R3931
Please keep these instructions for future reference, as they contain important information.
Requires four ???AA??? batteries (included) for operation.
Adult assembly is required for battery replacement. Tool required for battery replacement: Phillips screwdriver (not included).
Battery
Replacement
1.5V x 4 ???AA??? (LR6)
For best performance, we recommend replacing the batteries that came with this toy with four, new ???AA??? (LR6) alkaline batteries.
???Locate the battery compartment on the bottom of the toy.
???Loosen the screw in the battery compartment door and remove the door.
???Remove the exhausted batteries and throw them away.
???Insert four, new ???AA??? (LR6)
alkaline batteries.
Hint: We recommend alkaline batteries for longer battery life.
???Replace the battery compartment door and tighten the screw.
???If this product begins to operate erratically, you may need to reset the electronics. Turn the power off and then back on.
???When light from this toy dims or turns off, it???s time for an adult to change the batteries.
??? Protect the environment by not disposing of this product with household waste (2002/96/EC). Check your local authority for recycling advice and facilities (Europe only).
Battery Safety
Information
In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage:
???Do not mix old and new batteries or batteries of different types: alkaline, standard
???Insert batteries as indicated inside the battery compartment.
???Remove batteries during long periods of
???Never
???Use only batteries of the same or equivalent type, as recommended.
???Do not charge
???Remove rechargeable batteries from the product before charging.
???If removable, rechargeable batteries are used, they are only to be charged under adult supervision
Tough Enough for Little Explorers!
Power Button
???Press the power button on the front of the lantern to turn on the low beam light. Press the button again for high beam lights.
???Press the button again to turn power off.
???Pull the light up and lift the handle use as a lantern!
???Push the light down and lower the handle to use as a spotlight!
Consumer Information
Care
???Wipe this toy with a clean cloth dampened with a mild soap and water solution. Do not immerse this toy.
???This toy has no consumer serviceable parts. Do not take this toy apart.
???This Class B digital apparatus complies with Canadian
???Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.
???Cet appareil num??rique de la classe B est conforme ?? la norme
???L???utilisation de ce dispositif est autoris??e seulement aux conditions suivantes:
(1)il ne doit pas produire de brouillage
et (2) l???utilisateur du dispositif doit
??tre pr??t ?? accepter tout brouillage radio??lectrique re??u, meme si ce brouillage est susceptible de compromettre le fonctionnement du dispositif.
FCC Statement (United States Only)
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
???Reorient or relocate the receiving antenna.
???Increase the separation between the equipment and receiver.
???Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user???s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and
(2) this device must accept any interference received, including interference that may cause undesired operation.