Save This Manual

Keep this manual for the safety warn- ings and precautions, assembly, operating, inspection, maintenance and cleaning pro- cedures. Write the product???s serial number in the back of the manual (or month and year of purchase if product has no num- ber). Keep this manual and the receipt in a safe and dry place for future reference.

Important SAFETY

Information

In this manual, on the labeling, and all other information provid- ed with this product:

This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death.

DANGER indicates a hazardous

situation which, if not avoided, will result in death or serious injury.

WARNING indicates a

hazardous situation which, if not avoided, could result in death or serious injury.

CAUTION, used with the safety

alert symbol, indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.

NOTICE is used to address practices not related to personal injury.

CAUTION, without the safety alert

symbol, is used to address practices not related to personal injury.

General Product Safety Warnings

WARNING Read all safety warnings and instructions.

Failure to follow the warnings and instructions may result in serious injury.

Save all warnings and instructions for future reference.

The term ???product??? in the warnings refers to your battery-operated

(cordless) Crank Radio/Flashlight.

1.Work area safety

a.Keep work area clean and well lit.

Cluttered or dark areas invite acci- dents.

b.Do not operate this product in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. This product can cre- ate sparks which may ignite the dust or fumes.

c.Keep children and bystanders away while operating this product.

Distractions can cause you to lose control.

2.Electrical safety

a.Do not expose this product to rain or wet conditions. Water entering this product will increase the risk of product failure and/or electric shock.

3.Personal safety

a.Stay alert, watch what you are do- ing and use common sense when operating this product. Do not use this product while you are tired or under the influence of drugs, alco- hol or medication.

4.Product use and care

a.Do not force this product. Use the correct product for your applica- tion. The correct product will do the job better and safer at the rate for which it was designed.

b.Turn the Power Switch (13) to its ???OFF??? position before making any adjustments, changing acces- sories, or storing the unit. Such preventive safety measures reduce the risk of starting the product acci- dentally.

c.Store this product out of the reach of children and do not allow per- sons unfamiliar with the product or these instructions to operate the unit.

d.Maintain this product. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the product???s operation. If damaged, have the product repaired before use. Many accidents are caused by poorly maintained products.

e.Use this product in accordance with these instructions, taking into account the working conditions and the work to be performed. Use of this product for operations different from those intended could result in a hazardous situation.

5.Battery tool use and care

a.Recharge only with the Crank Handle (3).

b.Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact acciden- tally occurs, flush with water. If liquid contacts eyes, additionally seek medical help. Liquid ejected from the battery may cause irritation or burns.

6.Service

a.Have this product serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the unit is maintained.

Additional Precautions

1.Maintain labels and nameplates on the product. These carry important safety information. If unreadable or missing, contact Harbor Freight Tools for a replacement.

2.Avoid unintentional starting. Prepare to begin work before turning on the product.

3.Do not leave the tool unattended when its Power Switch (13) is on.

Turn off the unit before leaving.

4.This product is not a toy. Keep it out of reach of children.

5.People with pacemakers should consult their physician(s) before use.

Electromagnetic fields in close prox- imity to heart pacemaker could cause pacemaker interference or pacemak- er failure. In addition, people with pacemakers should:

???Avoid operating alone.

???Properly maintain and inspect to avoid electrical shock.

6.The warnings, precautions, and in- structions discussed in this instruction manual cannot cover all possible con- ditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.

OPERATING INSTRUCTIONS

Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.

Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.

Unpacking

When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.

Product Features

FIGURE A

DC COVER (17)

1.Check to make sure the Switch But- ton (13) is in its ???OFF??? position.

(See Figure A.)

2.To charge the internal Battery (27), pull out the Crank Handle (3) and ro- tate the Handle clockwise at a steady rate for approximately one minute. Then place the Crank Handle back in its original position. (See Figure B.)

CRANK HANDLE

(3)

FIGURE B

3.The Emergency Crank Radio/Flash- light features AM and FM frequen- cies.

???Charge the internal Battery (27) for one minute by rotating the Crank Handle (3). Then turn the Switch Button (13) to either its ???AM??? or

???FM??? function. (See Figure A.)

???Turn the Frequency Switch (15) to the correct ???AM??? or ???FM??? frequency to select the desired radio station.

(See Figure A.)

4.The Emergency Crank Radio/Flash- light features two LED Light func- tions:

???Charge the internal Battery (27) for one minute by rotating the Crank

Handle (3). Then turn the Switch

Button (13) to its ???1 LED??? posi- tion. One LED Light on the unit will illuminate for approximately 1-1/2 hours before recharging is neces- sary. (See Figure A.)

???Charge the internal Battery (27) for one minute by rotating the Crank

Handle (3). Then turn the Switch Button (13) to its ???3 LED??? position.

All three LED Lights on the unit will illuminate for approximately 30 minutes before recharging is neces- sary. (See Figure A.)

5.To operate the Alarm on the unit, simple turn the Switch Button (13) to its ???ALARM??? function.

(See Figure A.)

6.To charge a mobile phone, using the Emergency Crank Radio/Flashlight:

???Charge the internal Battery (27) for one minute by rotating the Crank

Handle (3). Then open the DC

Cover (17). (See Figure A.)

???Plug one end of the Mobile Phone Charger Cord (28) into the Charging Jack on the unit. Plug the other end of the Charger Cord into the mobile phone you wish to charge.

(See Figure A.)

???NOTE: One minute of crank time on the Crank Handle (3) will allow for 2 to 8 minutes mobile phone talk time or 40-50 minutes standby.

7.When finished using the Emergency

Crank Radio/Flashlight, make sure to turn the Switch Button (13) to its

???OFF??? position. Then store the unit in a clean, dry, safe location out of reach of children and other unauthor- ized persons.

Maintenance And

Servicing

Procedures not specifically explained in this manual must be performed only by a qualified technician.

To prevent possible injury

from accidental operation:

Turn the Switch Button (13) of the Emergency Crank Radio/ Flashlight to its ???OFF??? position before performing any inspection, maintenance, or cleaning procedures.

To prevent possible injury from product failure:

Do not use a damaged product. If abnormal noise or vibration, or Battery leakage occurs, have the problem corrected before further use.

detergent. Do not use solvents. Do not immerse the unit in liquid.

PLEASE READ THE

FOLLOWING CAREFULLY

The manufacturer and/or distributor has provided the parts list and assembly diagram in this manual as

a reference tool only. Neither the manufacturer or distributor makes any representation or warranty of any kind to the buyer that he or she is qualified to make any repairs to the product, or that he or she is qualified to replace any parts of the product. In fact, the manufacturer and/or distributor expressly states that

all repairs and parts replacements should be undertaken by certified and licensed technicians, and not by the buyer. The buyer assumes all risk and liability arising out of his or her repairs to the original product or replacement parts thereto, or arising out of his or her installation of

replacement parts thereto.