start -> Programs -> VCamNow 2.0 -> User Guide.

Consumer Affairs

Hasbm, Inc.

1027 Newport Avenue.

Pawtucket, RI

Tel: 1-800-844-3733

Fax: 1-401-431-8082

Product and colors may vary.

O 2006 Hasbro. All Rights Reserved. TM & 03 denote U.S. Trademarks.

ELECTRONICSTIGEim

mns~rmoloovcarr*to~.vl~rn

Open cover. Insert 2 x 1.5V "AA" or R6 size batteries (not

a CAUTION: TO AVOID BATTERY LEAKAGE

1.Be sure to insert the batteries correctly and always follow the toy and battery manufacturers'

2.Do not mix old batteries and new batteries or alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries;

3.Always remove weak or dead batteries from the

IMPORTANT: BATTERY INFORMATION

Please retain this information for future reference. Batteries should be replaced by an adult.

-

hCAUTION:

1.Always follow the instructions carefully. Use only

batteries specified and be sure to insert item correctly by matching the + and - polarity markings.

2.Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline batteries.

3.Remove exhausted or dead batteries from the product.

4.Remove batteries if product is not to be played with for a long time.

5.Do not short-circuit the supply terminals.

6.Should this product cause, or be affected by, local electrical interference, move it away from other electrical equipment. Reset (switching off and back on again or removing and re-inserting batteries) if necessary.

7.RECHARGEABLE BATTERIES: Do not mix these with any other types of batteries. Always remove from the product before recharging. Recharge batteries under adult supervision. DO NOT RECHARGE OTHER

TYPES OF BATTERIES.