To install the muffler:Figure 1. Noise reducing kit installed.

1.Measure the size of the muffler body (see

3.Remove the portion of the outlet hose marked in Step 2.

5.Apply the 3 x 15mm foam tape to the top and

6.Fit the ends of the outlet hose completely over the ends of the muffler.

7.Slide the wire hose clamps down to the end of the hose near the body, then tighten them to secure the muffler in place.

Copyright ?? November, 2006 By Grizzly Industrial, Inc. Revised November, 2009.

Warning: No portion of this manual may be reproduced in any shape

Or form without the written approval of Grizzly Industrial, inc.

#TR8803 printed in TAIWAN