INSTALLATION GUIDE FOR THE:

PRO-PDA15

Power Door Lock Actuator

ACTUATOR/DOOR LOCK INSTALLATION

1.) Carefully remove the door panel.

2.) Since the adjustable steel mounting strap is optional at this step, you can either attach strap to the door structure (see Drawing #3) and mount actuator/door lock to the strap, or attach actuator/door lock onto the door structure. Both mounting methods must ensure a suitable position is selected that will not hinder the window mechanism and is close enough to operate the existing lock assembly.

3.) Slide connector rod onto the end hole of actuator/door lock. Attach-connector rod clamp to the connector rod (see Drawing #2).

4.) Set door lock in the unlock position, then tighten connector rod clamp to the existing factory door rod supplied with kit.

5.) Pull connector rod until the actuator is fully extended, then tighten connector rod clamp to existing factory door rod.

INSTALLATION DIAGRAM

CONNECTOR

ROD CLAMP

CONNECTOR ROD

HEX HEAD

SCREWS