! Power Mac G4 / Macintosh Server G4
Zip Drive Bezel
Replacement Instructions
Follow the instructions in this sheet carefully. Failure to follow these instructions could damage your equipment and void its warranty.
Note: Online instructions are available at http://www.info.apple.com/installparts/.
Warning: During this procedure, keep small parts away from children.
Tools Required
No tools are required for this procedure.
Opening the Computer
Warning: Always shut down your computer before opening it to avoid damaging its internal components or causing injury. After you shut down the computer, the internal components can be very hot. Let the computer cool down before continuing.
1.Place your computer on a clean, at surface.
2.If you think your computer is in sleep, press the power button on the front of the computer to wake it.
3.Shut down your computer and wait ve minutes before continuing.
4.If you attached a security cable through the computer’s lockable cover latch, remove the cable.
5.Unplug all other cables from the computer except the power cord.
6. Touch the metal PCI access covers on the back of the computer. (Figure 1)
Important: To avoid electrostatic discharge, always ground yourself by touching the port access covers before you touch any parts or install any components inside the computer. To avoid static electricity building back up in your body, do not walk around the room until you have completed the installation and closed the computer.
Figure 1
7.Unplug the power cord.
Warning: The power supply in your computer is a
8.Lift the latch on the right side access panel.
9.Gently lower the access panel until it lies at. To avoid scratching the case, lower the panel onto a soft, clean cloth.
Warning: If you see any lights glowing on the main logic board, the computer has not been shut down. Close the side access panel and shut down the computer before proceeding.
Power Mac G4 Zip Drive Bezel - 2
Removing the Installed Zip Drive Bezel
1.From inside the chassis, behind the front panel, push the bezel tab forward to release the right side of the bezel. (Figure 2)
2.Disconnect the hook on the left side of the bezel from the front panel and remove the bezel from the computer.
Figure 2
Installing the Replacement Zip Drive Bezel
1.Align the hook on the left edge of the replacement bezel with the left edge of the opening in the front panel.
2.Rotate the bezel until it is ush with the front panel, making sure the tab on the right side of the bezel snaps into place.
Closing the Computer
1.Raise the side access panel, lift the latch, and press the panel against the case until it snaps securely into place.
2.Reconnect all cables and restart your computer.
Warning: Never turn on your computer unless all of its internal and external parts are in place and it is closed. Operating the computer when it is open or missing parts can damage your computer or cause injury.
Power Mac G4 Zip Drive Bezel - 3
! Apple Computer, Inc.
© 2004 Apple Computer, Inc. All rights reserved.
Under the copyright laws, this document may not be copied, in whole or in part, without the written consent of Apple.
The Apple logo is a trademark of Apple Computer, Inc., registered in the U.S. and other countries. Use of the “keyboard” Apple logo
Every effort has been made to ensure that the information in this document is accurate. Apple is not responsible for printing or clerical errors.
Apple Computer, Inc. 1 Innite Loop
Cupertino, CA
USA
+ 1 408 996 1010 http://www.apple.com
Apple, the Apple logo, Mac, Macintosh, and the Mac logo are trademarks of Apple Computer, Inc., registered in the U.S. and other countries.
Power Mac is a trademark of Apple Computer, Inc.
Power Mac G4 Zip Drive Bezel - 4