??
3
Bilge and Aerator Pump
Replacement Motor Cartridge
4620, 4622, 4624, 4623, 4625 Series
WARNING
Read all instructions carefully before installing and using this product. To prevent personal injury, disconnect the power source when installing or servicing this product. Always remove the boat from the water before using 120V AC power tools.
DO NOT use pump to remove gasoline, oil or other flammable liquids. Always use the fuse amperage rating specified for your pump model. Failure to do so could result in serious personal injury or fire hazards.
Attwood bilge pumps are designed to exhaust STANDING WATER ONLY. They are not intended to prevent rapid accumulation of
PRODUCT FEATURES
The Attwood Motor Cartridges are an easy solution for replacement of an Attwood Cartridge Bilge or Aerator Pump. The Replacement Motor Cartridges are interchangeable between
The cartridges are
To Remove Existing Cartridge
WARNING
If Aerator is installed
The pump, plumbing and connections may be below the water level. Removing the cartridge while the boat is in the water may result in flooding and sinking of your boat.
1.Hold pump housing firmly. Depress motor cartridge tabs, then twist cartridge
Figure 1
Lock
Unlock
Motor
Cartridge Tab
To Insert new motor cartridge
1.Check motor cartridge fit. Motor color must match housing color: 600 Series = RED, 800 = BLUE, 1200 = GRAY.
2.Coat
3.Insert cartridge into housing. Twist clockwise until you hear tabs snap up into slot.
Figure 2
Motor Cartridge
Red Tab
Red TabMust Be Extending Thru Slot
"O" Ring
WARNING
To avoid leaking or sinking, the aerator RED TAB MUST BE LOCKED AND VISIBLE through aerator housing slot.
ATTWOOD LIMITED WARRANTY
This Attwood Motor Cartridge carries a three (3) year warranty. See product catalog or www.attwoodmarine.com for details.
??2003 Attwood Corporation
1016 N. Monroe Street, Lowell, MI