Parts

Frame with Liner

Pad with Restraint

Front Tube

2 Frame Tubes

3

Assembly

IMPORTANT! Before assembly, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact Fisher-Price?? for replace- ment parts and instructions if needed. Never substitute parts.

1

Upper

Frame

Tube

??? Rotate the upper frame tube until it "snaps" into an upright position, as shown.

???Position the front tube so that the rubber feet are flat on the surface.

???While pressing the button on the lower frame tube, insert it into an end of the front tube. Continue to insert the lower frame tube into the front tube until you hear a "click".

???While pressing the button on the front tube, insert it into the end of the lower frame tube. Continue to insert the front tube into the lower frame tube until you hear a "click".

4

Assembly

??? Pull the front tube to be sure it is secure to each lower frame tube.

Frame with Liner

4

Front Tube

???Position the frame with liner so that the seat is over the front tube.

???While pressing the buttons on the upper frame tubes, insert them into the holes in the underside of the frame with liner.

???Continue to insert the upper frame tubes into the frame with liner until you hear a "click" on both sides.

5

Assembly

5

???Check to be sure the upper frame tubes are secure in the frame with liner. If you can remove the upper frame tubes from the frame with liner, you have not properly inserted the tubes into the frame. Remove the upper frame tubes from the frame with liner and repeat Assembly step 4.

IMPORTANT! Attach the provided pad (with restraint system) to this product. Never use this product without the provided pad.

B

6

???Fit the pad seat back pocket over the seat back and fasten.

???Fit the pad seat bottom pocket over the seat bottom and fasten B .

6

Assembly

7

Slot

???Pull the edges of the pad up slightly and insert the waist belts on the liner through the slots in the pad.

Assembly is now complete.

7

Battery Installation

???Locate the battery compartment door on the frame.

???Loosen the screw in the battery compartment door with a Phillips screwdriver.

???Remove the battery compartment door and the battery holder from the battery compartment.

Battery

Holder

???Open the battery holder.

???Insert four "C" (LR14) alkaline batteries as indicated inside the bat- tery holder.

Hint: We recommend using alkaline batteries for longer battery life.

??? Close the battery holder.

8

Battery Installation

Compartment

Door

???Align the ridge on the battery holder with the groove in the battery compartment.

???Slide the battery holder back into the battery compartment.

???Replace the battery compartment door and tighten the screw with a Phillips screwdriver. Do not over-tighten.

9

Battery Tips

1.5V x 4 "C" (LR14)

SHOWN ACTUAL SIZE

???Do not mix old and new batteries.

???Do not mix different types of batteries: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).

???Remove the batteries during long periods of non-use. Always remove exhausted batteries from the toy. Battery leakage and corrosion can damage this toy. Dispose of batteries safely.

??? Do not dispose of batteries in a fire. The batteries may explode or leak.

???Never short circuit the battery terminals.

???Non-rechargeable batteries are not to be recharged.

???Only batteries of the same or equivalent type as recommended in the "Battery Installation" instructions are to be used.

???If removable rechargeable batteries are used, they are only to be charged under adult supervision.

???Rechargeable batteries are to be removed from the toy before they are charged.

???If you use a battery charger, it should be examined regularly for damage to the cord, plug, enclosure and other parts. Do not use a damaged bat- tery charger until it has been properly repaired.

10

Securing Your Child

To tighten the restraint:

???Feed the anchored end of the restraint belt up through the buckle to form a loop .

???Pull the free end of the restraint belt B .

???Repeat this procedure to tighten the other restraint belt.

To loosen the restraint:

???Feed the free end of the restraint strap up through the buckle to form a loop .

???Enlarge the loop by pulling on the end of the loop toward the buckle.

???Pull the anchored end of the restraint belt to shorten the free end of the restraint belt B .

???Repeat this procedure to loosen the other restraint belt.

Note: After adjusting the restraint to fit your child, make sure you pull on it to be sure it is securely fastened.

12

Starting the Swing

IMPORTANT! Before each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact Fisher-Price?? for replace- ment parts and instructions if needed. Never substitute parts.

Power Dial

Power Dial

???Turn the power dial to any of eight settings.

???Give the seat a light push to start the swinging motion. Adjust the swing power dial to the desired swing motion setting.

Hint: As with most battery-powered swings, a heavier child will reduce the amount of swinging motion on all settings. In most cases, the low setting works best for a smaller child while the high setting works best for a larger child.

???If swinging stops while using a lower setting, try a higher setting. Give the seat a light push to start the swinging motion again.

???Be sure to turn this product off when not in use. Turn the power dial to the off setting .

13

Lights and Music!

Hint: Your baby can enjoy lights and music with or without swinging.

???Slide the lights and music switch to: baby activated lights and one song ; sound and lights off ; or parent activated

lights and music .

When baby pulls either toy on the arch, one tune plays along with twinkling lights.

On this setting, six tunes (approximately 10 minutes) play along with dancing lights.

Turns lights and music off.

??? Turn the volume dial to a comfortable listening level.

IMPORTANT! The maximum weight limit for this product is 17 lbs. If your child weighs less than 17 lbs., but is really active and appears to be able to climb out of the swing, immediately discontinue its use.

14

Take-Along

Seat Bottom

1

??? Lift the seat back and seat bottom together.

Straps

Seat

Back

???Tip the swing backwards the seat back down.

???Unfasten the straps on the seat bottom.

???Pull the straps from the loops on the seat bottom.

???Press both tabs on the frame at the same time to release the frame base.

16

Take-Along

Lower Frame

Tube

3

??? Rotate the lower frame tube around to the top of frame, as shown.

Upper

Frame

Tube

Strap

4

Lower

Frame

Tube

???Fit the straps on the seat bottom between the upper and lower frame tubes, as shown.

???Wrap the straps around the lower frame tubes and fasten the straps.

To set the swing back up for use:

???Unfasten the straps around the upper and lower frame tubes.

???Replace the straps through the loops on the seat bottom and fasten.

???Rotate the lower frame tube around until it snaps into place.

???Place the swing on a non-elevated, flat surface.

17

Care

???The pad is machine washable. Wash the pad separately in cold water on the gentle cycle. Do not use bleach. Tumble dry separately on low heat and remove promptly. The frame, liner and toys may be wiped clean using a mild cleaning solution and a damp cloth. Do not immerse the frame.

???This product has no consumer serviceable parts. Do not take this product apart.

IMPORTANT! Never use this product without the provided pad. Be sure to re-attach the provided pad (with restraint system) to this product.

Waist

Belts

To remove the pad:

???Push the waist belts back through the slots in the pad.

???Unfasten and slide the pad seat back pocket off of the seat back.

???Unfasten and slide the pad seat bottom pocket off of the seat bottom.

To replace the pad:

???Refer to Assembly steps 6 and 7.

18

One (1) Year Limited Warranty

Fisher-Price, Inc., 636 Girard Avenue, East Aurora, New York 14052 warrants that the Deluxe Take-Along Swing is free from all defects in material and workmanship when used under normal conditions for a period of one (1) year from the date of purchase.

Should the product fail to perform properly, we will repair or replace it at our option, free of charge. Purchaser is responsible for shipping the product to Consumer Relations at the address indicated above and for all associated freight and insurance cost. Fisher-Price, Inc. will bear the cost of shipping the repaired or replaced item to you.This warranty is void if the owner repairs or modifies the product.This warranty excludes any liability other than that expressly stated above including but not limited to any incidental or conse- quential damages.

SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDEN-

TAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLU-

SION MAY NOT APPLY TO YOU.

THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO

HAVE OTHER RIGHTS WHICH MAY VARY FROM STATE TO STATE.

19