Hasbro_Board_Games

rker (not included)

compartment m a r

(I- sta @'&a&& to cover). Famover cover.

Insert 2 r GV''AM"or RO3 size battertes.

Replacer cover-andtighten screw.

A CAUTION: TO AVOID BATTERY LEAKAGE

1.As with all small batteries, the batteries used with this toy should be kept away from small children who still put things In their mouths. If they are swallowed, promptly sea a doctor and have the, doctor phone (202) 625-3333 collect. In other countries, have the doctor call your local poison control center.

2.MaRe sure the batteries are inserted correctly and always follow tha toy and battery manufacturers'instructions.

3.Do not mix old batteries and new batteries or alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.

4.Always remove weak or dead batteries from the product.

IMPORTAN1 BATTERY INFORMATION

Please retain this information for future reference.

Batteries should be replaced by an adult.

CAUTION:

1.Always follow the instructions carefully. Use only batteries specified and be sure to Insert item correctly by matching the + and -polarity markings.

2.Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline batterles.

3.Remove exhausted ar $@adbatteries from the product.

4.Remove Batteries if product is not to be played with for a long time.

5.Do net short-circuit the cross terminals.

6. .Should thls product causa, or be affected by, local electrical interference, move i t away from other eleotried equipment. Reset (switching off and back on again or removing and re-inserting batteries) If necessary.

7.RECHARGEABLE BATTERIES: Do not mix these wlth any other types of battery. Always remove from the product before recharging. Recharge batteries under adult supervision. DO NOT RECHARGE

OTHER TYPES OF BATTERIES.

8.As with all small items, these batterles should be kept away from children. If swallowed, seek medical attention immediately.

N-S7'RIKE DISK SHOTMBLAS7ER

Launch Button

Wireless Remote

Motton Button

Pull Ba d Mechanlsm

6 Mlcm Dartsm

~rlgger

SETnNG UP 7HE GAME

1.Connedthe Power Adaptor to the Disk Launcher first, then plug it into an electric outlet.

2.Attach the Loading Arm to the back of the Disk Launcher, as shown.

3.Pull back the LoadingArm and insert the Disks, with the black side of Disks facing you. The Disk Launcher can hold a minimum of one Disk or a maximum of 12 disks. (Additional Disks sold separately.)

4.Place the Disk Launcher on a level floor. A Safety Switch on the bottom of the unit will register whether or not the launcher is resting on a level floor. If the Disk Launcher is not resting on a flat surface, the motor will turn off and the Disk Launcher will not function.

NOTE: Do not position the Disk Launcher so that Disks are in danger of hitting windows, furniture, television or stereo equipment, fragile objects, containers of liquid, plants, people, or pets.

The Wireless Remote, which you can attach any N-STRIKE5blaster with a rail system, operates like the remote control to your TV: it sends out an invisible beam, which activates the Disk Launcher.

You must aim the Wireless Remote at the Disk Launcher in order for it to function.

Mount the Wireless Remote onto the blaster rail by sliding and locking it into place.

GAME PLAY

Turn the Disk Launcher ON. The ON switch is locatedat the bottom front of the Disk Launcher.

You will hear a single tone, and the lights on the Launcherwill light up.

When you play with this product, it is recommended that you stand at least 8 to 12 feet away from the Disk Launcher.

The Disk Launcher has two height settings, to control how high it launches the Disks: the low setting is up to 7 feet (2.1 meters); and the high setting is up to 9 feet (2.7 meters). The default setting is low. Take note of the ceiling height in the room you're playingin, and set the launch height accordingly.

To change the heightsetting, pressthe Height Adjustment button on the front of the Disk Launcher. The top light indicatesthe high

setting; tha bottom light, the low setting. To return to the default setting, pressthe button again.

TO LOAD W E BLASER

1. Insert a dart into the barrel of the blaster.

2.Pull back the cocking mechanism.

3.Pull the trigger to fire.

4.Repeat steps I and 2 with darts from the blaster's storage compartment.

FOR ALL GAMES

1.Aim the blaster at the Disk Launcher.

2.Press the Wireless Remote'sLaunch button. You will see three red lightsgo on, on the Disk Launcher.

3.You will hear one long tone, followed by three short tones. This is a countdown to Disk launch. The three red lights will go off, in sequence and in time with each tone, and then a Disk will launch.

TIP: Keep your arm straight when firing the blaster. As the Disk flies into the air, watch for it to reach its highest point before falling: firing at the Disk at this moment increases the likelihood of hitting your target.

If you do not play with this product for more than approximately three minutes, it will enter "Sleep Mode." Once the unit enters Sleep Mode, you will need to turn the unit off and back on again to start playing again.

HOW TO PLAY

as a hi.To launch another Disk, you needto aim your and pressthe Wireless Remote'sLaunch button agam.

NOTE:If, after playing games 2 and 3, you wish to play game 1, push the Motion Button when the ATOWis back at the center and this will stop the motion.

Feel free to make up your own games, as you play with this product!

For example, ifyou are playing with a friend, you could launch six Disks and play "Best of Sixn: whoever hits the most Disks wins.

If your friend has his or her own N-STRIKEQblaster (sold separately), one player could launch the Disks with a Wireless Remote and both players could try to hit them at the same time.

rips

This product is for indoor use only. Do not take the Disk Launcher outdoors or expose it to natural elements such as wind, rain, or snow. Play in a clear, open indoor area.

Do not use the Disk Launcher or play this game with anything other than N-STRIKEQblasters.

I'm pressingthe Wireless Remote buttons and nothing is happeningwith the Disk Launcher.

One of the Disks appears to be stuck.

The three (3) LED lights on the unit are flashing.

A tone is repeating and will not stop.

-Make sure, when you are pressing the buttons on the Wireless Remote, that you are aiming the Wireless Remote at the Disk Launcher.

-The unit may be in Sleep Mode: turn it off and back on.

-Make sure ou have fresh batteries in the Wireless Remote and that the Disk ~ a u n d eisr plugged into a working electrical outlet.

-Unplug the Disk Launcher and attempt to dislodge the stuck Disk.

-There are no Disks in the unit, or the Loading Arm is not attached.

-There is an error with the unit. Turn it off and unplug it. Check to make sure there are no Disks stuck in the unit. Turn the unit back on again.

FCC STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesiredoperation.

Warning: Changes or modifmtions to this unit not expressly approved by the party responsible for compliance could void the user's authorityto operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protectionagainst harmful interference in a residentialinstallation. This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communicatbns. However, there is no guarantee that interferencewill not occur in a particular installation. If this equipment does cause harmful interferenceto radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver. Consult the dealer or an experienced radiom technician for help.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Your Disk Shot and DC adaptor should be periodically examined for potential hazards. If any potential hazards are found, please contact Hasbro Consumer affairs at 1-800-844-3733for repair or replacement.

O 2007 Hasbro. All Rights Resewed.

TM 8. @ denote U.S. Trademarks.

U.S. Pat. Nos.5611322, 5471967 and 5529050.

56855 PIN 6679700000Product and colon may vary.