Montana Big Sky??? Elite 16???x7???

Instructions apply to Part Number 2000000142

Front door

Vertical Door Pole inserts into sleeve and zips in
illus. 11
Charger
illus. 10
Light

3 Raise Ends of Tent

??? Insert grey shorter shock-corded poles through pole sleeves marked

with grey binding at both ends of tent above windows.

??? Insert second pin (located near center of tent) of pin & ring system into pole end.

??? Go to opposite end of pole and

gradually apply pressure to the pole forming an arch until you are able to insert the pin into the pole end.

??? Attach frame clips. (illus. 5)

illus. 5

4 Attach Rainfly

??? Assemble rainfly poles by interlocking shock- corded pole.

??? Insert rainfly pole into pole sleeves located at the center edges of the underside of rainfly. (illus. 7), (illus. 8)

??? Drape rainfly over tent, pole side

down. The rainfly poles should cover the door and rear window of tent.

??? Insert rainfly poles into grommets on tent body. (illus. 6)

??? Secure rainfly with attachments located on underside of rainfly.

???Connect the elastic loops with

???S??? hooks (found at the rainfly corners) to fabric loops near frame clips.

???Stake out all guylines. (illus. 8)

???Assemble and insert (short) Vertical Hinged Door Pole through vertical sleeve and into bottom pole stop. Gently apply pressure to insert top end into top pole stop and zip sleeve closed. (illus. 9, 10)

???Assemble and insert (long) Hinged Door Pole through curved door sleeve and into top pole stop. Gently apply

pressure to insert bottom end into bottom pole stop and zip sleeve closed. (illus. 9, 10)

???Attach light kit. (See instructions in light kit)

illus. 8

Completed tent with rainfly.

illus. 9 Hinged Door

Pole Stop

illus. 7 Insert rainfly pole through pole sleeve on underside of rainfly.

End guylines

Stake down doormat

Long Door Pole inserts into sleeve and pole stops, then zips in.

illus. 10 Hinged Door

Things You Should Know

???Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.

???Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

???STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER

PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.

???TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING

STORAGE.

???Do not leave your tent set-up for weeks at a time, be aware that exposure to the ultraviolet rays of the sun can seriously damage material and/or cause it to become discolored.

WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. This tent meets the flammability requirements of CPAI-84. The fabric may burn if left in continuous contact with any flame source. The application of any foreign substance to the tent fabric may render

the flame-resistant properties ineffective.

WARNING: Fluorescent tube(s) contain mercury (Hg) and must be recycled or disposed of according to local, state or federal laws. Call (800) 835-3278 or visit www.coleman.com/recycle/ for recycling instructions or safe disposal locations.

THE COLEMAN CO., INC.

3600 N. Hydraulic ??? Wichita, Kansas 67219

1-800-835-3278 ??? www.coleman.com

MADE IN CHINA

PRINTED IN CHINA REV. 9/07