5Recording Light Red light turns on during recording.
Connect to Computer
1Slide USB latch down. USB arm ???ips up automatically.
2 Connect USB arm to computer???s USB port.
???Your camcorder will begin recharging and you can install FlipShareTM software on your computer.
Recharge Battery
1Slide USB latch down. USB arm ???ips up automatically.
2 Connect USB arm to computer???s USB port.
3Recording light turns on to indicate charging. When charged, the recording light turns off.
???The camcorder uses a sealed, rechargeable battery.
???Recharging a discharged battery takes about three hours.
???The camcorder may remain connected to your computer after it is fully charged, but disconnecting it will help preserve the battery???s lifespan and performance.
???The optional Flip Video Power Adapter can charge the battery in about two hours.
Note: Your computer must be powered on for the camcorder to charge.
2
1
3
2
Record and Play
Gently touch lighted icons with your ???nger to activate the controls on the back panel.
Recording Videos
1 Press record button to start/stop.
2 Touch up/down buttons to zoom in/out.
Playing Videos
3 Touch play button to start/pause.
4 Touch left/right buttons to view previous/next.
Tip: Hold left/right during playback to
Deleting Videos
5 Touch delete button.
Select YES to con???rm.
Tip: Delete button is locked when you ???rst power on. To unlock, press and hold delete button.
Click HELP inside FlipShareTM for detailed instructions on all features.
View On HD Television
1 Power off camcorder and television.
2Connect camcorder to television with optional HDMITM Cable from Flip VideoTM. Learn more at www.theflip.com/accessories.
3Power on camcorder and television.
???Camcorder screen turns off when connected to television.
4Switch your television to VIDEO input.
??? See television manual for instructions.
5 Touch play button to start/pause playback.
Note: You can use any brand of HDMI??? Cable that has an HDMI Connector (Type A) on one end
and HDMI Mini Connector (Type C) on the other end.
Included In This Box
Flip VideoTM Registration and Support
Go to www.theflip.com/support
Declaration of Conformity
Responsible Party: Cisco Systems, Inc.
30 Maiden Lane, 6th Floor, San Francisco, CA 94108
FCC COMPLIANCE STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
RADIO AND TV INTERFERENCE
This equipment has been tested and found to comply with the limits
for a Class B digital device in accordance with the speci???cations in Part 15 of FCC rules. These speci???cations are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the manufacturer???s instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
???Reorient or relocate the receiving antenna.
???Increase the separation between the equipment and the receiver.
???Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
???Consult the dealer or an experienced radio/television technician for help.
The supplied interface cable must be used with the equipment in order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules.
CAUTION: Changes or modi???cations to this device not authorized by Cisco, Inc. may void the user???s authority to operate this device.
CANADIAN
This Class B digital apparatus complies with Canadian
?? 2009 Cisco Systems, Inc. and/or its af???liates (???Cisco???). All rights reserved. THE FLIP VIDEO LOGO, FLIP VIDEO, FLIP MINO HD, and FLIPSHARE are trademarks of Cisco. Designed in the USA. Made in China. For more information, visit www.theflip.com. Facebook, MySpace, and YouTube are trademarks of their respective owners. Mac is a registered trademark of Apple Inc. HDMI, the HDMI Logo and