CENTURY??

L E G E N D A R Y L E A D E R S H I P

OWNER'S MANUAL

5130 / 5230

INSTALLATION, OPERATION, MAINTENANCE & PARTS

NOTE: MANUAL including SPECIFICATIONS, subject to change without notice All ratings specified are based on structural factors only,

not vehicle capacities or capabilities.

CENTURY??

Miller Industries Towing Equipment Inc.

LIMITED WARRANTY

MILLER INDUSTRIES TOWING EQUIPMENT INC., hereinafter referred to as MILLER, warrants to the original purchaser that each new MILLER wrecker or other MILLER products will be free from defects in material and workmanship for a period of twelve (12) months from date placed in service, but in no event shall such warranty period exceed twenty-four (24) months from date of manufacture by MILLER. The purchaser must promptly notify MILLER in writing of any failure in material or workmanship. In no event shall MILLER accept such notification later than twenty-four (24) months from date of delivery or twelve (12) months from date placed in service, whichever is earlier.

MILLER's obligation under this warranty, statutory or otherwise, is limited to the repair or replacement at the MILLER factory, or at a point designated by MILLER, of such part or parts as shall appear upon inspection by MILLER to be defective in material or workmanship. New or remanufactured parts will be used for any replacement at MILLER's option. This warranty is not transferable. This warranty does not obligate MILLER to bear the cost of labor or transportation charges in connection with the repair or replacement of any parts found to be defective, nor shall it apply to a product upon which repairs or alterations have been made unless authorized by MILLER.

EXCEPT AS EXPRESSLY SET FORTH IN THIS WARRANTY, MILLER MAKES NO OTHER

WARRANTY, EXPRESS OR IMPLIED, AND HEREBY DISCLAIMS ALL OTHER WARRANTIES

INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. MILLER shall in no event be liable for claimed downtime, claimed loss of profits or goodwill, or any other special, incidental, indirect, or consequential damages concerning or relating to any product or parts, whether based on negligence, strict liability, breach of contract, breach of warranty, misrepresentation or any other legal theory, regardless of whether the loss resulted from any general or particular requirement which MILLER knew or had reason to know about at the time of sale.

MILLER MAKES NO WARRANTY, EXPRESS OR IMPLIED, AS TO THE FINISHED PRODUCTS

MANUFACTURED OR SUPPLIED BY ANOTHER MANUFACTURER AND SUPPLIED BY MILLER TO PURCHASER, including, but not limited to, any vehicle to which a MILLER product may be affixed or any accessories or wire rope, and MILLER EXPRESSLY DISCLAIMS ANY IMPLIED WARRANTIES OF

MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE AS TO SUCH EQUIPMENT OR PRODUCTS. This language shall in no way affect or diminish the rights of the purchaser to rely on such warranties as are extended by such manufacturers or suppliers. MILLER shall, to the extent permitted under applicable law, pass on to the purchaser such manufacturer's or seller's warranty.

MILLER, whose policy is one of continuous improvement, reserves the right to improve its products through changes in design or materials as it may deem desirable without being obligated to incorporate such changes in products previously sold. This warranty is not intended to cover or include the following items, which are set forth by way of example and not limitation:

A.Normal deterioration of trim, paint, lettering, and appearance items due to wear or exposure to weather, road conditions, road treatments, etc.

B.Any damage or defect due to accident, misuse, abuse, improper or unauthorized repairs, failure to provide reasonable and necessary maintenance, or uses for which the equipment was not designed or intended.

C.Alterations or modifications that affect performance, operation or reliability.

D.Normal maintenance parts including, but not limited to, wear pads, bushings, wire rope, mud flaps, fenderettes, light bulbs, hydraulic oil, filters, and tow sling belts.

IT IS EXPRESSLY UNDERSTOOD THAT MILLER MAKES NO IMPLIED WARRANTY THAT MILLER

PRODUCTS SHALL BE FIT FOR THE PURPOSE OF LIFTING OR MOVING PEOPLE OR FOR ANY

OTHER IMPROPER USE.

SERIAL NUMBER

Miller Industries Towing Equipment Inc.

8503 Hilltop Drive

Ooltewah, Tennessee 37363

Telephone (423) 238-4171

Section VI - PARTS

This Section is provided by the manufacturer for the purpose of ordering any component part of the CENTURY 5130 or 5230 that may be required when part replacement is necessary. Be certain to use only original equipment replacement parts for warranty purposes as well as for keeping your CENTURY 5130 or 5230 in its original state and optimum operating capacities. When ordering replacement or spare parts be sure to provide the following information to the manufacturer???s Parts Department.

1.Manual Number & Date of Publication

2.Manual Page Number

3.Page Title

4.Reference Number of Part Desired

5.Part Number

6.Part Description

7.Quantity of Part Desired

Providing this information will help ensure that the correct parts will be delivered to you in an expedient manner. Should additional information be required for repair or replacement of certain components, contact your Manufacturer Authorized Representative.

The Manufacturer reserves the right, without notice or obligation, to improve or modify their products, which may change the specifications, models and feature availability.

VI-1

Section VI - PARTS (cont'd)

SUBFRAME ASSEMBLY

VI-2

Section VI - PARTS (cont'd)

SUBFRAME ASSEMBLY

VI-3

Section VI - PARTS (cont'd)

STANDARD BODY ASSEMBLY - 5130

VI-4

Section VI - PARTS (cont'd)

STANDARD BODY ASSEMBLY - 5130

VI-5

Section VI - PARTS (cont'd)

STANDARD BODY ASSEMBLY - 5230

VI-6

Section VI - PARTS (cont'd)

STANDARD BODY ASSEMBLY - 5230

VI-7

Section VI - PARTS (cont'd)

RECOVERY BOOM ASSEMBLY

VI-8

Section VI - PARTS (cont'd)

RECOVERY BOOM ASSEMBLY

VI-9

Section VI - PARTS (cont'd)

UNDERLIFT & TOWER ASSEMBLY

VI-10

Section VI - PARTS (cont'd)

UNDERLIFT & TOWER ASSEMBLY

VI-11

Section VI - PARTS (cont'd)

UNDERLIFT HYDRAULICS

VI-12

Section VI - PARTS (cont'd)

UNDERLIFT HYDRAULICS

VI-13

Section VI - PARTS (cont'd)

RECOVERY BOOM HYDRAULICS

VI-14

Section VI - PARTS (cont'd)

RECOVERY BOOM HYDRAULICS

VI-15

Section VI - PARTS (cont'd)

PUMP, VALVE & FILTER HYDRAULICS

VI-16

Section VI - PARTS (cont'd)

PUMP, VALVE & FILTER HYDRAULICS

VI-17

Section VI - PARTS (cont'd)

WINCH HYDRAULICS & AIR FREE SPOOL

VI-18

Section VI - PARTS (cont'd)

WINCH HYDRAULICS & AIR FREE SPOOL

VI-19

Section VI - PARTS (cont'd)

LEFT CONTROL ASSEMBLY

VI-20

Section VI - PARTS (cont'd)

LEFT CONTROL ASSEMBLY

REMOTE CONTROL ASSEMBLY

VI-21

Section VI - PARTS (cont'd)

RIGHT CONTROL ASSEMBLY

VI-22

Section VI - PARTS (cont'd)

RIGHT CONTROL ASSEMBLY

VI-23

Section VI - PARTS (cont'd)

REAR SPADE HYDRAULICS

VI-24

Section VI - PARTS (cont'd)

HYDRAULIC CYLINDERS

VI-25

Section VI - PARTS (cont'd)

GLAD HAND KIT

VI-26

Section VI - PARTS (cont'd)

LIFT ADAPTERS

VI-27

Section VI - PARTS (cont'd)

KING PIN ADAPTER

VI-28

Section VI - PARTS (cont'd)

MODULAR WIRING KIT

VI-29

Section VI - PARTS (cont'd)

MODULAR LIGHT KIT

VI-30

NOTES

CENTURY??

Miller Industries Towing Equipment Inc.

8503 Hilltop Drive ??? Ooltewah, Tennessee 37363 ??? (423) 238-4171 www.millerind.com