EVANSTONTM 4 MODEL 2000001586
Before you begin
Read all instructions before set up.
???Select a level site clear of rocks, branches, and other hard or sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
???Do not set up your tent under trees because of potential lightning strikes or falling tree limbs in inclement weather.
???Secure with all stakes and guylines provided to prevent property damage or personal injury.
???For best results in windy conditions, position narrow end of tent into the wind.
???Enlist the help of at least one other person to assist you when it is time to assemble the tent.
5.Insert end of each black Main Pole into pins located in the corners of the tent. (Fig. 2 & 2A)
7.Insert end of the grey Main Pole into pin located on the sides of the tent. (Fig. 2 & 2B)
To Attach Rainfly
1.Drape Rainfly over tent with green vestibule flaps locat- ed at the front of the tent. (Fig 3).
NOTE: Hook and loop fasteners, located on seams of underside of Rainfly, should be centered over black & grey Main Poles.
2.Insert black Rainfly Pole with through sleeve in underside of Rainfly above front door of tent. (Fig. 3)
3.Insert short, black, thin Awning Pole through sleeve in underside of Rainfly above window at back of tent. (Fig. 4)
4. Insert metal tip into grommet on tent seam at back of tent (Fig. 4A). Go to opposite end of Awning Pole and gradually apply pressure to pole forming an arch; then insert metal tip into grommet.
(continued on other side)
To Attach Rainfly continued
5.Insert end of each black Rainfly Pole into pin on either side of front door. (Fig. 5 & 5A)
6.Go to opposite end of Rainfly Pole and gradually apply pressure to form an arch. Insert the pin into pole end at other side of the door. (Fig. 5 & 5A)
7.Locate all hook & loop fasteners on underside of Rainfly and wrap around all Main Poles, Awning & Rainfly Pole to secure. (Fig. 5B) NOTE: Make sure longer hook & loop fastener on Rainfly is secured around grey and black Main Poles where they cross. (Fig. 5C)
8.Stretch elastic straps and hook clip on each to the metal loops at the front and back corners of the tent. (Fig. 5D)
9.Extend out vestibule flaps and secure with metal stakes through the loops in the web straps (Fig. 5 & 5E)
10.Stretch guylines until taut, then secure with stakes. (Fig. 5 & 5F)
Fig. 5
5C
5B
5A
Vestibule Flaps, Door & Window Flaps/Vents
1.Vestibule flaps may be rolled back and secured by inserting toggles through fabric loops. (Fig. 6)
2.For better ventilation, unzip door flap, roll, and insert toggle into fabric loop to secure. (Fig. 7)
3.To open back and side window vents for more ventilation, unzip,
then roll up and insert toggles through fabric loops.
1.All poles and stakes must be placed in the storage bag to prevent damage to the fabric items placed in the carry case.
2.Make sure tent is clean and dry before placing in carry case.
3.Remove rainfly, spread out on floor of tent, then unzip door & vents before taking tent down for storage.
4.Neatly fold tent to width of pole storage bag, place on tent, roll tightly, and place in carry case.
5.Store in a clean, dry area.
Things You Should Know:
Electrical Cord Access
1.Unzip access panel in the lower left front corner of tent and bring in electrical cord. Use only UL approved cords that are rated for outdoor usage. (Fig. 9)
Fig. 9
Cooler Access
The smaller zippered opening at the back of tent is designed for added ventilation and easy access to your beverage cooler.
1. To use as a vent, unzip flap to exposeFig. 10 screen. (Fig. 10)
2.To use as a cooler access, unzip other flap to make an avenue to bring beverages into tent. (Fig. 11)
Fig. 11
WARNING: Keep all flame and heat sources away from this tent fabric.
This tent meets the flammability requirements of CPAI-84. The fabric may burn if left in continuous contact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.
The Coleman Company, Inc. ??? 3600 N. Hydraulic ??? Wichita, Kansas 67219 1-800-835-3278 ??? www.coleman.com
MADE IN CHINA ??? PRINTED IN CHINA
?? 2008 The Coleman Company, Inc.
Coleman??,
, and
are registered trademarks and EvanstonTM is a trademark of The Coleman Company, Inc.
4010003993 (20081114)
