To assemble:

1.Select a dry, straight wooden board of the dimensions shown in Figure 1.

2.Drill as many 7⁄16 in. holes as desired along the length of the board, at least 3 in. apart and 3⁄4 in. on center from the top of the board (see Figure 2).

Note: Make sure holes are at least 3 in. from the ends of the board so that the board will not split when stressed.

3.Using the hex bolts and nuts provided, mount the two bar clamp heads (see Figure 3).

If you need help with your new bar clamp heads, call our

Tech Support at: (570) 546-9663.