Table of Contents

www.CasablancaFanCo.com 1.888.227.2178

Congratulations on purchasing your new Casablanca?? ceiling fan! It will provide comfort and performance in your home or office for many years. This installation and operation manual contains complete instructions for installing and operating your fan.

We are proud of our work and appreciate the opportunity to supply you with the best ceiling fan available anywhere in the world.

To register your fan please visit: www.CasablancaFanCo.com/register

Blades

What to Expect with

Your Installation

30 inches

Preparation

Switch Housing

Ceiling Bracket

Installation

Canopy

11PA GE

Troubleshooting

What to Expect with Your Installation

www.CasablancaFanCo.com 1.888.227.2178

Must be able to secure the fan to building structure or fan-rated outlet box

You may need a friend to help you.

If you are unfamiliar with wiring, use a qualified electrician.

Know your wiring

Ceiling angles greater than 34?? will require an

Angled Mounting Kit. See page 4 for details.

Assess location

1 Standard Downrod

for ceilings 8-10 feet high

2 Shorter Downrod

for fans installed close to ceiling

3 Longer Downrod

for ceilings 10 feet or higher

Read and Save These Instructions

This product conforms to UL Standard 507.

WARNINGS

w.1 - To reduce the risk of fire, electrical shock, or personal injury, mount fan directly from building structure and/or an outlet box marked acceptable for fan support of 70 lbs (31.8 kg) and use the mounting screws provided with the outlet box.

w.2 - To avoid possible electrical shock, before installing or servicing your fan, disconnect the power by turning off the circuit breakers to the outlet box and associated wall switch location. If you cannot lock the circuit breakers in the off position, securely fasten a prominent warning device, such as a tag, to the service panel.

w.3 - To reduce the risk of fire, electrical shock, or motor damage, use only Casablanca Solid State Speed Controls.

w.4 - To reduce the risk of personal injury, do not bend the blade brackets when installing the blade brackets, balancing the blades, or cleaning the fan. Do not insert foreign objects in between rotating fan blades.

CAUTIONS

c.1 - All wiring must be in accordance with national and local electrical codes ANSI/NFPA 70. If you are unfamiliar with wiring, use a qualified electrician.

Select a downrod length

c.2 - Use only Casablanca replacement parts.

Tools Needed

www.CasablancaFanCo.com 1.888.227.2178

UA T I

S

T

Guide Touches

BOTH Ceiling & Wall

You need ONLY a Longer Downrod

*most common

UA T I

S

T

Guide Touches Wall

but NOT Ceiling

You need BOTH a Longer Downrod & an Angled Mounting Kit

Ceiling Bracket Installation

www.CasablancaFanCo.com 1.888.227.2178

OFF

Make sure all four (4) bumpers are still attached.

For angled ceilings, point opening toward peak.

If you are unable to do this, call Technical Support at 1-888-227-2178.

To avoid possible electrical shock, before installing your fan, disconnect the power by turning off the circuit breakers to the outlet box associated with the wall switch location.

Refer to warning w.1 on pg. 2

5

Downrod

www.CasablancaFanCo.com 1.888.227.2178

skip to next page

If you need a different downrod length follow these steps:

Steps 1-5 to remove standard downrod pipe

12345

7

Downrod (continued)

Remove the pre-installed setscrew so that the downrod can be inserted.

Hand tighten the downrod (at least 4-5 full turns) until it stops.

8???

3/8???

If the setscrew is not tightened securely, the fan may fall.

Downrod (continued)

www.CasablancaFanCo.com 1.888.227.2178

Put the wires and downrod through the canopy. Let the canopy sit loosely on top of the fan.

DO NOT PICK THE FAN UP BY THE

CANOPY OR WIRES. Place the downrod ball into the slot in the ceiling bracket.

9

Wiring

www.CasablancaFanCo.com 1.888.227.2178

Refer to CAUTION c.1 on pg. 2

Turn the splices upward and push them carefully back through the hanger bracket into the outlet box. Spread the wires apart, with the grounded wires on one side of the outlet box and the ungrounded wires on the other side of the outlet box.

10

www.CasablancaFanCo.com 1.888.227.2178

Insert the two canopy screws found in the hardware bag.

Note: Fan style may vary.

11

Switch Housing

www.CasablancaFanCo.com 1.888.227.2178

13

Insert the third screw, found in the hardware bag, into place and

then tighten all three (3) screws.

Make sure the upper switch housing is securely attached to the mounting plate. Failure to properly secure all 3 assembly screws could result in the switch housing fixture falling.

Light Kit (continued)

www.CasablancaFanCo.com 1.888.227.2178

Make sure the lower switch housing is securely attached to the upper switch housing. Failure to properly secure all 3 assembly screws could result in the light fixture falling.

Connect the pull chain pendants

to the short chains coming fromSee next page for fan the switch housing.

operation instructions.

Note: Glass shade style and number of lights may vary.

15

Maintenance & Cleaning

www.CasablancaFanCo.com 1.888.227.2178

ON

The pull chain controls the fan: high, medium, low, extra low, and off.

The light pull chain controls the power to the light fixture: on and off.

To switch the direction of air flow, move the reverse switch to the opposite position.

For cleaning the fan, use soft brushes or cloths to prevent scratching. Cleaning products may damage the finishes.

Troubleshooting

Fan doesn???t work

???Make sure power switch is on.

???Pull the pull chain to make sure it is on.

???Push the motor reversing switch firmly left or right to ensure that it is engaged.

???Check the circuit breaker to ensure the power is turned on.

???Make sure the blades spin freely.

???Turn off power from the circuit breaker, then loosen the canopy and check all the connections according to the wiring diagram on page 10.

???Check the plug connection in the switch housing.

Excessive wobbling

???Tighten all of the blade and blade iron screws until they are snug.

???Turn the power off, support the fan carefully, and check that the hanger ball is properly seated.

???Use the provided balancing kit and instructions to balance the fan.

www.CasablancaFanCo.com 1.888.227.2178

Noisy Operation

???Tighten the blade and blade iron screws until they are snug.

???Check to see if any of the blades are cracked. If so, replace all of the blades.